Page 83 of 328

yellowblue
2-25 Headlamp High/Low Beam Changer
To change the headlamps from low beam to high or high
beam to low, push the turn signal away from you. To
switch back to low beams, pull the lever toward you.
When the high beams are
on, this light on the
instrument panel also will
be on. It will go off when
you switch to the
low beams.
Flash-to-Pass
This feature lets you use your high-beam headlamps to
signal a driver in front of you that you want to pass.
To use it, pull the turn signal/multifunction lever toward
you until the high
-beam headlamps come on, then
release the lever to turn them off.
Windshield Wipers
You control the windshield wipers by moving the stalk
with the windshield wiper symbol on it up or down.
For steady wiping at low speed, move the stalk down to
LO. For high
-speed wiping, move the stalk down to HI.
To stop the wipers, move the stalk to OFF.
If your vehicle is equipped with intermittent wipers, you
can use this function by moving the stalk to INT. In light
rain or snow, you might want to use this position rather
than continuous wiping.
Page 84 of 328

yellowblue
2-26
Remember that damaged wiper blades may prevent you
from seeing well enough to drive safely. To avoid damage,
be sure to clear ice and snow from the wiper blades before
using them. If they're frozen to the windshield, carefully
loosen or thaw them. If your blades do become damaged,
get new blades or blade inserts.
Heavy snow or ice can overload your wipers. A circuit
breaker will stop them until the motor cools. Clear away
snow or ice to prevent an overload.
Windshield Washer
To wash your windshield, pull the stalk with the washer
symbol on it toward you to spray washer fluid on the
windshield. The spray will continue until you release the
lever. If your vehicle is equipped with intermittent
wipers, your windshield wipers will cycle a few times.
See ªWindshield Washer Fluidº in the Index.
CAUTION:
In freezing weather, don't use your washer until
the windshield is warmed. Otherwise the washer
fluid can form ice on the windshield, blocking
your vision.
Rear Window Wiper/Washer (If Equipped)
If you have this option on
your two
-door model, push
the upper button to turn on
your rear wiper. Push the
same button again to turn
it off.
To wash and wipe at the same time, push the lower
washer button all the way in.
The washer and wiper will run as long as you hold it.
To add washer fluid, see ªWindshield Washer Fluidº in
the Index.
Page 251 of 328
yellowblue
6-59
Engine Compartment Fuse Block
The main fuse box is in your engine compartment on the
driver's side. It protects all electrical loads.
For access to the main fuses, squeeze the tabs on the
sides and pull off the cover.
Fuse Useage
BATT All Electrical Load
ABS ABS System
IG Accessory, Ignition, Windshield
Wipers, Defrost/Defog, Heater,
Back
-Up Lamps
LAMP Taillamps, Stoplamps, Hazard,
Headlamps (right and left)
PTC PTC Heater
FI Fuel Injection
RDTR Radiator Fan Motor
A/C Air Conditioner