1998 SSANGYONG MUSSO service

8B-22 SUPPLEMENTAL RESTRAINT SYSTEM(SRS)
GENERAL DESCRIPTION
AND SYSTEM OPERATION
INTRODUCTION
SRS (Supplemental Restraint System) air bag protects driver
and passenger by inflating air bag under collision and seat
belt pre - tensioner is a supplemental equipment for seat belt
reducing shocks from the collision by pulling passenger’s body
against seat back at the same time of air bag inflation.
Air bag unit has diagnosis functions and indicates system
malfunctions to the driver by turning on the air bag warning
lamp.
CAUTION
Perform the service procedures for the air bag system as
ordered, if not, the air bag can be operated suddenly and it
could result in damage of air bag or injury. Before service
(removal, installation, checking and replacement of parts),
observe the following instructions and service correctly.
1. To service, turn the ignition switch to ‘LOCK’ position and
disconnect the negative battery cable and continue the
procedures after approx. 30 seconds.
2. If the vehicle is damaged due to accident, remove the air
bag ECU first to get the accident records.
3. Never use the other vehicle’s air bag parts and replace
with genuine part, if required.
4. Do not disassemble or repair the air bag module, air bag
unit and wiring harness to reuse.
5. Replace the air bag unit or air bag module if dropped,
cracked or damaged.

Low (Philips H4)
Tail Lamp
Brake Lamp
High Mounted Stop Lamp
Reverse Lamp
Fog Lamp*
Turn Signal Lamp
Position Lamp
Front Lamp
Rear Lamp
Luggage Lamp
Door Courtesy Lamp
SECTION 9B
LIGHTING SYSTEM
Caution: Disconnect the negative battery cable before removing or installing any electrical unit or when a
tool or equipment could easily come in contact with exposed electrical terminals. Disconnecting this cable
will help prevent personal injury and damage to the vehicle. The ignition must also be in LOCK unless otherwise
noted.
TABLE OF CONTENTS
SPECIFICATIONS
BULB USAGE CHART
Head Lamp
Rear
Front
Interior
Application
Specifications . . . . . . . . . . . . . . . . . . . . . . . . 9B-1
Bulb Usage Chart . . . . . . . . . . . . . . . . . . . . . . 9B-1
Schematic and Routing Diagrams . . . . . . . . 9B-2
Tail Lamp & B/O Lamp . . . . . . . . . . . . . . . . . . 9B-2
Head Lamp . . . . . . . . . . . . . . . . . . . . . . . . . . . 9B-3
Head Lamp Leveling Device . . . . . . . . . . . . . . 9B-4
Turn Signal Lamp and Hazard Lamp . . . . . . . . 9B-5Back-Up Lamp and Stop Lamp . . . . . . . . . . . . 9B-6
Front and Rear Fog Lamp . . . . . . . . . . . . . . . 9B-7
Room Lamp . . . . . . . . . . . . . . . . . . . . . . . . . . 9B-8Maintenance and Repair . . . . . . . . . . . . . . . 9B-9
On-Vehicle Service . . . . . . . . . . . . . . . . . . . . . 9B-9
Front and Rear Lamps . . . . . . . . . . . . . . . . . . 9B-9
Hi
(Philips H1)
Hi
LowWatt/Quantity
55W / 2
55W / 2
55W / 2
5W / 4
21W / 4
21W / 1
21W / 2
55W / 2
21W / 2
5W / 2
8W / 2
10W / 1
8W / 1
5W / 4

LIGHTING SYSTEM 9B-9
FRONT AND REAR LAMPS
1 Low-beam Head Lamp
2 High-beam Head Lamp
3 Turn Signal Lamp
4 Position Lamp5 Back-up Lamp
6 Tail / Stop Lamp
7 Turn Signal Lamp
8 Tail / Stop Lamp
MAINTENANCE AND REPAIR
ON-VEHICLE SERVICE

SECTION 9D
WIPERS/WASHER SYSTEM
Caution: Disconnect the negative battery cable before removing or installing any electrical unit or when a
tool or equipment could easily come in contact with exposed electrical terminals. Disconnecting this cable
will help prevent personal injury and damage to the vehicle. The ignition must also be in LOCK unless otherwise
noted.
TABLE OF CONTENTS
Schematic and Routing Diagrams . . . . . . . . 9D-2
Rear Wiper and Washer . . . . . . . . . . . . . . . . . 9D-2
Maintenance and Repair . . . . . . . . . . . . . . . 9D-3
On-Vehicle Service . . . . . . . . . . . . . . . . . . . . . . 9D-3
Front Wiper and Washer . . . . . . . . . . . . . . . . 9D-3
Rear Wiper and Washer . . . . . . . . . . . . . . . . . 9D-5

WIPERS/WASHER SYATEM 9D-3
FRONT WIPER AND WASHER
1 Windshield Linkage
2 Wiper Arm
3 Wiper Blade (Left)
4 Wiper Blade (Right)
5 Washer Nozzle
6 Reservoir Tank Guide
7 Reservoir Tank8 Washer Hose
9 Cap
10 Washer Motor
11 Hose Connector (Y- type)
12 Washer Hose (Left)
1 3 Nozzle Pipe
14 Washer Hose
MAINTENANCE AND REPAIR
ON VEHICLE SERVICE

SECTION 9E
INSTRUMENTATION/DRIVER INFORMATION
Caution: Disconnect the negative battery cable before removing or installing any electrical unit or when a
tool or equipment could easily come in contact with exposed electrical terminals. Disconnecting this cable
will help prevent personal injury and damage to the vehicle. The ignition must also be in LOCK unless otherwise
noted.
TABLE OF CONTENTS
Schematic and Routing Diagrams . . . . . . . . 9E-2
Cluster . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9E-2
Component Locator . . . . . . . . . . . . . . . . . . . 9E-3
Combination Meter . . . . . . . . . . . . . . . . . . . . . 9E-3
Maintenance and Repair . . . . . . . . . . . . . . . 9E-4
On-Vehicle Service . . . . . . . . . . . . . . . . . . . . . . 9E-4
Combination Meter . . . . . . . . . . . . . . . . . . . . . 9E-4

9E-4 INSTRUMENTATION/DRIVER INFORMATION
COMBINATION METER
Diesel
1. Speedometer(km/h)
2. Tachometer
Revolution
Tolerance
1000
+137
-632000
3000
+261
-394000
+298
-25000
- +199
-51
Gasolin
1 Windshield Linkage
Speed
Tolerance
40
+3
+060 80
+5
+0100
+5
+0140
+5.5
+0.5160
+5.5
+0.5180
- +4
+0120
+5.5
+0.5
Speed
Tolerance
20
+4
+040 60
+4
+080
+5
+0120
+5.5
+0140
+5.5
+0.5160
+5.5
+0.5 +3
+0100
+5
+0
Speed
Tolerance
180
+6
+1200 240
- +6
+1
-
MAINTENANCE AND REPAIR
ON VEHICLE SERVICE

SECTION 9H
SEATS
Caution: Disconnect the negative battery cable before removing or installing any electrical unit or when a
tool or equipment could easily come in contact with exposed electrical terminals. Disconnecting this cable
will help prevent personal injury and damage to the vehicle. The ignition must also be in LOCK unless otherwise
noted.
TABLE OF CONTENTS
Specifications . . . . . . . . . . . . . . . . . . . . . . . . 9H-1
General Specifications . . . . . . . . . . . . . . . . . . 9H-1
Diagnosis . . . . . . . . . . . . . . . . . . . . . . . . . . . 9H-2
Schematic and Routing Diagrams . . . . . . . . 9H-3
Power Seat . . . . . . . . . . . . . . . . . . . . . . . . . . . 9H-3
Seat Warmer . . . . . . . . . . . . . . . . . . . . . . . . . . 9H-4Seat Belt & Tension Reducer Circuit . . . . . . . . 9H-5
Component Locator . . . . . . . . . . . . . . . . . . . 9H-6
Front Seat & Rear Seat . . . . . . . . . . . . . . . . . 9H-6
Maintenance and Repair . . . . . . . . . . . . . . . 9H-7
On-Vehicle Service . . . . . . . . . . . . . . . . . . . . . 9H-7
SPECIFICATIONS
GENERAL SPECIFICATIONS
Slide
Tilt
Height
Tilt and Height(up)
Slide
Slide
Tilt and Height
Load Rating
Operating Temperature Range
Switch Operating Force Application
Deseription
DC11 - 15V
-30°C - 80°C
20 ± 7mm/sec
10.6 ± 5mm/sec
7 ± 2mm/sec
Tilt:35 ± 2mm, Height:35 ± 2mm
Forward:230mm
Less Then 7A
Less Then 7A
DC12V 1A
-30°C - 80°C
0.3 - 0.7Kgf Operating Voltage
Operating Temperature Range
Seat Operating Speed(at 13.5V)
Seat Operating Distance
Operating Current(at 13.5V)
Seat Heater Switch