1999 GMC C-SERIES lock

yellowblue
v
For example,
these symbols
are used on an
original battery:
CAUTION
POSSIBLE
INJURY
PROTECT
EYES BY
SHIELDING
CAUSTIC
BATTERY
ACID COULD
CAUSE
BURNS
AVOID
SPARKS OR
FLAMES
SPARK OR
FLAME
COULD
EXPLODE
BATTERY
These symbols
are important
for you and
your passengers
whenever your
vehicle is
driven:
DOOR LOCK
UNLOCK
FASTEN
SEAT
BELTS
POWER
WINDOW
AIR BAG
These symbols
have to do with
your lamps:
MASTER
LIGHTING
SWITCH
TURN
SIGNALS
PARKING
LAMPS
HAZARD
WARNING
FLASHER
DAYTIME
RUNNING
LAMPS
FOG LAMPS
These symbols
are on some of
your controls:
WINDSHIELD
WIPER
WINDSHIELD
WASHER
WINDSHIELD
DEFROSTER
REAR
WINDOW
DEFOGGER
VENTILATING
FAN
These symbols
are used on
warning and
indicator lights:
ENGINE
COOLANT
TEMP
BATTERY
CHARGING
SYSTEM
BRAKE
COOLANT
ENGINE OIL
PRESSURE
ANTI-LOCK
BRAKES
Here are some
other symbols
you may see:
FUSE
LIGHTER
HORN
SPEAKER
FUEL
Vehicle Symbols
These are some of the symbols you may find on your vehicle.
ProCarManuals.com

yellowblue
1-2
Seats and Seat Controls
This section tells you about the seats in your vehicle and
how to adjust them.
CAUTION:
You can lose control of the vehicle if you try to
adjust the seat while the vehicle is moving. The
sudden movement could startle and confuse you,
or make you push a pedal when you don't want
to. Adjust the driver's seat only when the vehicle
is not moving.
Bucket and Bench Seats
If your vehicle has a bucket or bench seat, you can
adjust it with this lever at the front of the seat.
Slide the lever toward the outer seat support to unlock it.
Slide the seat to where you want it. Then, release the
lever and try to move the seat with your body to make
sure the seat is locked into place.
ProCarManuals.com

yellowblue
1-3 Head Restraints
Some seats have adjustable head restraints. Slide an
adjustable head restraint up or down so that the top of
the restraint is closest to the top of your ears. This
position reduces the chance of a neck injury in a crash.
Seatback Latches
The front of the full-width bench seat seatback folds
forward to let you reach the rear of the cab. Bucket seats
have outboard
-mounted levers to tilt the seatbacks
forward or rearward.
Your seatback will move back and forth freely unless
you come to a sudden stop
-- then it will lock into place.
If your vehicle is parked going down a fairly steep hill,
the seatback may not fold without some help from you.
To fold the seatback
forward, push the seatback
toward the rear of the
vehicle as you lift this latch.
The latch must be down for
the seat to work properly.
Bench Seat Shown
CAUTION:
If the seatback isn't locked, it could move
forward in a sudden stop or crash. That could
cause injury to the person sitting there. Always
press rearward on the seatback to be sure it
is locked.
ProCarManuals.com

yellowblue
1-5
To adjust the height of the
cushion, lift the cushion
height adjustment handle up
and forward. You can
choose between two
settings. The handle is
located underneath the seat,
in the front.
Lumbar Adjustments
To get more support in the
lumbar area of your back,
turn the lumbar adjustment
knob. The knob is located
on the upper cushion, on the
inboard side of the driver's
seat and the outboard side
of the passenger's seat.Seatback Adjustment
To tilt the seatback, turn the
backrest tilt knob. The knob
is located on the lower
cushion, on the outboard
side of the driver's seat and
the inboard side of the
passenger's seat.
Fore
-and-Aft Adjustment
To slide the seat forward or
backward, move the lever
toward the passenger's side.
The seat will lock in at
1/2 inch (1.5 cm)
increments. The lever is
located underneath the seat,
in the front.
ProCarManuals.com

yellowblue
1-6
Chugger-Snubber Lock-Out Feature (If Equipped)
This handle is located on
the lower outboard side of
the driver's seat and the
inboard side of the
passenger's seat. Move the
handle down to isolate any
backslap experienced while
in tractor/trailer operation or
while operating a dump
truck application. This is
only available on
low
-back seats.
Safety Belts: They're for Everyone
This part of the manual tells you how to use safety belts
properly. It also tells you some things you should not do
with safety belts.
CAUTION:
Don't let anyone ride where he or she can't wear
a safety belt properly. If you are in a crash and
you're not wearing a safety belt, your injuries
can be much worse. You can hit things inside the
vehicle or be ejected from it. You can be seriously
injured or killed. In the same crash, you might
not be if you are buckled up. Always fasten your
safety belt, and check that your passengers' belts
are fastened properly too.
ProCarManuals.com

yellowblue
1-12 Lap-Shoulder Belt
The driver has a lap-shoulder belt. Here's how to wear
it properly.
1. Close and lock the door.
2. Adjust the seat (to see how, see ªSeatsº in the Index)
so you can sit up straight.
Bench (A)
Suspension (B)
3. Pick up the latch plate and pull the belt across you.
Don't let it get twisted.
4. Push the latch plate into the buckle until it clicks.
ProCarManuals.com

yellowblue
1-13
For suspension-type seats (B), if the belt stops before
it reaches the buckle, tilt the latch plate and keep
pulling until you can buckle the belt. Pull up on the
latch plate to make sure it is secure. If the belt is
pulled out all the way so that it locks, press down on
the button on the retractor cover to make it retract.
If the belt isn't long enough, see ªSafety Belt
Extenderº at the end of this section.
Make sure the release button on the buckle is
positioned so you would be able to unbuckle the
safety belt quickly if you ever had to.
Suspension (B)
5. To make the lap part tight on suspension
-type
seats (B), pull down on the buckle end of the belt as
you pull up on the shoulder belt.
ProCarManuals.com

yellowblue
1-15

You can add a small amount of slack. The system
works like a window shade. To add a little slack, pull
down on the shoulder belt just a little
-- no more
than 1 inch (25 mm).

If it's now too loose, pull it out like you did before
and start again.

If you move around in the vehicle and your shoulder
belt becomes loose, be sure to make it tight again.
The lap part of the belt should be worn low and snug on
the hips, just touching the thighs. In a crash, this applies
force to the strong pelvic bones. And you'd be less likely
to slide under the lap belt. If you slid under it, the belt
would apply force at your abdomen. This could cause
serious or even fatal injuries. The shoulder belt should go
over the shoulder and across the chest. These parts of the
body are best able to take belt restraining forces.
The safety belt locks if there's a sudden stop or a crash.
ProCarManuals.com