1999 LEXUS SC300 checking

CHASSIS
364The recommended cold tire pressures, tire size and the
vehicle capacity weight are given on the label.
You should check the tire pressures every two weeks, or at
least
once a month. And don't forget the spare! The pressure
for the spare tire should be same with that for the standard tire.
(See page 356 or 358.) Incorrect tire pressure can reduce tire
life and make your vehicle less safe to drive.
Low tire pressure results in excessive wear, poor handling,
reduced fuel economy, and the possibility of blowouts from
overheated tires. Also, low tire pressure can cause poor
sealing of the tire bead. If the tire pressure is excessively low,
there is the possibility of wheel deformation and/or tire
separation. So keep your tire pressures at the proper level. If
a tire needs frequent refilling, have it checked by your Lexus
dealer. High tire pressure produces a harsh ride, handling problems,
excessive wear at the center of the tire tread, and a greater
possibility of tire damage from road hazards.
The following instructions for checking tire pressure should
be observed:

The pressure should be checked only when the tires are
cold. If your vehicle has been parked for at least 3 hours
and has not been driven for more than 1.5 km or 1 mile
since, you will get an accurate cold tire pressure reading.
 Always use a tire pr essure gauge. The appearance of the
tire can be misleading. Besides, tire pressures that are even
just a few pounds off can degrade handling and ride.
 Do not bleed or reduce tire pressure after driving. It is
normal for the tire pressure to be higher after driving.
 Never exceed the vehicle capacity weight. The
passengers and luggage weight should be located so that
the vehicle is balanced.
 Be sure to reinstall the tire valve caps. Without the valve
caps, dirt or moisture could get into the valve core and
cause air leakage. If the caps have been lost, have new
ones put on as soon as possible.

CHASSIS
365
ROTATING TIRES
To equalize tire wear and help extend tire life, Lexus
recommends that you rotate your tires approximately
every 12000 km (7500 miles). However, the most
appropriate timing for tire rotation may vary according
to your driving habits and road surface conditions.
The wheel assemblies must be rotated as illustrated above.
When rotating tires, check for uneven wear and damage.
Abnormal wear is usually caused by incorrect tire pressure,
improper wheel alignment, out±of balance wheels, or severe
braking.
Before storing radial, snow or studded tires, mark the
direction of rotation and be sure to install them in the same
direction when using them again. Tires should be stored in a
cool dry place.CHECKING AND REPLACINGTIRES
When to replace your tires

CHASSIS
369
INSTALLING SNOW TIRES ANDCHAINS
When to use snow tires or chains
Snow tires or chains are recommended when driving on
snow or ice.
On wet or dry road, conventional or radial tires provide better
traction than snow or studded tires.
Snow tire selection
If you need snow tires, select the same size, construction
and load capacity as the original tires on your Lexus.
Do not use tires other than stated above. Since your vehicle
has radial tires as original equipment, make sure your snow
tires also have radial construction. Do not install studded tires
without first checking local regulations for possible
restrictions.
Snow tire installation
Snow tires should be installed on all wheels.
Installing snow tires on the rear wheels only can lead to an
excessive difference in road grip capability between the front
and rear tires which could cause loss of vehicle control.

SECTION 6 ± 4
374
SERVICE PROCEDURES AND
SPECIFICATIONS
Electrical components
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
.
374
Checking battery condition. . . . . . . . . . . . . . . . . . . . . . . . . . .
380
Battery recharging precautions . . . . . . . . . . . . . . . . . . . . . . . .
386
Checking and replacing the blade type fuses . . . . . . . . . . . . .
388
Checking the cartridge type fuses . . . . . . . . . . . . . . . . . . . . . .
393
Adding washer fluid . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
396
Checking the headlight aim . . . . . . . . . . . . . . . . . . . . . . . . . .
396
Replacing light bulbs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
399
SPECIFICATIONS
±LOCATION OF FUSES

ELECTRICAL COMPONENTS
380
CHECKING BATTERYCONDITION
Precautions
CAUTION
BATTERY PRECAUTIONS
The battery produces flammable and explosive hydrogen gas.

Do not cause a spark by contacting the battery terminals
with tools.

Do not smoke or light a match near the battery.
The electrolyte contains poisonous and corrosive sulfuric acid.

Avoid contact with eyes, skin or clothes.

Never inhale or swallow electrolyte.

Wear protective safety glasses when working near the
battery.

Keep children away from the battery.
EMERGENCY MEASURES

If electrolyte gets in your eyes, flush your eyes with clean
water for at least 15 minutes and get immediate medical
attention. If possible, continue to apply water with a sponge
or cloth while traveling to the medical office.

ELECTRICAL COMPONENTS
381

If electrolyte gets on your skin, thoroughly wash the
contact area. If you feel a pain or burn, get medical
attention immediately.

If electrolyte gets on your clothes, there is a
possibility of its soaking through to your skin, so
immediately take off the exposed clothing and follow
the procedure above, if necessary.

If you happen to swallow electrolyte, drink a large
quantity of water or milk. Follow with milk of
magnesia, beaten raw egg or vegetable oil. Then go
immediately for emergency help.Checking battery exterior

ELECTRICAL COMPONENTS
382
Check the battery for corroded or loose connections,
cracks, or loose hold±down clamps.
1. If the battery is corroded, wash it off with a solution of
warm water and baking soda. Coat the terminals with grease
to prevent further corrosion.
2. If the connections are loose, tighten the clamp bolts ±but
do not overtighten.
3. Tighten the hold±down clamp only enough to keep the
battery firmly in place. Overtightening may damage the
battery case.NOTICE

Make sure the engine and all accessories are turned
off before performing maintenance.

When checking the battery, remove the ground cable
first and reinstall it last.

Be careful not to cause a short circuit with tools.

Take care no solution gets into the battery when
washing it.

ELECTRICAL COMPONENTS
383
Checking battery fluid
There are 2 types of batteries: maintenance type and
non±maintenance type.
A non±maintenance battery has ºMAINTENANCE FREE
BATTERYº on its top. A maintenance type battery does not
have such indication.
Maintenance type battery
Check the fluid condition by the fluid level lines on the side
of the battery. Or if the battery has a hydrometer on its top,
you can also check the hydrometer.
Non±maintenance battery
Check the battery condition by the hydrometer on the top of
the battery.(a) Checking by the fluid level lines (Maintenance type
battery only)