1999 GMC C-SERIES manual transmission

yellowblue
2-25
If your parking brake doesn't hold the vehicle when
applied, see your GM Truck dealer who can adjust your
parking brake properly.
To release the parking
brake, first push down the
regular brake pedal. Then,
push the parking brake lever
all the way down and shift
the automatic transmission
to NEUTRAL (N).
The PARK BRAKE light will remain illuminated if the
parking brake is not fully released.
NOTICE:
Driving with the parking brake on can overheat
the parts in the system. You may have to replace
them, and you could also damage other parts of
your vehicle.
Electric/Hydraulic Parking Brake
(If Equipped)
CAUTION:
It will take a few seconds for the parking brake
to fully apply, and even longer when it is cold
outside. Do not leave your vehicle until the
parking brake applies fully. Without the parking
brake applied, your vehicle is free to move. It
could hit someone or something.
ProCarManuals.com

yellowblue
2-26
If your vehicle has this
system, you will have a
knob to the right of the
steering column.
To apply the parking brake, pull the knob toward you.
Then shift the transmission to NEUTRAL (N) or
PARK (P).
Push the knob in to release the parking brake. The
ignition must be in RUN and the shift lever out of
PARK (P) in order to release the parking brake.
The parking brake will automatically apply if the
ignition is turned off and in PARK (P) and will also
apply (will not release) if the vehicle's battery is dead
or disconnected.The PARK BRAKE light may flash while the parking
brake is being applied or released. This is normal for
this system.
If your vehicle needs towing or the parking brake will
not release, the towing operator will need to disconnect
the propshaft before towing your vehicle. See ªTowing
Your Vehicleº in the Index.
Air Brake (If Equipped)
CAUTION:
When the yellow SYSTEM PARK and the red
TRAILER AIR SUPPLY knobs are both pushed
in, your rig will be free to move. It could strike
someone or something. When both of these knobs
are pushed in, either hold the regular brake
pedal down or, if you have it, pull out the blue
TRACTOR PARKING knob, to keep your rig
from moving.
ProCarManuals.com

yellowblue
2-28
CAUTION:
If you apply any one of the air brake parking
controls while the vehicle is moving, your rig will
stop suddenly. If you are not ready for this, you
or others could be injured. Don't apply any one
of these controls while you're driving, unless you
have to make an emergency stop.
If the air pressure drops below 60 to 70 psi (413 to
482 kPa), the PRIMARY BRAKE light will come on. If
the air pressure drops to 40 to 45 psi (275 to 309 kPa), the
yellow knob will automatically pop out and apply the
spring brakes. If you ever have a complete loss of air so
that your air brakes automatically apply, there is a way that
the tow operator can release the parking brakes to tow the
vehicle. See ªTowing Your Vehicleº in the Index.
CAUTION:
If your vehicle is left in gear, the engine can
start if the vehicle starts to roll. This can easily
happen if you have the diesel engine. Shift the
transmission into NEUTRAL (N) before you
leave the vehicle.
ProCarManuals.com

yellowblue
2-30
Running Your Engine While You're
Parked (Automatic Transmission)
It's better not to park with the engine running. But if
ever you have to, here are some things to know.
CAUTION:
Idling the engine with the climate control system
off could allow dangerous exhaust into
your vehicle (see the earlier Caution under
ªEngine Exhaustº).
Also, idling in a closed-in place can let deadly
carbon monoxide (CO) into your vehicle even if
the fan switch is at the highest setting. One place
this can happen is a garage. Exhaust
-- with
CO
-- can come in easily. NEVER park in a
garage with the engine running.
Another closed-in place can be a blizzard.
(See ªBlizzardº in the Index.)
CAUTION:
It can be dangerous to get out of your vehicle
without the parking brake firmly set. Your
vehicle can roll. If you've left the engine running,
the vehicle can move suddenly. You or others
could be injured. To be sure your vehicle won't
move, even when you're on fairly level ground,
always set your parking brake.
Follow the proper steps to be sure your vehicle
won't move.
Windows
Manual Windows
Turn the hand crank on each door to raise or lower
the window.
ProCarManuals.com

yellowblue
2-36 Cruise Control (If Equipped)
With cruise control, you can
maintain a speed of about
30 mph (48 km/h) or more
without keeping your foot
on the accelerator. Cruise
control does not work at
speeds below about 30 mph
(48 km/h).
If you have an automatic transmission and you apply
your brakes, the cruise control will shut off.
If you have a manual transmission and you apply your
brakes or push the clutch pedal, the cruise control will
shut off.CAUTION:

Cruise control can be dangerous where you
can't drive safely at a steady speed. So,
don't use your cruise control on winding
roads or in heavy traffic.

Cruise control can be dangerous on
slippery roads. On such roads, fast changes
in tire traction can cause needless wheel
spinning, and you could lose control. Don't
use cruise control on slippery roads.
ProCarManuals.com

yellowblue
2-39
Using Cruise Control on Hills
How well your cruise control will work on hills depends
upon your speed, load and the steepness of the hills.
When going up steep hills, you may want to step on the
accelerator pedal to maintain your speed. When going
downhill, you may have to brake or shift to a lower gear
to keep your speed down. Of course, applying the brake
or clutch takes you out of cruise control. Many drivers
find this to be too much trouble and don't use cruise
control on steep hills.
Ending Cruise Control
There are different ways to turn off the cruise control:

Step lightly on the brake pedal.

Push the clutch pedal, if you have a
manual transmission.

Move the cruise switch to OFF.
Erasing Speed Memory
When you turn off the ignition, your cruise control set
speed memory is erased.Trailer Brake Hand Control Valve
(Option)
If your vehicle has this feature, it is mounted on the
steering column.
This control lets you apply the trailer brakes without
applying the tractor brakes. You can apply the trailer
brakes a little or apply them all the way if you have to.
Use this control only when you're driving. Don't use it
for parking or to hold the rig on a hill.
ProCarManuals.com

yellowblue
2-57
Readings in the low warning zone may occur when a
large number of electrical accessories are operating
in the vehicle and the engine is left at an idle for an
extended period. This condition is normal since the
charging system may not be able to provide full
power at engine idle. As engine speeds are increased,
this condition should correct itself because higher
engine speeds allow the charging system to create
maximum power.
You can only drive a short time on the battery. Be sure
to shut off the radio, the fan or any unnecessary
accessories and have the system serviced.
Do Not Shift Warning Light
If your vehicle has the
Allison MD automatic
transmission, certain
transmission malfunctions
will turn this light on.If this light comes on while you are driving, do not use
the transmission shift control. Using the transmission
shift control will result in the loss of forward gears. The
computer for the transmission senses a problem and
chooses a gear to stay in so that you can drive the
vehicle in that gear. You may not be able to drive as fast
or back up when this light is on.
NOTICE:
If the DO NOT SHIFT warning light comes on
while you are driving, it is a warning that making
a transmission ªrangeº change could leave you
stranded. The vehicle may not continue to move
if you change gears with the transmission shift
control. The transmission can't operate in all
gears because something is wrong. Leave the shift
control alone and drive directly to a GM dealer
for service. If you can't go in for service
immediately, have the vehicle towed.
Brake System Warning Light
Your vehicle has either hydraulic or air brakes. Each
system has different warning lights.
ProCarManuals.com

yellowblue
2-64 Service Trans Filter Indicator Light
(If Equipped)
If your vehicle has this
light, you'll find it
below the cluster on the
instrument panel.
It monitors the transmission fluid filter. If it ever
goes on, it means your transmission filter is dirty and
requires replacement.
Malfunction Indicator Lamp
(Check Engine Light)
If your vehicle is equipped
with either a gasoline
engine or an electronically
controlled diesel engine,
you will have this light.
If this light comes on or flashes while you are driving,
two things may happen.
First, you won't notice any difference in engine
performance, but your tail pipe emissions may increase.
Second, your engine may not run properly or may stall
without warning. If either of these things happen, drive
or tow your vehicle to your dealer for service.
ProCarManuals.com