CHASSIS ELECTRICAL ± Ignition Switch and Immobilizer System54-10
Immobilizer System
Caution
1. The ID code should always be re-registered when replacing the immobilizer-ECU.
vehicles>
2. If the immobilizer-ECU has been replaced, you will need to re-register the ignition key ID codes
and to reset the code for the fuel cut valve controller to the factory setting.
vehicles>
3. If the immobilizer-ECU has been replaced with a new part, the password (vehicle secret code)
which has been stored in the immobilizer-ECU for each vehicle will be replaced by the password
(secret code) specified by the customer.
STANDARD FLOW OF DIAGNOSIS TROUBLESHOOTING54300690024
Refer to GROUP 00 ± How To Use Troubleshooting/Inspection Service Points.
DIAGNOSIS FUNCTION54300700116
DIAGNOSIS CODES CHECK
Refer to GROUP 00 ± How To Use Troubleshooting/Inspection Service Points.
ERASING DIAGNOSIS CODES
Refer to GROUP 00 ± How To Use Troubleshooting/Inspection Service Points.
Caution
The diagnosis codes which result from disconnecting the battery cables cannot be erased.
INSPECTION CHART FOR DIAGNOSIS CODES
54300710027
Diagnosis code No.Inspection itemsReference
page
11Transponder communication system or radio interference of ID code54-11
12*ID code are not the same or are not registered54-11
21Communication system between MUT-II and engine-ECU54-12
31EEPROM abnormality inside immobilizer-ECU54-12
NOTE
*: Diagnosis code No. 12 is not recorded.
CHASSIS ELECTRICAL ± Radio and Tape Player54-73
B-8 Insufficient memory (preset stations are erased).
Is dedicated fuse No. 5 blown or is the circuit open?Ye sReplace fuse or repair harness.
No
Disconnect and check the connector at the rear of the radio.
Is the memory backup (battery) power being supplied?NoRepair harness.
Ye s
Repair or replace radio.
C. TAPE PLAYER
C-1 Cassette tape will not be inserted.
Are there any foreign objects in the tape player?Ye sRemove the object(s)*1
No*1
Attempting to force a foreign object (e.g., a coin or clip, etc.) out
of the tape player may damage the mechanism. The player should
be taken to a service dealer for repair.
Does the tape player work if another tape is inserted?Ye sReplace tape*2
No
Repair or replace tape player.
*2
Ensure that the tape label is not loose, that the tape itself is not
deformed and that the tape is tightly wound. Also, tape of C-120
or greater length often get caught in the mechanism and should
not be used.
C-2 No sound (even after a tape has been inserted).
Is dedicated fuse No. 4 blown or is the circuit open?Ye sReplace fuse or repair harness.
No
Is connector at rear of radio connected tightly?NoConnect connector firmly.
Ye s
Disconnect connector at rear of radio. Is ACC power being supplied
to the radio?Ye sRepair or replace tape player.
No
Repair harness.
