Page 485 of 667

76CHASSIS AND BODY
16
REPAIR COVER - SQUAB - REAR SEAT
Service repair no - 78.90.13
Remove
1.Remove rear seat.See this Section.
2.Remove 2 screws and remove squab striker.
3.Remove 2 bolts securing squab to cushion
frame.
4.Remove squab stop bolt.
5.Remove squab and collect spacer.
6.Release velcro securing squab cover edges and
fold cover over squab pad.
7.Remove squab cover.
Refit
8.Position cover to squab pad, align to its fitted
position and secure velcro.
9.Position and align squab to cushion frame.
10.Fit spacer and tighten securing bolts.
11.Fit and tighten squab stop bolt.
12.Fit squab striker and tighten screws.
13.Fit rear seat.See this Section.REGULATOR - REAR DOOR GLASS
Service repair no - 76.31.46
Remove
1.Remove rear door trim casing.See this
Section.
2.Carefully release plastic sheet from rear door.
3.Remove 2 bolts securing door glass to regulator.
4.Raise glass and secure with a suitable wedge.
5.Remove 4 bolts securing glass regulator
assembly to door.
6.Manoeuvre regulator through access hole at
bottom of the door.
Refit
7.Clean mating face of regulator and door glass.
8.Lubricate regulator with grease.
9.Position regulator in door and secure with bolts.
10.Remove wedge holding glass and align glass to
regulator.
11.Secure glass to regulator and fit and tighten
bolts.
12.Fit plastic sheet to rear door.
13.Fit rear door trim casing.See this Section.
ProCarManuals.com
Page 486 of 667
CHASSIS AND BODY
17
REPAIR TRIM CASING - REAR DOOR
Service repair no - 76.34.04.99
Remove
1.Remove screw securing door handle
escutcheon.
2.Remove escutcheon.
3.Remove interior lock button bezel.
4.Remove retaining clip and remove door glass
regulator handle.
5.Release covers and remove 2 screws securing
door pull to door.
6.Carefully release 12 clips securing trim casing to
door and remove door casing.Refit
7.Fit trim casing to door and secure with clips.
8.Fit door glass regulator handle.
9.Fit escutcheon to door handle and tighten screw.
10.Fit door lock button bezel.
11.Fit door pull and secure with screws.
ProCarManuals.com
Page 487 of 667

76CHASSIS AND BODY
18
REPAIR AUXILLIARY SWITCH PANEL
Service repair no - 76.46.38
Remove
1.Remove 2 screws securing axilliary switch panel
to fascia and collect nuts and washers.
2.Disconnect multiplug from headlamp Levelling
switch.
3.Disconnect multiplug and Lucar from cigar
lighter.
4.Noting their fitted position, disconnect 4 Lucars
from rear wash wipe switch.
5.Remove switch panel.Do not carry out further dismantling if
component is removed for access only.6.Release pin securing rear wash wipe knob to
switch and remove knob.
7.Remove locknut securing rear wash wipe switch
to panel.
8.Remove rear wash wipe switch.
9.Remove knob from headlamp levelling switch.
10.Remove locknut securing headlamp switch to
panel.
11.Remove headlamp levelling switch.
12.Remove element from cigar lighter.
13.Release bulb holder from cigar lighter.
14.Release cigar lighter from tags and remove from
panel.
15.Fit cigar lighter to panel and locate tags.
16.Fit bulb holder to cigar lighter.
17.Fit element to cigar lighter.
18.Fit headlamp levelling switch to panel and
secure with locknut.
19.Fit knob to headlamp levelling switch.
20.Fit rear wash wipe switch to panel and secure
with locknut.
21.Fit knob to rear wash wipe switch, ensuring pin
is correctly located.
Refit
22.Position auxilliary switch panel to fascia and
connect 4 Lucars to rear wash wipe switch.
23.Connect multiplug and Lucar to cigar lighter.
24.Connect multiplug to headlamp levelling switch.
25.Fit auxilliary switch panel to fascia and secure
with screws.
ProCarManuals.com
Page 488 of 667
CHASSIS AND BODY
19
REPAIR LOWER FASCIA PANEL - UP TO 02MY
Service repair no - 76.46.05
Remove
1.Disconnect battery negative lead.
2.Remove steering wheel.See STEERING,
Repair.
3.Remove 7 screws securing nacelle to steering
column.
4.Remove 2 halves of nacelle from steering
column.
5.Remove instrument pack.See ELECTRICAL,
Repair.
6.Remove 3 screws securing heater control cable
assembly to end of fascia.
7.Release heater control cable assembly from
fascia and move aside.
8.Release HRW, Rear Fog Guard Lamp, and
Hazard Warning switches from fascia.
9.Disconnect multiplugs and Lucars from switches.
10.Collect switches.
11.Remove locking rings from both front speakers.
12.Remove 4 screws securing each speaker to
fascia.
13.Disconnect multiplugs from speakers and
remove both front speakers.
ProCarManuals.com
Page 489 of 667
76CHASSIS AND BODY
20
REPAIR
14.Carefully prise Land Rover decal from grab
handle.
15.Remove 2 screws securing grab handle to crash
pad and lower fascia panel.
16.Remove grab handle.
17.Remove 4 screws securing demister vents to
crash pad.
18.Remove both demister vents.
19.Remove 3 screws securing crash pad to
bulkhead.
20.Remove crash pad.
21.Release radio from fascia.
22.Disconnect 2 multiplugs and aerial from radio.23.Remove radio.
24.Remove 2 trim studs securing radio housing to
fascia.
25.Remove radio housing.
26.Remove auxilliary switch panel.See this
Section.
27.Remove auxilliary switch panel cover.
28.Remove interior fuse box cover.
ProCarManuals.com
Page 490 of 667
CHASSIS AND BODY
21
REPAIR
29.Remove 2 screws securing each footwell vent
and remove vents from lower fascia.
30.Remove screw securing each door check strap
cover and remove both covers.
31.Remove 3 screws securing wiper motor cover to
bulkhead.
32.Remove wiper motor cover.
33.Remove 3 screws securing finisher rail to lower
fascia.
34.Remove finisher rail.
ProCarManuals.com
Page 491 of 667

76CHASSIS AND BODY
22
REPAIR
35.Remove 7 trim clips securing trim upper fascia
trim casing to bulkhead.
36.Carefully fold back trim casing over fresh air vent
operating levers and remove.
37.Release demist hose from parcel shelf.
38.Remove 18 screws securing parcel shelf to
lower fascia panel.
39.Remove parcel shelf.
40.Remove 7 screws securing bottom edge of lower
fascia panel to bulkhead.
41.Remove both retaining plates and lower footwell
covers.
42.Remove 2 bolts securing top of lower fascia to
bulkhead.
43.With assistance, remove lower fascia.Refit
44.With assistance, fit lower fascia.
45.Fit 2 bolts securing top of lower fascia to
bulkhead.
46.Fit both retaining plates and footwell covers to
lower fascia.
47.Fit 7 screws securing bottom edge of lower
fascia to bulkhead.
48.Fit parcel shelf to lower fascia and secure with
screws.
49.Fit demist hose to parcel shelf.
50.Carefully manoeuvre upper fascia trim casing
over fresh air vents and fit to fascia.
51.Fit trim clips securing trim casing to bulkhead.
52.Fit finisher rail to lower fascia and secure with
screws.
53.Fit wiper motor cover and secure with screws.
54.Fit both door check strap covers and secure with
screws.
55.Fit both footwell vents to lower fascia and secure
with screws.
56.Fit interior fuse box cover.
57.Fit auxilliary switch panel cover.
58.Fit auxilliary switch panel.See this Section.
ProCarManuals.com
Page 492 of 667

CHASSIS AND BODY
23
REPAIR 59.Fit radio housing to fascia and secure with trim
studs.
60.Position radio to fascia and connect multiplugs
and aerial.
61.Fit radio to fascia.
62.Fit crash pad to fascia and secure with screws.
63.Fit both demister vents to crash pad and secure
with screws.
64.Fit grab handle to fascia and secure with screws.
65.Fit Land Rover decal to grab handle.
66.Position both front speakers to fascia and
connect multiplugs.
67.Fit speakers to fascia and secure with screws.
68.Fit locking rings to speakers.
69.Connect multiplugs and Lucars to HRW, Rear
Fog Guard Lamp, and Hazard Warning
Switches.
70.Fit switches to fascia.
71.Position heater controls to fascia and secure
with screws.
72.Fit instrument pack.See ELECTRICAL,
Repair.
73.Fit 2 halves of nacelle to steering column and
secure with screws.
74.Fit steering wheel.See STEERING, Repair.
75.Reconnect battery negative lead.PANEL - MOUNTING - FRONT DOOR - FROM 02MY
Service repair no - 76.11.28
Remove
1.Remove plastic sheet.See this Section.
2.Lower glass and remove 2 bolts securing door
glass to regulator.
3.Release glass from regulator, raise and wedge
in raised position.
ProCarManuals.com