1997 NISSAN MAXIMA tow

hitch when not in use. Remove the
receiver when not in use. After the
hitch is removed, seal the bolt holes
to prevent exhaust fumes, water or
dust from entering the passenger
compartment.
IRegularly check that all hitch mount-
ing bolts are securely mounted.
Tire pressures
IWhen towing a trailer, inflate the vehicle
tires to the recommended cold tire pressure
indicated on the tire placard (located on the
inside of the center console lid.)
ITrailer tire condition, size, load rating and
proper inflation pressure should be in ac-
cordance with the trailer and tire manufac-
turers' specifications.
Safety chain
Always use a suitable chain between your
vehicle and the trailer. The chain should be
crossed and should be attached to the hitch,
not to the vehicle bumper or axle. Be sure to
leave enough slack in the chain to permit
turning corners.
Trailer lights
Trailer lights should comply with Federal
and/or local regulations. When wiring the ve-
hicle for towing, connect the stop and tail light
pickup into the vehicle electrical circuit at a
point between the sensor and stop light or light
switch.
Trailer brakes
If your trailer is equipped with a braking sys-
tem, make sure it conforms to Federal and/or
local regulations and that it is properly in-
stalled.
Never connect a trailer brake system
directly to the vehicle brake system.
Pre-towing tips
IBe certain your vehicle maintains a level
position when a loaded and/or unloaded
trailer is hitched. Do not drive the vehicle if
it has an abnormal nose-up or nose-down
condition; check for improper tongue load,
overload, worn suspension or other pos-
sible causes of either condition.
IAlways secure items in the trailer to preventload shifts while driving.
IBe certain your rear view mirrors conform to
all federal, state or local regulations. If not,
install any mirrors required for towing be-
fore driving the vehicle.
Trailer towing tips
In order to gain skill and an understanding of
the vehicle's behavior, you should practice
turning, stopping and backing up in an area
which is free from traffic. Steering stability, and
braking performance will be somewhat differ-
ent than under normal driving conditions.
IAlways secure items in the trailer to prevent
load shift while driving.
IAvoid abrupt starts, acceleration or stops.
IAvoid sharp turns or lane changes.
IAlways drive your vehicle at a moderate
speed.
IAlways block the wheels on both vehicle
and trailer when parking. Parking on a
slope is not recommended; however, if you
must do so, and if your vehicle is equipped
with automatic transmission, first block the
wheels and apply the parking brake, and
then move the transmission shift lever into
the ªPº position. If you move the shift lever
to the ªPº position before blocking the
9-16
Z01.2.1/A32-DX

wheels and applying the parking brake,
transmission damage could occur.
IWhen going down a hill, shift into a lower
gear and use the engine braking effect.
When ascending a long grade, downshift
the transmission to a lower gear and reduce
speed to reduce chances of engine over-
loading and/or overheating.
IIf the engine coolant rises to an extremely
high temperature when the air conditioning
system is on, turn off the air conditioner.
Coolant heat can be additionally vented by
opening the windows, switching the fan
control to high and setting the temperature
control to the ªHOTº position.
ITrailer towing requires more fuel than nor-
mal circumstances.
IAvoid towing a trailer for the first 500 miles
(800 km).
IHave your vehicle serviced more often than
at intervals specified in the recommended
Maintenance Schedule.
IWhen making a turn, your trailer wheels will
be closer to the inside of the turn than your
vehicle wheels. To compensate for this,
make a larger than normal turning radius
during the turn.ICrosswinds and rough roads will adversely
affect vehicle/trailer handling, possibly
causing vehicle sway. When being passed
by larger vehicles, be prepared for possible
changes in crosswinds that could affect
vehicle handling. If swaying does occur,
firmly grip the steering wheel, steer straight
ahead, and immediately (but gradually) re-
duce vehicle speed. This combination will
help stabilize the vehicle. Never increase
speed.
IBe careful when passing other vehicles.
Passing while towing a trailer requires con-
siderably more distance than normal pass-
ing. Remember the length of the trailer
must also pass the other vehicle before you
can safely change lanes.
ITo maintain engine braking efficiency and
electrical charging performance, do not use
fifth gear (manual transmission) or over-
drive (automatic transmission).
IAvoid holding the brake pedal down too
long or too frequently. This could cause the
brakes to overheat, resulting in reduced
braking efficiency.
When towing a trailer, change oil in the
transmission more frequently.
See the Maintenance schedule.
9-17
Z01.2.1/A32-DX

S
Safety
Child safety rear door lock .......................... 2-3
Reporting safety defects (For U.S.A.) ....... 9-19
Seat adjustment .............................................. 2-12
Seat belt
2-point type without retractor .................... 2-29
3-point type seat belt with ......................... 2-26
Precautions on seat belt usage ................ 2-24
Seat belt extenders ................................... 2-30
Seat belt maintenance .............................. 2-31
Seat belts .................................................. 2-24
Seats ............................................................... 2-12
Spark plug replacement .................................. 7-15
Speedometer .................................................... 1-4
Starting
Before starting the engine ........................... 4-6
Jump starting ..................................... 5-7, 7-14
Precautions when starting and driving ........ 4-2
Push starting ............................................... 5-9
Starting the engine ...................................... 4-6
Steering
Power steering fluid................................... 7-11
Power steering system .............................. 4-17
Tilting steering wheel ................................ 2-38
Sunroof (If so equipped) ................................. 1-21
Supplemental air bag warning light ................ 2-22
Supplemental restraint system (Supplemental air
bag system) .................................................... 2-17
Switch
Front fog light switch (If so equipped) ...... 1-15
Hazard warning flasher switch .................. 1-16
Headlight and turn signal switch ............... 1-14Ignition switch .............................................. 4-4
Rear window and outside mirror defogger
switch......................................................... 1-13
Windshield wiper and washer switch ........ 1-12
T
Tachometer ....................................................... 1-4
Theft warning (If so equipped)........................ 1-10
Three way catalyst ............................................ 4-2
Tilting steering wheel ...................................... 2-38
Timing chain ..................................................... 9-8
Tire
Flat tire ........................................................ 5-2
Tire chains ................................................. 7-31
Tire placard ............................................... 9-12
Tire pressure ............................................. 7-30
Uniform tire quality grading ....................... 9-18
Wheels and tires ................................ 7-30, 9-9
Tow truck towing ............................................. 5-10
Towing
Tow truck towing ....................................... 5-10
Towing load/specification chart ................. 9-15
Trailer towing ............................................. 9-14
Trailer towing .................................................. 9-14
Transmission
Automatic transmission fluid ..................... 7-10
Driving with automatic transmission............ 4-7
Driving with manual transmission ............. 4-10
Trip odometer ................................................... 1-4
Trunk lid lock .................................................... 2-9
Trunk lid opener operation ............................... 2-6
Trunk light ....................................................... 1-23U
Uniform tire quality grading............................. 9-18
V
Vanity mirror light ............................................ 1-23
Vehicle identification ....................................... 9-10
Vehicle identification number (Chassis
number) ..................................................... 9-10
Vehicle identification number plate ........... 9-10
Vehicle loading information............................. 9-13
Vehicle recovery (Freeing a stuck
vehicle)............................................................ 5-12
Ventilator ........................................................... 3-2
W
Warning
Hazard warning flasher switch .................. 1-16
Supplemental air bag warning labels ........ 2-22
Supplemental air bag warning light........... 2-22
Theft warning (If so equipped) .................. 1-10
Warning/indicator light and buzzer.............. 1-6
Wheels and tires ..................................... 7-30, 9-9
Window washer fluid ....................................... 7-12
Windshield wiper and washer switch.............. 1-12
Wiper
Windshield wiper and washer switch ........ 1-12
Wiper blades ............................................. 7-18
10-4
Z01.2.1/A32-DX

Recommended fuel:
Unleaded premium gasoline with an octane
rating of at least 91 AKI (Anti-Knock Index)
number (Research octane number 96).
If unleaded premium gasoline is not avail-
able, unleaded regular gasoline with an
octane rating of at least 87 AKI (Research
octane number 91) can be used.
However, for maximum vehicle perfor-
mance, the use of unleaded premium gaso-
line is recommended.
Using a fuel other than that specified
could adversely affect the emission con-
trol devices and systems, and could
also affect the warranty coverage.
Under no circumstances should a
leaded gasoline be used, since this will
damage the three way catalyst.
For further details such as gasohol, see ªFuel
recommendationº in the ªTechnical and con-
sumer Informationº section.
Recommended engine oil
specifications:
IAPI SG or SH and Energy Conserving II
IAPI Certification Mark
ISAE 10W-30 viscosity oil is preferred for
ambient temperatures above 0ÉF (þ18ÉC).
See ªEngine oil and oil filter recommendationº
in the ªTechnical and consumer informationº
section.
Tire cold pressure:
See tire placard affixed to the center console
lid.
Recommended new vehicle
break-in procedure:
During the first 1,000 miles (1,600 km) of
vehicle use, follow the recommendations out-
lined in the ªBREAK-IN SCHEDULE Informa-
tion found in the ªStarting and drivingº section
of this Owner's Manual. Follow these recom-
mendations for the future reliability and
economy of your new vehicle. Failure to follow
these recommendations may result in vehicle
damage or shortened engine life.(page)
IIn case of emergency .......................... 5-1
(Flat tire, engine will not start,
overheating, towing)
IHow to start the engine ....................... 4-1
IMaintenance schedule......................... 8-1
IDo-it-yourself operations .................... 7-1
ITechnical and consumer
information ........................................... 9-1
GAS STATION INFORMATION QUICK REFERENCE
Z01.2.1/A32-DX