1999 GMC C-SERIES lock

yellowblue
2-20
Air Suspension Dump Control (If Equipped)
If your vehicle is equipped with the Hendrickson HAS
Series single
-axle air suspension, you may have this
control. The air suspension dump control allows the
operator to lower the deck height approximately
4.5 inches (11.5 cm) from the normal frame height.
The switch to deflate and
inflate the air suspension is
located on the upper left
side of the instrument panel
above the driver's side vent.
The light in the switch will be illuminated whenever the
switch is in the ªdumpedº position.
Automatic Transmission Operation
We build vehicles with four, five and six-speed
automatic transmissions. This part of the manual covers
the basics of these. With some of the transmissions, you
will find another manual in your vehicle that goes into
more detail. On the ceiling, in front of and above the
driver, or in some other place near the driver, you will
see a label that describes important operating facts about
the automatic transmission in your vehicle. Make sure
you follow the instructions on this label.
You may have a PARK (P) position for your shift lever.
This position locks your rear wheels. It is the best
position to use when you start your engine because your
vehicle can't move easily.
All vehicles equipped with automatic transmissions
can be started in PARK (P), if equipped, or in
NEUTRAL (N). When you shift out of NEUTRAL (N),
you may have to hold in a push button on the shift lever
or lift up on a release handle as you shift. See the
Allison Automatic Transmission Operator's Manual in
your vehicle for more information about this.
ProCarManuals.com

yellowblue
2-24 Hydraulic Brakes
If your vehicle has hydraulic brakes, it has a parking
brake lever or an electric/hydraulic parking brake. The
lever is below the instrument panel to the left of the
steering column. The electric/hydraulic parking brake
knob is to the right of the steering column.
Your vehicle may also be equipped with an automatic
transmission which has a shift lever. This lever will have
a PARK (P) position on the shift indicator. When the
PARK (P) position is selected with the shift lever, the
parking brake is automatically applied.
Propshaft Brake Burnish Procedure
It is recommended that the propshaft-mounted parking
brake be burnished as part of the new vehicle break
-in.
The parking brake will work best after it has been
burnished following these instructions.
Make 10 stops, using the parking brake hand lever, from
20 mph (32 km/h) about 2 1/2 miles (4 km) apart.
Between stops, drive the vehicle at 20 mph (32 km/h).
Lever Operated Parking Brake
To apply the parking brake,
pull the lever all the way up.
The PARK BRAKE light
will come on when the
parking brake is applied.
Then shift the transmission
to NEUTRAL (N) or
PARK (P).
The vehicle must be stopped when applying the parking
brake, except while burnishing the parking brake linings
(see ªPropshaft Brake Burnish Procedureº in the Index).
You can easily adjust the parking brake by turning the
knob on the lever. Turning it clockwise makes the brake
grip more tightly. It will also make the lever seem harder
to pull up. Turning the knob counterclockwise makes the
parking brake apply less firmly. Adjust the parking
brake only when the lever is down (released).
ProCarManuals.com

yellowblue
2-32
To tilt the wheel, hold the steering wheel and pull the
lever. Move the steering wheel to a comfortable level,
then release the lever to lock the wheel in place.
Turn Signal/Multifunction Lever
The lever on the left side of the steering column
includes your:

Turn Signal and Lane Change Indicator

Headlamp High/Low Beam Changer

Windshield Wipers

Windshield Washer

Cruise Control (If Equipped)
ProCarManuals.com

yellowblue
2-35
Low Speed Delay Wipers (If Equipped)
You can set the wiper speed
for a long or short delay
between wipes. This can be
very useful in light rain or
snow. Turn the band to
choose the delay time.
The closer to LO, the
shorter the delay.
Heavy snow or ice can overload your wipers. Clear
away snow or ice to prevent bending or breaking the
wiper linkage.
Windshield Washer
At the top of the multifunction lever, there's a paddle
with the word PUSH on it. To spray washer fluid on the
windshield, push the paddle.
CAUTION:
In freezing weather, don't use your washer until
the windshield is warmed. Otherwise the washer
fluid can form ice on the windshield, blocking
your vision.
If you have the standard wipers, the wipers will keep
going in LO until you turn the wiper control to the
off symbol.
If you have the low
-speed delay option, the wipers will
clear the window and then either stop or return to your
preset speed.
ProCarManuals.com

yellowblue
2-40
CAUTION:
Using the trailer brake hand control for parking
or for holding the vehicle on a hill may not keep
the vehicle from rolling. This can happen if
someone hits the valve by accident, or if air
pressure bleeds from the system. If the vehicle
rolls, you or others could be injured. To park the
vehicle or hold it on a hill, use the parking
brake properly.
Inter-Axle Differential Lock Control
(If Equipped)
If your vehicle has this
feature, the control is
located at the lower
right corner of the
instrument panel.
If you're approaching a slippery surface where it looks
like one or even all of the wheels may start to slip, you
can use this control. It locks your rear differentials so
that power is transmitted equally to both rear axles.
ProCarManuals.com

yellowblue
2-41
Let up on the accelerator before you turn on your
inter
-axle differential lock. When you turn on this
control, the DIFF LOCK indicator on the instrument
panel will light.
NOTICE:
Activating the inter-axle differential lock when
the rear wheels are actually spinning freely, as
they might on ice or snow, can cause you to lose
control of the vehicle. It can also damage the
axles. Turn on this control only when the wheels
are not spinning freely.
Rear Axle Differential Lock Control
(If Equipped)
If your vehicle has a
Controlled Traction or
Locking Differential axle,
the control is located at the
lower right corner of the
instrument panel. You'll see
this control on single rear
axle vehicles.
If you're approaching a slippery surface where it looks
like one or even both wheels may start to slip, you can
use this control. It locks your rear differential so that
power is transmitted equally to both rear wheels.
ProCarManuals.com

yellowblue
2-42
Let up on the accelerator before you turn on your rear
axle differential lock.
NOTICE:
Activating the rear-axle differential lock when
the rear wheels are actually spinning freely, as
they might on ice or snow, can cause you to lose
control of the vehicle. It can also damage the axle.
Turn on this control only when the wheels are not
spinning freely.
Engine Air Control (If Equipped)
If your vehicle has this control, the handle is located on
the instrument panel just to the right of the steering
wheel. The control is activated by pulling the handle out
and turning slightly in either direction to lock it.
ProCarManuals.com

yellowblue
2-44
Press the top left switch to turn on your:

Parking Lamps

Marker Lamps (unless your vehicle has the optional
marker and clearance lamps switch)

Taillamps

Instrument Panel Lights

License Plate Lamps
Push the bottom left switch to turn on the headlamps, as
well as all of the lamps just listed. Push the switch
marked with the ªOº symbol to turn off your lamps.
Move the thumbwheel to the right of the off switch
down to dim your instrument panel lights. Moving this
wheel up makes these lights brighter. Moving it all the
way up will make the interior lamp come on.
A circuit breaker protects your headlamps. If you have
an electrical overload, your headlamps will flicker on
and off. Have your headlamp wiring checked right away
if this ever happens.Headlamps On Reminder (If Equipped)
If you have this system, a tone alarm will sound when
your headlamps and/or parking lamps are turned on and
your ignition is in OFF, LOCK or ACCESSORY.
Daytime Running Lamps (If Equipped)
Daytime Running Lamps (DRL) can make it easier for
others to see the front of your vehicle during the day.
DRL can be helpful in many different driving
conditions, but they can be especially helpful in the
short periods after dawn and before sunset.
The high and low
-beam headlamps will come on at
reduced brightness in daylight when:

The ignition is on,

The headlamp switch is off and

The parking brake is released.
When the DRL are on, only your low
-beam headlamps
will be on. The exterior lamps won't be on. Your
instrument panel won't be lit up either.
When it begins to get dark, your DRL indicator light is a
reminder to turn your headlamp switch on. The other
lamps that come on with your headlamps will also
come on.
ProCarManuals.com