Page 230 of 432
STARTING AND DRIVING
212
To allow proper operation of your vehicle's
ventilation system, keep the inlet grilles in front of
the windshield clear of snow, leaves, or other
obstructions.
If you smell exhaust fumes in the vehicle, drive with
the windows open and the trunk lid closed. Have the
cause immediately located and corrected.
BEFORE STARTING THE
ENGINE
1. Check the area around the vehicle before entering it.
2. Adjust seat position, seatback angle, head restraint height
and steering wheel angle.
3. Adjust inside and outside rear view mirrors.
4. Lock all doors.
5. Fasten seat belts.
Remember to check that the service reminder indicators
function when turning the key to ºONº, and check the fuel
gauge to see that you have sufficient fuel.
IGNITION SWITCH WITH
STEERING LOCK
Page 231 of 432
STARTING AND DRIVING
213
ºSTARTº ± Starter motor on. The key will return to the
ºONº position when released.
For starting tips, see page 216.
ºONº ± Engine on and all accessories on.
This is the normal driving position.
NOTICE
Do not leave the key in the ºONº position if the engine is
not running. The battery will discharge and the
electronic ignition system could be damaged.
ºACCº ± Accessories such as the radio operate, but the
engine is off.
If you leave the key in the ºACCº or ºLOCKº position and
open the driver's door, a buzzer will remind you to remove the
key.
Page 232 of 432
STARTING AND DRIVING
214
ºLOCKº ± Engine is off and the steering wheel is locked.
The ignition key can be removed only at this position.
To turn the key from ºACCº to the ºLOCKº position, you
must put the transmission selector lever in the ºPº position.
Once you remove the key, the engine immobiliser system is
automatically set. See ºEngine immobiliser systemº on page
16.
When starting the engine, the key may seem stuck at the
ºLOCKº position. To free it, first be sure the key is pushed
all the way in, and then rock the steering wheel slightly while
turning the key gently.If, in an emergency, you must turn the engine off while the
vehicle is moving, turn the key only to ºACCº.
Page 235 of 432
STARTING AND DRIVING
217
AUTOMATIC TRANSMISSION(SC400)
Your automatic transmission has a shift lock system to
minimize the possibility of incorrect operation. This
means you can only shift out of ºPº position when the
brake pedal is depressed with the ignition switch in ºONº
position. ()
Page 237 of 432
STARTING AND DRIVING
219
(a) Normal driving
1. Start the engine as instructed in ºHow to start the
engineº on page 216.
The transmission must be in ºPº or ºNº. The engine will not
start in any drive position even if the ignition key is turned to
ºSTARTº.
Page 247 of 432
STARTING AND DRIVING
229
AUTOMATIC TRANSMISSION(SC300)
Your automatic transmission has a shift lock system to
minimize the possibility of incorrect operation. This
means you can only shift out of ºPº position when the
brake pedal is depressed with the ignition switch in ºONº
position. ()
Page 249 of 432
STARTING AND DRIVING
231
(a) Normal driving
1. Start the engine as instructed in ºHow to start the
engineº on page 216.
The transmission must be in ºPº or ºNº. The engine will not
start in any drive position even if the ignition key is turned to
ºSTARTº.
Page 260 of 432

STARTING AND DRIVING
242In the power mode, the ºECT PWRº light in the instrument
cluster is on and the transmission is shifted up at higher
vehicle speeds and shifted down more responsively than in
the normal mode.
To return to the normal mode, push the driving pattern
selector switch lightly on the ºSNOWº side.
Snow mode: For slippery road surfaces such as in snow. In
this mode, the spinning of the rear wheels is controlled
appropriately.
When you push the driving pattern selector switch on the
ºSNOWº side, the snow mode is turned on and the ºECT
SNOWº light in the instrument cluster comes on.
To return to the normal mode, push the driving pattern
selector switch on the ºSNOWº side again.
When you turn the ignition switch off in the snow mode, the
mode automatically changes to the normal mode.
CRUISE CONTROL
The cruise control allows you to cruise the vehicle at a
desired
speed over 40 km/h (25 mph) with your foot off the
accelerator pedal.
Your cruising speed can be maintained although a slight speed
change may occur when driving up or down a gradient, within
the limits of engine performance. On steeper hills, a great
speed change will occur so it is better to drive without the
cruise control.
When the cruise control is on, the driving pattern of the
automatic transmission is fixed in the normal position,
regardless of the position of the selector switch.
CAUTION
To help maintain maximum control of your vehicle, do not
use the cruise control when driving in heavy or varying
traffic, or on slippery (rainy, icy or snow±covered) or
winding roads.
Avoid vehicle speed increases when driving downhill. If the
vehicle speed is too fast in relation to the cruise control set
speed, cancel the cruise control then downshift the
transmission to use engine braking to slow down.