7
4.
Remedy the malfunctions indicated by th
diagnosis codes, disconnect the diagnosis code
check harness, and then reconnect the valve
relay harness. Then turn the ignition switch to ON
again to check the ABS warning lamp. (Refer to
P.35B-19.) If the lamp indicates a malfunction,
the valve relay system may be defective. (Refer
to P.35B-17)
ERASING DIAGNOSTIC CODES
With the MUT-II
Connect the MUT-II to the diagnosis connector (16-
pin), then erase the diagnostic codes.
Without the MUT-II
Removing the battery cable from the battery (-)
terminal for 10 seconds or more, then reconnect the
cable.
See next page.
ABS <2WD> - Troubleshooting35B-7
