1997 Oldsmobile Achieva oil dipstick

Check Oil Light (If Equipped) Passlock Warning Light
CHECK
OIL
If you have a 3 100 engine,
this light should come on
briefly when you start the
engine.
If the light doesn’t
come on, have it repaired.
If the light comes on and
stays on after starting your
vehicle, your engine oil
level should be checked. SECURITY
This light will come on
briefly when you turn the
key toward the START
position. The light will stay
on until the engine starts.
Prior to checking the oil level, be sure your vehicle has
been shut off for several minutes and is on a level
surface. Check the oil level on your dipstick and bring it
to the proper level. See “Engine Oil” in the Index.
NOTE:
A false CHECK OIL light may be generated
when parking on steep grades.
The
oil level monitoring system only checks oil level
during the brief period between key on and engine
crank. It does not monitor engine oil level when the
engine is running. Additionally, an oil level check is
only performed if the engine has been turned off for a
considerable period of time allowing the oil normally in
circulation to drain back into the oil pan.
If the light flashes, the Passlock system has entered a
tamper mode,
If the vehicle fails to start, see “Passlock”
in the Index.
If the light comes on continuously while driving and
stays on, there may be a problem with the Passlock
system. Your vehicle will not be protected by Passlock,
and you should see your retailer.
2-70

2.4L (CODE T) Engine
When you open the hnnd, you’ll see:
A. Engine Coolant Surge Tank
E. Power Steering Fluid Reservoir H. Hydraulic Clutch Fluid
B. Engine Oil Fill Cap F. Brake Fluid Reservoir
Reservoir (if equipped)
C. Engine Oil Dipstick
G. Windshield Washer Fluid I. Air Cleaner
D. Automatic Transaxle Dipstick
Reservoir J. Battery
(if equipped)

3100 (CODE M) Engine
When you open the hood, you'll see:
A. Engine Coolant Surge Tank
B. Power Steering Fluid Reservoir
C. Engine
Oil Fill Cap
D. Engine Oil Dipstick E.
Automatic I'ransaxle Dipstick
F. Brake Fluid Reservoir
G. Windshield Washer Fluid
Reservoir
H. Air Cleaner
I. Battery
6-11

Checking Engine Oil
Pull out the dipstick and clean it with a paper towel or
cloth, then push it back in all the way. Remove
it again,
keeping the tip down, and check the level.
I
3100 Engine
The engine oil dipstick handle is yellow. The dipstick
handle for the
2.4L engine is located behind the engine.
The dipstick for the
3100 engine is located in front of
the engine, behind the fan.
Turn
off the engine and give the oil a few minutes to
drain back into the oil pan.
If you don’t, the oil dipstick
might not show the actual level.
6-13

What Kind of Oil to Us
3100 Engine
The 2.4L engine oil fill cap is located on the passenger’s
side
of the engine. The 3100 engine oil fill cap is located
in front
of the engine, behind the fan.
Just fill it enough to put the level somewhere
in the
proper operating range. Push
the dipstick all the way
back in when you’re through. Oils recommended
for your vehicle can be identified by
looking for the “Starburst” symbol. This symbol
indicates that the oil has been certified by the American
Petroleum Institute (API).
Do not use any oil which
does not carry this Starburst symbol.
If you change your own oil,
be sure you use
oil that has
the Starburst symbol on the
front of the oil container. If
you have your oil changed
for
you, be sure the oil put
into your engine
is
American Petroleum
Institute certified for
gasoline enrzines.
I ”
You should also use the proper viscosity oil for your
vehicle, as shown in the following chart:
6-15

Automatic Transaxle Fluid
When to Check and Change
A good time to check your automatic transaxle fluid
level is when the engine oil is changed.
Change both the fluid and filter every
50,000 miles
(83 000 km) if the vehicle is mainly driven under one or
more
of these conditions:
0 In heavy city traffic where the outside temperature
regularly reaches
90°F (32°C) or higher.
0 In hilly or mountainous terrain.
0 When doing frequent trailer towing.
Uses such as found in taxi, police or delivery service.
If you do not use your vehicle under any of these
conditions, the fluid and filter do not require changing.
See “Scheduled Maintenance Services”
in the Index.
How to Check
Because this operation can be a little difficult, you may
choose
to have this done at your Oldsmobile retail
facility Service Department.
If you do it yourself, be sure to follow all the instructions
here, or you could get a false reading
on the dipstick.
I NOTICE:
Too much or too little fluid can damage your
transaxle.
Too much can mean that some of the
fluid could come out and fall on hot engine parts
or exhaust system parts, starting a fire.
Be sure to
get an accurate reading if
you check your
transaxle fluid.
Wait at least 30 minutes before checking the transaxle
fluid level if you have been driving:
0 When outside temperatures are above 90°F (32°C).
0 At high speed for quite a while.
In heavy traffic -- especially in hot weather.
0 While pulling a trailer.
6-19

Manual Transaxle Fluid
When to Check
A good time to have it checked is when the engine oil is
changed. However, the fluid in your manual transaxle
doesn’t require changing.
How to Check
Because this operation can be a little difficult, you may
choose
to have this done at your Oldsmobile retail
facility Service Department.
E you do it yourself, be sure to follow all the instructions
here, or you could get a false reading on the dipstick.
I NOTICE:
Too much or too little fluid can damage your
transaxle.
Too much can mean that some of the
fluid could come out and fall
on hot engine parts
or exhaust system parts, starting a fire. Be sure to
get an accurate reading if you check your
transaxle fluid.
Check the fluid level only when your engine is off, the
vehicle is parked
on a level place and the transaxle is cool
enough for you to rest your fingers on the
transaxle case.
Then, follow these steps:
1. The manual transaxle dipstick handle is white and is
located behind the engine. Flip
the handle up and
then pull
out the dipstick and clean it with a rag or
paper towel.
2. Push it back in all the way and remove it.