1999 Lexus LS400 lexus LS400 1999 Electrical Components / LEXUS 1999 LS400 OWNER'S MANUAL (OM50514U)

COMFORT ADJUSTMENT
145
Adjust the position of the lap and shoulder belts.
1
Position the lap belt as low as possible on your hips
± not on your waist.
2 Adjust it to a snug fit by pulling the shoulder portion
upward through the latch plate.
CAUTION
High±positioned lap belts and loose±fitting belts
both could cause severe injuries due to sliding under
the lap belt during a collision or other unintended
result. Keep the lap belt positioned as low on hip as
possible.
 For your safety, do not place the shoulder belt under
your arm.
16L023a

COMFORT ADJUSTMENT
146

Front seat belts only
Adjust the shoulder anchor position to your size.
Manual type: To raise the anchor position, push the
anchor up. To lower the anchor position, support the
anchor
while you push the lock release button then slide
the anchor down. After adjustment, make sure the
anchor is locked in position.
CAUTION
Always make sure the shoulder belt is positioned
across the center of your shoulder. The belt should be
kept away from your neck, but not falling off your
shoulder. Failure to do so could reduce the amount of
protection in an accident and cause severe injuries in a
collision.
16L024a

COMFORT ADJUSTMENT
147


Front seat belts only
Power type: To adjust the shoulder anchor position,
press the upper or lower part of the control switch
located on the door. When the switch is released, the
shoulder anchor will stop at that position.
CAUTION
Always make sure the shoulder belt is positioned
across the center of your shoulder. The belt should be
kept away from your neck, but not falling off your
shoulder. Failure to do so could reduce the amount of
protection in an accident and cause severe injuries in a
collision.
16L117a

COMFORT ADJUSTMENT
148To release the belt, press the buckle release button
and allow the belt to retract.
If the belt does not retract smoothly, pull it out and check
for kinks or twists. Then make sure it remains untwisted
as it retracts.
Seat belt extender
If your seat belts cannot be fastened securely because
it is not long enough, a personalized seat belt extender
is available from your Lexus dealer free of charge.
Please
contact your local Lexus dealer so that the dealer
can order the proper required length for the extender.
Bring the heaviest coat you expect to wear for proper
measurement and selection of length. Additional
ordering information is available at your Lexus dealer.
CAUTION
When using the seat belt extender, observe the
following. Failure to follow these instructions could
result in less effectiveness of the seat belt restraint
system in case of vehicle accident, increasing the
chance of personal injury.
 Never use the seat belt extender if you can fasten the
seat belt without it.
 Remember that the extender provided for you may
not be safe when used on a different vehicle, or for
another person or at a different seating position than
the one originally intended for.
16L026-1

COMFORT ADJUSTMENT
149
To connect the extender to the seat belt, insert the
tab into the seat belt buckle so that the ºPRESSº
signs on the buckle release buttons of the extender
and the seat belt are both facing outward as shown.
You will hear a click when the tab locks into the buckle.
When releasing the seat belt, press on the buckle
release button on the ext
ender, not on the seat belt. This
helps prevent damage to the vehicle interior and
extender itself.
When not in use, remove the extender and store in the
vehicle for future use.

COMFORT ADJUSTMENT
150
CAUTION
After inserting the tab, make sure the tab and buckle
are locked and that the belt is not twisted.
 Do not insert coins, clips, etc. in the buckle as this
may prevent you from properly latching the tab and
buckle.
 If the seat belt does not function normally,
immediately contact your Lexus dealer. Do not use
the seat until the seat belt is fixed. It cannot protect
an adult occupant or your child from injury.

COMFORT ADJUSTMENT
151
SUPPLEMENTAL RESTRAINTSYSTEM (SRS)
The Supplemental Restraint System (SRS) consists
of driver and front passenger airbags, side airbags
and seat belt pretensioners. The combination of
these 3 systems is designed to provide further
protection for the driver and front passenger when
added to the primary protection provided by the seat
belts.
16L118±1

COMFORT ADJUSTMENT
152

Driver and front passenger airbags, and seat belt
pretensioners
Driver and front passenger airbags:In response to a severe frontal impact, the driver and
front passenger airbags work together with the seat
belts to help preventing or reduce injury by inflating,
in order to decrease the likelihood of the driver's or
front passenger's heads or chests from directly
hitting the steering wheel or dashboard.
Seat belt pretensioners:
In response to a severe frontal impact, the seat belts
are quickly drawn back in by the retractors so that
the belts snugly restrain the driver and front
passenger.
The front passenger airbag is activated even with no
passenger in the front seat.
The seat belt pretensioners are activated even with no
passenger in the front seat.
Be sure to wear your seat belt.