When the engine compartment is cool, wipe the cap and
the top
of the reservoir clean, then unscrew the cap and
wipe the dipstick with a clean rag. Replace the cap and
completely tighten it. Then remove the cap again and
Book at the fluid level on the dipstick.
The level should
be at the FTLL COLD mark. If
necessary, add Q~Y enough fluid to bring the level up
to the mark.
at to use
To determine what kind of fluid to use, see
“Recommended Fluids
and Lubricants” in the Index.
Always use the proper fluid. Failure
to use the proper
fluid
can cause leaks and damage hoses and seals.
What to use
When you need windshield washer fluid, be sure to read
the manufacturer’s instructions before use.
If you will be
operating
your vehicle in an area where the temperature
may
fall below keezing, use a fluid that has suffkient
protection against freezing.
The windshield washer fluid reservoir is located by
the coolant recovery tank on the driver’s side of the
engine compartment.
Open
the cap labeled WASHER ONLX Add
washer
fluid until the tank is full.
ProCarManuals.com
