1998 ISUZU TROOPER roof rack

1B Ð 52 AIR CONDITIONING
REAR COOLER PARTS (ROOF DUCT TYPE)
16
15
14
2
3
4
5
7
6 1
13
11
12
10
9
8
Legend
(1) Roof Duct Bracket
(2) Roof Duct
(3) Lower Duct
(4) Resistor
(5) Wire Harness
(6) Liquid Line (high pressure pipe)
(7) Suction Line (low pressure pipe)
(8) Drain Hose(9) Cover Assembly
(10) Filter
(11) Cooling Unit
(12) Grille Assembly
(13) Panel
(14) Knob
(15) Nut
(16) Fan Control Switch
855RY00001

8F±91 BODY STRUCTURE
5. Remove rear view mirror.

Remove the rubber stopper (1).

Pry off the mirror stay cover (2) and remove 3
screws.
720RW004
6. Remove map light/sun roof switch.

Pry the map light clip free from the map light/sun
roof switch bracket and disconnect the connector.
805RS001
7. Remove sunvisors.

Remove the fixing screw and turn the sunvisor
holder (1) to remove it.

Disconnect the vanity mirror illumination connector.
743RW008
8. Remove sun roof finisher (W/Sun roof).
9. Remove headlining.

Remove the headlining fixing clips.
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Install the headlining so that the fixing clips will not
come off.
2. To install the sun roof finisher (3), first fit in at one
place with the head lining (2) close to the sun roof
frame complete (1), then install the entire finisher
tightly by hitting it with a plastic hammer, not allowing
it to move up.
665RS001

8J±14EXTERIOR/INTERIOR TRIM
Luggage Side and Quarter Upper Trim Cover (Long Wheel Base)
Luggage Side, Quarter Upper Trim Cover and Associated Parts
760RW017
Legend
(1) Assist Grip
(2) Rear Seat Belt Anchor Bolt Cover and Anchor
Bolt
(3) Quarter Upper Trim Cover
(4) Anchor Bolt
(5) Luggage Side Trim Cover
(6) Luggage Side Lower Cover
(7) Third Seat Assembly and seat Bracket(8) Third Seat Belt Anchor Bolt Cover and Anchor
Bolt
(9) Rear End Floor Trim Cover
(10) Luggage Side Cap
(11) Speaker Grille
(12) Rear Speaker
(13) Luggage Room Light
(14) Rear Roof Trim Cover
Removal
1. Disconnect the battery ground cable.
2. Remove the third seat assembly and seat bracket.
3. Remove the rear end floor trim cover.
4. Remove the luggage side cap.

9AÐ2 SEAT BELT SYSTEM
Legend
(1) Center Pillar Upper Trim Cover
(2) Adjust Shoulder Anchor Assembly/Seat Belt
Anchor Plate
(3) Center Pillar
(4) Dust Cover
(5) Retractor(6) Anchor Bolt (Lower)
(7) Door Sill Plate (Front & Rear)
(8) Center Pillar Lower Trim Cover
(9) Front Seat Belt Assembly
(10) Front Seat Belt Anchor Bolt Cover and Anchor
Bolt
Seat Belt
Front Seat Belt and Associated Parts (Long Wheel Base)
73
4
5
6 1
2
10
8
9
760RW022
Removal
1. Disconnect the battery ground cable.
2. Remove the door sill plate (Front & Rear).
3. Remove the center pillar lower trim cover.
4. Remove the front seat belt anchor bolt cover and
anchor bolt (Upper Side).
cRefer to Center Pillar and Roof Side Trim Cover in
Exterior/Interior Trim section.
5. Remove the seat belt lower anchor bolt and screw,
and then remove the front seat belt.
6. Remove the adjust shoulder anchor assembly/seat
belt anchor plate.
cRefer to Center Pillar and Roof Side Trim Cover in
Exterior/Interior Trim section.
Inspection
If any of the following abnormalities is found, replace on
an assembly basis;
cDeform and malfunction of adjustable shoulder
anchor/seat belt anchor plate.
cNo smooth move of upper/lower anchors in the
circumferential direction.
cDamaged and/or deformed through ring.
cDamaged and/or deformed tongue.
cDamaged and/or frayed of webbing.
cDeformed retractor bracket.
cSeat belt not rewound up.
cResistance or abnormal sound when seat belt is
wound out and rewound.
cRetractor abnormality.