1998 Lexus LS400 lock

AIR CONDITIONING AND AUDIO
128
(b) Windshield defogging and defrosting
21L009-3
To remove interior fog on the windshield
Push the”FRONT WINDSHIELD” button.
To remove frost or exterior fog on the windshield
1. Place the temperature control button at the maximum
temperature.
2. Push the ”FRONT WINDSHIELD” button.
3. Push the fan speed control button on the right side to obtain a
maximum air flow.
4. Leave the air conditioning onoff button off.When the ”FRONT WINDSHIELD” button is pushed while
operating in automatic mode, the air conditioning is set to operate
and the OUTSIDE AIR mode is set.
If you push the ”FRONT WINDSHIELD” button once again while
in the FRONT WINDSHIELD mode, the mode then returns to the
last mode used.
CAUTION
Do not use the ”FRONT WINDSHIELD” button during
cooled air operation in extremely humid weather. The
difference between the temperature of the outside air and that
of the windshield could cause the outer surface of the
windshield to fog up blocking your vision.
When you turn the ignition switch on after the removal and
installation of the battery terminal, the indicator light may flash and
the operating sound of the motor may be heard. This does not
indicate a malfunction.
You may hear the operating sound of the motor about 70 seconds
after the ignition switch is turned off. This is not also a malfunction.

AIR CONDITIONING AND AUDIO
130
(d) Operating tips
Make sure the air inlet grilles in front of the windshield are not
blocked by leaves or other obstructions.
If air flow control is not satisfactory, check the dashboard vents.
(See ”Center vents”, ”Side vents”, ”Lower vent” and ”Rear
vents”.)
To help cool down the interior after parking in the hot sun, drive
for the first few minutes with the windows open. After the excess
heat has blown away, close the windows.
When driving on dusty roads, close all windows. If dust thrown
up by the vehicle is still drawn into the vehicle after closing the
windows, it is recommended that the air intake control button be
left to the OUTSIDE AIR mode and the fan speed control button
be pressed to anywhere except the ”OFF” button.
If following another vehicle on a dusty road, or driving in windy
and dusty conditions, it is recommended that the air intake control
button be temporarily pressed in to the RECIRCULATED AIR
mode, which will close off the outside passage and prevent
outside air and dust from entering the vehicle interior.
Center vents
21L0121
The center vents may be opened or closed as shown.
Side vents
21L013
The side vents may be opened or closed as shown.

AIR CONDITIONING AND AUDIO
143 Push this button on the lower side to skip backward. Push the button
until ”REW” and the number you want to skip appear on the display.
If you set ”REW 1”, the player will rewind to the beginning of
the current program.
When counting the number of programs you want to rewind,
remember to count the current program as well. For example, if
you want to rewind to a song that is two before the song you are
listening to, push this button until ”REW 3” appears on the
display.
When the beginning of the tape is reached, the player automatically
resumes normal play.
There must be at least 5 seconds of blank space between programs
for this feature to work correctly.
”RPT”, ”SKIP” or ”Automatic program selection” features:
These features may not work well with some spoken word, live or
classical recordings.
Compact disc player operation
The compact disc player is an optional accessory that your vehicle
is prewired to accept. Although your audio system has a CD button,
your vehicle may or may not be equipped with a CD player. Please
contact your dealer for additional details if you would like to have
the optional CD player installed.
(a) Inserting compact discs
20L019-2
1. Push the lock release button and open the cover.

AIR CONDITIONING AND AUDIO
144
20L020-1
2. Push this button to eject the magazine.
20L021
3. Pull out the tray while pushing the lock release button.
20L022
4. Put a disc on the tray with its label face down and push the
tray back into the magazine.
If the label faces up, the disc cannot be played. In this case, ”Err”
and the disc number appears on the display.
20L023-1
5. Insert the magazine into the player as indicated by the arrow
head on the magazine and close the cover.

AIR CONDITIONING AND AUDIO
149 Radio reception
Usually, the problem with radio reception does not mean there is a
problem with your radio it is just the normal result of conditions
outside the vehicle.
For example, nearby buildings and terrain can interfere with FM
reception. Power lines or telephone wires can interfere with AM
signals. And of course, radio signals have a limited range, and the
farther you are from a station, the weaker its signal will be. In
addition, reception conditions change constantly as your vehicle
moves.
Here are some common reception problems that probably do not
indicate a problem with your radio:
FM
Fading and drifting stations Generally, the effective range of FM
is about 40 km (25 miles). Once outside this range, you may notice
fading and drifting, which increase with the distance from the radio
transmitter. They are often accompanied by distortion.
Multipath FM signals are reflective, making it possible for two
signals to reach your antenna at the same time. If this happens, the
signals will cancel each other out, causing a momentary flutter or
loss of reception.
Static and fluttering These occur when signals are blocked by
buildings, trees, or other large objects. Increasing the bass level may
reduce static and fluttering.Station swapping If the FM signal you are listening to is
interrupted or weakened, and there is another strong station nearby
on the FM band, your radio may tune in the second station until the
original signal can be picked up again.
AM
Fading AM broadcasts are reflected by the upper atmosphere
especially at night. These reflected signals can interfere with those
received directly from the radio station, causing the radio station to
sound alternately strong and weak.
Station interference When a reflected signal and a signal received
directly from a radio station are very nearly the same frequency, they
can interfere with each other, making it difficult to hear the
broadcast.
Static AM is easily affected by external sources of electrical noise,
such as high tension power lines, lightening, or electrical motors.
This results in static.
Caring for your cassette player and tapes
For high performance from your cassette player and tapes:
Clean the tape head and other parts regularly.
A dirty tape head or tape path can decrease sound quality and
tangle your cassette tapes. The easiest way to clean them is by
using a cleaning tape. (A wet type is recommended.)

SECTION 3 1
154
STARTING AND DRIVING
Starting and driving
Threeway catalytic converter 155. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Engine exhaust caution 156. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Before starting the engine 157. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Ignition switch with steering lock 157. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Parking brake 158. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
How to start the engine 159. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Automatic transmission 160. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Electronic throttle control system 167. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Cruise control 168. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Electronically modulated air suspension 171. . . . . . . . . . . . . . . . . . . . . . .
Traction control system 173. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Vehicle skid control system 174. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Brake system 176. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Types of tires 179. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

STARTING AND DRIVING
157
BEFORE STARTING THE ENGINE
1. Check the area around the vehicle before entering it.
2. Adjust seat position, seatback angle, head restraint height and
steering wheel angle.
3. Adjust inside and outside rear view mirrors.
4. Lock all doors.
5. Fasten seat belts.
Remember to check that the service reminder indicators function
when turning the key to ”ON”, and check the fuel gauge to see that
you have sufficient fuel.
IGNITION SWITCH WITH
STEERING LOCK
31L0011
”START” Starter motor on. The key will return to the ”ON”
position when released.
For starting tips, see page 159.
”ON” Engine on and all accessories on.
This is the normal driving position.
NOTICE
Do not leave the key in the ”ON” position if the engine is not
running. The battery will discharge and the electronic ignition
system/distributor ignition system could be damaged.
”ACC” Accessories such as the radio operate, but the engine
is off.
If you leave the key in the ”ACC” or ”LOCK” position and open the

STARTING AND DRIVING
158driver’s door, a buzzer will remind you to remove the key.*
NOTE: *The volume or interval of beep sound can be changed.
Ask your Lexus dealer for details.
31L0031
”LOCK” Engine is off and the steering wheel is locked. The
ignition key can be removed only at this position.
To turn the key from ”ACC” to the ”LOCK” position, you must put
the transmission selector lever in the ”P” position.
Once you remove the key, the engine immobiliser system is
automatically set. See ”Engine immobiliser system” on page 10.
When starting the engine, the key may seem stuck at the ”LOCK”
position. To free it, first be sure the key is pushed all the way in, and
then rock the steering wheel slightly while turning the key gently.
If, in an emergency, you must turn the engine off while the vehicle
is moving, turn the key only to ”ACC”.
PARKING BRAKE
31L005
1
To set: Fully depress the parking brake pedal.
2
To release: Pull the parking brake release lever.
Before leaving your vehicle, firmly apply the parking brake.
CAUTION
Before driving, make sure the parking brake is fully released
and that the parking brake reminder light is off.