AUTOMATIC TRANSMISSION 5A-191
SSANGYONG MY2002
24. Install the pump and cover assembly over the
input shaft being careful not to damage the sealing
rings. Apply additional Loctite 202 or equivalent
as required to the pump cover to case bolts.
Install and tighten bolts to specification.
Installation Notice
KAA5A1M0
Tightening Torque24 - 34 Nm
(18 - 25 lb-ft)
25. Check that the transmission end float is 0.50 -
0.65 mm. If the unshimmed end float clearance is
greater than specification, shims are to be placed
between the No. 4 bearing and the input shaft
bearing surface. If the end float clearance is less
than 0.5 mm then the transmission has been
assembled incorrectly or the parts are out of
specification.
26. Perform the following steps to check the end float :
a. Attach a dial indicator to the front of the trans-
mission case with the stylus resting on the end
of the input shaft.
b. Apply a force of approximately 250 N or 25 kg
to the input shaft.
c. Zero the dial indicator.
d. Place a small lever behind the forward clutch
cylinder and lever the cylinder forward.
e. The measurement recorded on the dial indicator
is the transmission end float or clearance be-
tween the No. 4 bearing and the converter sup-
port tube.
27. On completion of this procedure, adjust the front
and rear bands to specifications. Refer to “Front
and Rear Band Adjustment” in this section.
KAA5A1N0
AUTOMATIC TRANSMISSION 5A-211
SSANGYONG MY2002
KAA5A2S0
0555 - 336263
Cross Shaft Bullet
SPECIAL TOOLS AND EQUIPMENT
SPECIAL TOOLS TABLE
0555 - 336256
Transmission Bench
Cradle
0555 - 336260
Clutch Pack Clearance
Kit
0555 - 336262
Cross Shaft Seal
Installer0555 - 336257
Pump Puller
0555 - 336259
Clutch Spring
Compressor
0555 - 336261
Cross Shaft Seal
Remover
ss Shaft Pin
emover / Instal
er (Dentent Lever)
KAA5A2P0
KAA5A2R0
KAA5A2T0
KAA5A2V0KAA5A2W0KAA5A2U0 KAA5A2Q0
