Page 14 of 38
Check the action of the buttons on the other door to verify its function (lock/unlock).
WARNING! The doors should not be locked while driving. In case of an accident, this may hinder rapid access to
the occupants of the vehicle.
NOTE: If a door is not closed completely, the courtesy lights will stay on and a chime will sound until the door is
closed.
Contents | Top of Page
ProCarManuals.com
Page 32 of 38
Chapter 10 - Audio systems
pg. 131 Audio systems
Audio systems
This chapter describes the audio system in your car. SC-813
132
SC-816145
SC-900161
General Information184
pg. 132 Audio system SC -813 (certain models)
The following pages describe the use of your SC -813 Cassette radio and CD remote control
1. On/off (push)
2.
3. Volume (turn)
4. Pause/Mute (push)
5. Balance (pull)
6. Active Sound
Control
7. CD changer selector
8.
9. Tape mode selector
10. Tape direction
selector PROG
11. Bass control
12. Treble control
13. Fader control
14.
15. Preset buttons
16. CD-Disc No.
selector
17. PROG - Reversing 11.
Dolby B NR button
12. Cassette eject
13. Not in use
14. Scan
15. Auto seek memory
16.
17. Seek tuning up/down
18. TP-Next/Previous song
19. CD-Next UP/Previous
DOWN track
20.
21. Manual tuning
22. TP-fast forward/Rewind
23. CD-Music search
UP/DOWN
24. RND button 19.
Cassette slot
20. Display
21. Waveband selector (AM)
22. Waveband selectors (FM)
23. Anti-theft LED
TP = Applicable only in Tape Mode
CD = Applicable only when in CD mode and
connected to a CD changer.
ProCarManuals.com
Page 33 of 38
the tape
pg. 133 Anti -theft code
Anti -theft code
The radio features anti-theft circuitry. If the set is removed from the vehicle or if the battery power is disconnected, a
special code must be entered to enable operation of the set.
Refer to the radio code card supplied with your vehicle or ask your retailer for the correct code.
When the car is parked with the ignition key removed, the anti-theft LED will flash.
To enter the code
After installation or when the set has been disconnected from power, the set displays "COdE" when it is switched on.
Enter the 4-digit code using the preset buttons. If the correct code is entered, "on" is displayed and the set is ready to
use.
If you enter an incorrect code you must enter the correct code again from the beginning.
Incorrect code
If an incorrect code has been entered "rPt" is displayed. Enter the correct code.
After three unsuccessful coding attempts the set will lock and remain locked for two hours. "OFF" is displayed.
During this waiting period:
the battery must be connected
the ignition key must be turned to position I
the unit must be turned on
Make sure the headlights are turned off to help prevent battery drain (please refer to page 24 for information on turning
the headlights off). Enter the code again once this time has elapsed.
ProCarManuals.com
