1998 Lexus LS400 lexus LS400 1998 Engine / LEXUS 1998 LS400 OWNER'S MANUAL (OM50498U)

SECTION 3 1
154
STARTING AND DRIVING
Starting and driving
Threeway catalytic converter 155. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Engine exhaust caution 156. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Before starting the engine 157. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Ignition switch with steering lock 157. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Parking brake 158. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
How to start the engine 159. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Automatic transmission 160. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Electronic throttle control system 167. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Cruise control 168. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Electronically modulated air suspension 171. . . . . . . . . . . . . . . . . . . . . . .
Traction control system 173. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Vehicle skid control system 174. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Brake system 176. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Types of tires 179. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

STARTING AND DRIVING
155
THREEWAY CATALYTIC
CONVERTER
31L0022
Threeway catalytic converters are emission control devices
installed in the exhaust system.
It looks somewhat like a muffler, but its purpose is to reduce
pollutants in the exhaust gas.
CAUTION
Keep people and combustible materials away from the
exhaust pipe while the engine is running. The exhaust gas
is very hot.
Do not drive, idle or park your vehicle over anything that
might burn easily such as grass, leaves, paper or rags.
NOTICE
A large amount of unburned gases flowing into the threeway
catalytic converter may cause it to overheat and create a fire
hazard. To prevent this and other damage, observe the following
precautions:
Use only unleaded gasoline.
Do not drive with an extremely low fuel level; running out of
fuel could cause the engine to misfire, creating an excessive
load on the threeway catalytic converter.
Do not allow the engine to run at idle speed for more than 20
minutes.
Avoid racing the engine.
Do not pushstart or pullstart your vehicle.
Do not turn off the ignition while the vehicle is moving.
Keep your engine in good running order. Malfunctions in the
engine electrical system, electronic ignition
system/distributor ignition system or fuel system could cause
an extremely high threeway catalytic converter
temperature.
If the engine becomes difficult to start or stalls frequently,
take your vehicle in for a checkup as soon as possible.
Remember, your Lexus dealer knows your vehicle and its
threeway catalytic converter system best.

STARTING AND DRIVING
156To ensure that the threeway catalytic converter and the
entire emission control system operate properly, your vehicle
must receive the periodic inspections required by the Lexus
Maintenance Schedule. For scheduled maintenance
information, refer to the separate ”Owner’s Manual
Supplement/ Maintenance Schedule”.
ENGINE EXHAUST CAUTION
CAUTION
Avoid inhaling the engine exhaust. It contains carbon
monoxide, which is a colorless and odorless gas. It can
cause unconsciousness or even death.
Make sure the exhaust system has no holes or loose
connections. The system should be checked from time to
time. If you hit something, or notice a change in the sound
of the exhaust, have the system checked immediately.
Do not run the engine in a garage or enclosed area except
for the time needed to drive the vehicle in or out. The
exhaust gases cannot escape, making this a particularly
dangerous situation.
Do not remain for a long time in a parked vehicle with the
engine running. If it is unavoidable, however, do so only in
an unconfined area and adjust the heating or cooling
system to force outside air into the vehicle.
Keep the trunk lid closed while driving. An open or
unsealed trunk lid may cause exhaust gases to be drawn
into the vehicle. If you must drive with the trunk lid open
to accommodate a large object, close the windows, open all
the dashboard vents and have the heating or cooling system
deliver fresh air into the vehicle by turning the fan to high
speed with the air intake control button in the OUTSIDE
AIR mode.
To allow proper operation of your vehicle’s ventilation
system, keep the inlet grilles in front of the windshield clear
of snow, leaves, or other obstructions.
If you smell exhaust fumes in the vehicle, drive with the
windows open and the trunk lid closed. Have the cause
immediately located and corrected.

STARTING AND DRIVING
157
BEFORE STARTING THE ENGINE
1. Check the area around the vehicle before entering it.
2. Adjust seat position, seatback angle, head restraint height and
steering wheel angle.
3. Adjust inside and outside rear view mirrors.
4. Lock all doors.
5. Fasten seat belts.
Remember to check that the service reminder indicators function
when turning the key to ”ON”, and check the fuel gauge to see that
you have sufficient fuel.
IGNITION SWITCH WITH
STEERING LOCK
31L0011
”START” Starter motor on. The key will return to the ”ON”
position when released.
For starting tips, see page 159.
”ON” Engine on and all accessories on.
This is the normal driving position.
NOTICE
Do not leave the key in the ”ON” position if the engine is not
running. The battery will discharge and the electronic ignition
system/distributor ignition system could be damaged.
”ACC” Accessories such as the radio operate, but the engine
is off.
If you leave the key in the ”ACC” or ”LOCK” position and open the

STARTING AND DRIVING
158driver’s door, a buzzer will remind you to remove the key.*
NOTE: *The volume or interval of beep sound can be changed.
Ask your Lexus dealer for details.
31L0031
”LOCK” Engine is off and the steering wheel is locked. The
ignition key can be removed only at this position.
To turn the key from ”ACC” to the ”LOCK” position, you must put
the transmission selector lever in the ”P” position.
Once you remove the key, the engine immobiliser system is
automatically set. See ”Engine immobiliser system” on page 10.
When starting the engine, the key may seem stuck at the ”LOCK”
position. To free it, first be sure the key is pushed all the way in, and
then rock the steering wheel slightly while turning the key gently.
If, in an emergency, you must turn the engine off while the vehicle
is moving, turn the key only to ”ACC”.
PARKING BRAKE
31L005
1
To set: Fully depress the parking brake pedal.
2
To release: Pull the parking brake release lever.
Before leaving your vehicle, firmly apply the parking brake.
CAUTION
Before driving, make sure the parking brake is fully released
and that the parking brake reminder light is off.

STARTING AND DRIVING
159
HOW TO START THE ENGINE
Before cranking
1. Apply the parking brake firmly.
2. Turn off unnecessary lights and accessories.
3. Put the selector lever in ”P”. If you need to restart the engine
while the vehicle is moving, put the selector lever in ”N”. A starter
safety device will prevent the starter from operating if the selector
lever is in any drive position.
4. Depress the brake pedal and hold it to the floor until you are ready
to drive off.
Starting the engine
Before starting the engine, be sure to follow the instructions in
”Before cranking”.
Normal starting procedure
The multiport fuel injection system/sequential multiport fuel
injection system in your engine automatically controls the proper
airfuel mixture for starting. You can start a cold or hot engine as
follows:
1. With your foot off the accelerator pedal, crank the engine by
turning the key to ”START”. Release it when the engine starts.
2. After the engine runs for about 10 seconds, you are ready to drive.If the weather is below freezing, let the engine warm up for a few
minutes before driving. Do not leave the vehicle while the engine
is warming up.
If the engine stalls ...
Simply restart it , using the correct procedure given in normal
starting.
If the engine will not start
See ”If your vehicle will not start” on page 193.
NOTICE
Do not crank for more than 30 seconds at a time. This may
overheat the starter and wiring systems.
Do not race a cold engine.
If the engine becomes difficult to start or stalls frequently,
have the engine checked immediately.

STARTING AND DRIVING
160
AUTOMATIC TRANSMISSION
Your automatic transmission has a shift lock system to minimize
the possibility of incorrect operation. This means you can only
shift out of ”P” position when the brake pedal is depressed with
the ignition switch in ”ON” position. ()
31L078
The shift position is displayed on the instrument cluster.P:Parking, engine starting and key removal position
R:Reverse position
N:Neutral position
D:Normal driving position (Shifting into overdrive possible)
4:Position for engine braking (Shifting into overdrive not
possible)
When the cruise control is being used, even if you downshift
from ”D” to ”4”, engine braking will not be applied because
the cruise control is not cancelled. For the operation to
decrease the vehicle speed, see page 170.
3, 2:Position for more powerful engine braking
L:Position for maximum engine braking

STARTING AND DRIVING
161 Correct use of the automatic transmission is explained in the
following parts.
(a) Normal driving
(b) Using engine braking
(c) Using the ”3”, ”2” and ”L” positions
(d) Backing up
(e) Parking
(f) Good driving practice
(g) Rocking your vehicle if stuck
(h) If you cannot shift the selector lever
(i) If the ”ECT PWR” indicator light flashes
(a) Normal driving
31L0072
1
”P” (Park) position 2
”N” (Neutral) position
1. Start the engine as instructed in ”How to start the engine” on
page 159.
The transmission must be in ”P” or ”N”. The engine will not start
in any drive position even if the ignition key is turned to ”START”.