1998 VOLVO C70 parking brake

11 Electrically operated sun roof (optional)41
12 Rear window demister/heated door mirrors
23
13 Air mix
33
14 Air vents
33
15 Passenger side air bag (SRS) hatch
4-6
16 Air vents
33
17 Hood release
51
18 Turn signals, high/low beams
20
Cruise control
29
19 Adjustable steering wheel
32
20 Windshield wiper/washer
21
21 Heated front seats (optional)
30
22 Auxiliary socket
31
23 Audio systems
131
24 Heating and ventilation controls
33-35
25 Hazard warning flashers
23
26 Ashtray
31
27 Coin holder
28 Shiftlock release button (automatic transmission only)
97
29 Gear selector shift positions
60-62
30 Transmission mode selectors
62
31 Parking brake
30
32 Horn/SRS
4-6
33 Trunk open control
52
34 Power window controls
36
35 Power mirror controls
48
36 Fuel tank open control
37
37 Central locking button
36
Some of the items above are available on certain models only.
Shiftlock (automatic transmission only)
When your car is parked, the gear selector is locked in the (P)ark position. To release the selector from this position,
turn the ignition key to position II (or start the engine), depress the brake pedal, press the button on the front side of the
gear selector and move the selector from (P)ark.
If it is necessary to manually override the shiftlock system:
Turn the starting (ignition) key to position I
Press firmly on the "SHIFTLOCK OVERRIDE" button located near the base of the gear selector.
While holding the override button down, press the button on the front of the gear selector.
Move the gear selector from the ( P)ark position.
Keylock (automatic transmission only)
This means that when you switch off the ignition, the gear selector must be in the (P)ark position before the starting
(ignition) key can be removed from the ignition switch.
Anti -lock Brake System (ABS)
ProCarManuals.com

Chapter 6 - In case of emergency
pg. 81 In case of an emergency
In case of an emergency

Even if you maintain your car in good running condition, there is always the possibility that something might go wrong
and prevent you from driving, such as a punctured tire, blown fuse or bulb, etc. For additional information, see section
"ON CALL Road Assistance".
Wheel changing
82-83
Spare tire84
Replacing bulbs85-90
Replacing fuses91-93
Installation of accessories94
Replacing wiper blades95-96
In case of emergency97
pg. 82 Wheel changing

Loosen wheel bolts
Changing a wheel
The spare wheel is located under the carpet on the trunk floor. The jack and crank are secured in the wheel recess.
Engage the parking brake.
Put the gear selector in (P)ark (automatic) or in Reverse (manual).
With the car still on the ground, use the lug wrench to loosen the wheel bolts 1/2 - 1 turn. Turn the bolts
counterclockwise to loosen.
Fold out the crank handle on the jack by pressing the nob on the handle downward. To attach the jack, refer to the
illustration on the following page.
NOTE: To avoid excessive wear and the necessity of rebalancing, mark and reinstall wheels in same location and
position as before removal. To lessen the chance of imbalance, each wheel hub is equipped with a guide stud to ensure
ProCarManuals.com

that a removed wheel can be reinstalled in its original position (as when changing over to winter tires/wheels).
CAUTION:
The car must not be driven with wheels of different dimensions or with a spare tire other than the one that came
with the car. The use of different size wheels can seriously damage your car's transmission.
pg. 83 Wheel changing (cont.)

Jack attachment
There is a jack attachment located in the center on each side of the car. Position the jack on the bar in the attachment
as shown in illustration A above and crank while simultaneously guiding the base of the jack to the ground. The base
of the jack must be flat on a level, firm, non-slippery surface. Before raising the car check that the jack is still
correctly positioned in the attachment. Raise the vehicle until both wheels on the side of the car where the jack is
attached are lifted off the ground. Unscrew the wheel bolts completely and carefully remove the wheel so as not to
damage the thread on the studs.
Installing the wheel
Clean the contact surfaces on the wheel and hub. Lift the wheel and place it on the hub. Make sure that you align the
wheel with the guide stud on the wheel hub prior to installation. Install the wheel bolts crosswise (see illustration) and
tighten by turning lightly clockwise. Lower the vehicle to the ground and alternately tighten the nuts to 81 ft. lbs. (110
Nm). Install the wheel cap (where applicable).

Correct tightening order for wheel bolts
WARNING!
The jack's attachment must engage the bar in the jack attachment (A). The car's weight must not rest on the jack's
attachment (B).
Be sure the jack is on a firm, level, non-slippery surface.
Never allow any part of your body to be extended under a car supported by a jack.
Use the jack intended for the car when replacing a wheel. For any other job, use stands to support the end of the
car being worked on.
Apply the parking brake, select position P (automatic transmission) or Reverse gear (manual transmission).
Block the wheels standing on the ground, use rigid wooden blocks or large stones.
The jack should be kept well-greased.
ProCarManuals.com

Label information.........................106Lifting the car...........................110Locks......................................42Long distance trips........................73Long load storage..........................50Lubrication...............................113
M
Maintenance schedule......................108Maintenance service.......................107Malfunction indicator lamp..............17,18Manual transmission....................60,127Manual transmission fluid.................124Memory function - front seats..............46Mirrors - rear/side view...................48
O
Occupant safety............................12Octane rating..............................57Odometer...................................16Oil (engine)......................114,115,124Oil pressure warning light.................18On-call...................................130
P
Paint touch -up............................100Parking brake...........................17,30Parking brake reminder light...............18Parking lights.............................20Polishing.................................103Power seats.............................46,47Power steering fluid..................116,124
R
Radio
General information.....................184
SC-813..................................132 SC-816..................................145 SC-900..................................161Radio Data System - RDS...................166Reading lights.............................49Rear (side) windows - opening..............37Rear fog light..........................17,22Rear suspension...........................126Rear window demister.......................23Rear/side -view mirrors....................48Refueling..................................57Remote control (central locking system)....43Remote keyless entry system................43Replacing bulbs.............85,86,87,88,89,90Replacing fuses............................91Reporting Safety Defects...................12Road Assistance...........................130Roadholding................................65Roof rails/racks...........................65
S
Safety defects (reporting).................12Seat belt maintenance......................12Seat belts.............................2,3,10 Automatic Locking Retractor..............10 Emergency Locking Retractor..............10Seat belts - cleaning.....................104Seats......................................46Seats - heated.............................30Service reminder indicator..............17,19Servicing.........................110,111,112Shift lock..............................59,61Shiftlock release (override)...............97Side Impact Protection System (SIPS)........8Side -view mirrors - heated.................23
ProCarManuals.com