1998 SSANGYONG MUSSO ignition

SECTION 9L
GLASS AND MIRRORS
Caution: Disconnect the negative battery cable before removing or installing any electrical unit or when a
tool or equipment could easily come in contact with exposed electrical terminals. Disconnecting this cable
will help prevent personal injury and damage to the vehicle. The ignition must also be in LOCK unless otherwise
noted.
TABLE OF CONTENTS
Schematic and Routing Diagrams . . . . . . . . 9L-2
Outside Mirror . . . . . . . . . . . . . . . . . . . . . . . . . 9L-2
Auto Dimming Room Mirror . . . . . . . . . . . . . . . 9L-3
Maintenance and Repair . . . . . . . . . . . . . . . 9L-4
On-Vehicle Service . . . . . . . . . . . . . . . . . . . . . . 9L-4
Front & Side Glass . . . . . . . . . . . . . . . . . . . . . 9L-4
Tailgate Glass . . . . . . . . . . . . . . . . . . . . . . . . . 9L-9
Auto Dimming Room Mirror . . . . . . . . . . . . . . 9L-12

GLASS AND MIRRORS 9L-13
Check & Service
If reflection ratio is not adjusted automatically during night
driving when AUTO switch is pressed, check each connectors
for proper connection and power flow to the auto dimming room
mirror using multi tester.
1. Yellow (Connected to back-up lamp)
2. Blue (Ground)
3. White (Power)
Voltage Rating
Operating Current
Over CurrentDV 12V
1 A
3 A
Function
When ignition switch is turned ON, green lamp on auto dimming
mirror will turn in and glare reflection ratio will be automatically
adjusted. By positioning AUTO switch to ON, 2Sensors will
automatically adjust refection ratio after sensing rear and
surrounding brightness to reduce driver’s eye fatigue during
driving though tunnel or in night.
When OFF switch is pressed, the lamp goes out and it will be
operated as a normal rear view mirror and shift lever is
positioned in reverse, the auto dimming function will be
automatically OFF.
Specifications

SECTION 9P
DOORS
Caution: Disconnect the negative battery cable before removing or installing any electrical unit or when a
tool or equipment could easily come in contact with exposed electrical terminals. Disconnecting this cable
will help prevent personal injury and damage to the vehicle. The ignition must also be in LOCK unless otherwise
noted.
TABLE OF CONTENTS
Schematic and Routing Diagrams . . . . . . . . 9P-2
Power Window . . . . . . . . . . . . . . . . . . . . . . . . 9P-2
Maintenance and Repair . . . . . . . . . . . . . . . 9P-3
On-Vehicle Service . . . . . . . . . . . . . . . . . . . . . . 9P-3Front Door . . . . . . . . . . . . . . . . . . . . . . . . . . . 9P-3
Rear Door . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9P-4
Tail Gate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9P-5

SECTION 9T
REMOTE KEYLESS ENTRY AND
ANTI-THEFT SYSTEM
Caution: Disconnect the negative battery cable before removing or installing any electrical unit or when a
tool or equipment could easily come in contact with exposed electrical terminals. Disconnecting this cable
will help prevent personal injury and damage to the vehicle. The ignition must also be in LOCK unless otherwise
noted.
TABLE OF CONTENTS
Specifications . . . . . . . . . . . . . . . . . . . . . . . . 9T-1
REKES Specifications . . . . . . . . . . . . . . . . . . . 9T-1
Schematic and Routing Diagrams . . . . . . . . 9T-2
REKES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9T-2
Diagnosis . . . . . . . . . . . . . . . . . . . . . . . . . . . 9T-3
SPECIFICATIONS
REKES SPECIFICATIONS
Diagnosis Test . . . . . . . . . . . . . . . . . . . . . . . . 9T-3
Maintenance and Repair . . . . . . . . . . . . . . . 9T-5
On-Vehicle Service . . . . . . . . . . . . . . . . . . . . . . 9T-5
REKES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9T-5
Transmitter
Description
DC 3V
-10°C - 60°C
Changeable Coin Type LITHIUM Battery
(CR2032)
Above 2 years (10 times/day) Application
Rated Voltage
Rated Range of Operating Temperature
Model
Durability
Description
DC 12V
DC 8V - 16V
-30°C - +80°C
Above 5M W
Maximum 3mA Application
Rated Voltage
Rated Range of Operating Voltage
Rated Range of Operating Temperature
Insulating Resistance
Arm Current
Receiver

SECTION 9U
CONTROL UNITS AND SYSTEM
Caution: Disconnect the negative battery cable before removing or installing any electrical unit or when a
tool or equipment could easily come in contact with exposed electrical terminals. Disconnecting this cable
will help prevent personal injury and damage to the vehicle. The ignition must also be in LOCK unless otherwise
noted.
TABLE OF CONTENTS
Specifications . . . . . . . . . . . . . . . . . . . . . . . . 9U-1
STICS Specifications . . . . . . . . . . . . . . . . . . . 9U-1
Schematic and Routing Diagrams . . . . . . . . 9U-2
STICS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9U-2
Function Description . . . . . . . . . . . . . . . . . . 9U-3
SPECIFICATIONS
STICS SPECIFICATIONS
Description
DC 12V
Dc 9V - 16V
Less than 1mA(key is removed and all doors locked)
-30°C - +80°C
Between terminal No.5 and 3,4,8,12,18,25
Between terminal No. 5 and 2,6,7,16,17
Between terminal No.5 and 11, 27Application
Voltage Rating
Voltage Rating
Current Consumption
Operating Temperature
Voltage Drop
(at DC 12V)Max. 1.2V
Max. 1.8V
Max. 2.0VSTICS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9U-3
Maintenance and Repair . . . . . . . . . . . . . . 9U-10
On-Vehicle Service . . . . . . . . . . . . . . . . . . . . . 9U-10
STICS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9U-10

CONTROL UNITS AND SYSTEM 9U-3
FUNCTION DESCRIPTION
STICS
Operating Functions
NO.ApplicationDeseription
1Wiper INT sensing vehicle speed
lBy operating INT time control volume, variable time will be
changed within 1.5 - 20 seconds.
2Washer relating wiperlWiper begins to operate within 0.6 - 1 sec when the washer
switch is ON and it operates 3 times after the washer switch is
OFF while the IGN2 switch in ON.
3Dimming room lamplWhen room lamp is coupled with door, it turns on if door is
opened. After closing the door it maintains 2 seconds of lighting
and dims off whithin 3 seconds.
4Time delayed power window controllPower window can be operated within 30 seconds after turning
the IGN1 switch from ON to OFF. If driver’s/passenger’s door is
opened within the 30 seconds, time will be prolonged for more
30 seconds from that moment.
5Rear defogger timerlThe rear defogger will be operated for 12 min. by turning ON the
defogger switch while engine is running.
lDefogger will be stopped by pushing the switch again.
lThe defogger will be operated 6 min, if push ON the switch within
10 min. after 12 min. of operation.
6Seat belt warninglThe warning lamp will be turned on for about 6 sec. with an
intermittent chime bell when the IGN. switch is ON unless
fastening the seat belt.
7Parking brake warninglThe indicator lamp will flash if drive while the parking brake is
applied.
8Tail lamp lighting warninglWhen the driver’s door is opened while the tail lamp is still ON,
the buzzer operates intermittently. In this condition, the door will
be automatically unlocked when it locked.
9Door ajar warninglThe indicator lamp will be blinking when the door is not closed
completely and driving.
10IGN key reminderlThe chime will be operated intermittently if the driver’s door is
opened while the IGN key is still remaining in the ignition switch.
In this condition, the door will be automatically unlocked when it
locked.
11Central door locklAll doors will be locked/unlocked by locking/unlocking the
driver’s or passenger’s door.

9U-4 CONTROL UNITS AND SYSTEM
NO. ApplicationDeseription
13Ignition key hole illuminationlCoupled with door switch, ignition key hole illumination lamp will
turn on when the driver’s door is opened and will dim off after 10
sec. after closing the door.
14Auto door locklAll doors will be locked automatically if the vehicle speed
reaches 50km/h though the doors are in unlock.
15Auto door unlocklAll doors will be automatically unlocked if the vehicle crashes
while driving (over 15km/h).
16Input checking functionlSelf diagnostic function for each sensor switches and loads for
the system.
12Coupled with REKESlBeing coupled with REKES (remote keyless entry system), all
doors will be locked/unlocked according to signals of transmitter
when the ignition key is not inserted.

9U-8 CONTROL UNITS AND SYSTEM
11. Central door lock
T1 : within 0.2 sec.
T2 : 0.5±0.1
12. Coupled with REKES mode
T1 : 0.05±0.02 sec. (lock signal)
T2 : 0.1±0.02 sec. (unlock signal)
T3 : within 0.2±5 sec.
T4 : 0.5±0.1 sec.
T5 : within 0.3 sec.
T6, T7 : 0.5±0.1 sec.
T8 : 1±0.25 sec.
13. Ignition key hole illumination