1997 LINCOLN MARK VIII lights

128The anti-theft system is designed to work with the
factory installed remote entry system. It may not
work with other remote entry systems.Disarming an Untriggered Anti-Theft
SystemYou can disarm the system by:q
unlocking a front door with the key (turn the
key all the way to the end of travel or the
system will not disarm).
q
using the keyless entry unlock code.
q
using the UNLOCK button of the remote entry
transmitter.
q
turning the ignition to ON or ACC.
If you armed the system while inside your vehicle,
you can disarm it by turning the ignition to the ON
or ACC position. This allows you to open the front
door and exit without triggering the system.
Triggering the Alarm SystemThe armed system will be triggered if:q
any door is opened without disarming the
system (see previous paragraphs), or
q
the hood is opened.
Disarming a Triggered SystemThe alarm can be disarmed by:q
unlocking a front door with the key
q
using the keyless entry unlock code
q
using the UNLOCK control on the remote entry
transmitter
NOTE:The flashing lights and honking horn will
shut off automatically approximately three minutes
after the system is triggered. It will trigger again if
another intrusion occurs. However, the engine will
not be allowed to start until the system is disarmed.
File:05fncf8.ex
Update:Thu Jun 27 10:02:20 1996

1663. Make sure that the gearshift is in P (Park) and
the parking brake is set before you turn the
key.
Before you start your vehicle, you should test the
warning lights on the instrument panel to make
sure that they work. Refer to theInstrumentation
chapter.Starting Your EngineTo start your engine:
1. Follow the steps underPreparing to Start Your
Vehicleat the beginning of this section.
2. Turn the ignition key to the ON position.
3. DO NOT depress the accelerator pedal when
starting your engine. DO NOT use the
accelerator while the vehicle is parked.
4. Turn the key to the START position (cranking)
until the engine starts. Allow the key to return
to the ON position after the engine has started.For a cold engine:
q
At temperatures10ÊF(-12ÊC) andbelow:If
the engine does not start infifteen (15)
secondson the first try, turn the key to OFF,
wait approximately ten (10) seconds so you do
not flood the engine, then try again.
q
At temperaturesabove10ÊF(-12ÊC):If the
engine does not start infive (5) secondson
the first try, turn the key to OFF, wait
approximately ten (10) seconds so you do not
flood the engine, then try again.
For a warm engine:
q
Do not hold the key in the START position for
more thanfive (5) secondsat a time. If the
engine does not start within five (5) seconds on
the first try, turn the key to the OFF position.
Wait a few seconds after the starter stops, then
try again.
File:08fnto8.ex
Update:Wed Jun 19 15:04:46 1996

253
How to Prepare Your Vehicle for
Inspection/Maintenance (I/M) TestingIn some localities it may become a legal
requirement to pass an Inspection/Maintenance
(I/M) test of the On-Board Diagnostic (OBD) II
system. If the vehicle's powertrain system or its
battery has just been serviced, the OBD II system is
reset to a not ready for I/M testing condition. To
prepare for I/M testing, the law specifies that
additional mixed city and highway driving is
required to complete the check of the OBD II
system.
The driving modes required to reach the ready
condition consist of a minimum of 30 minutes of
city and highway driving as described below:q
At least twenty minutes driving in stop and go,
city type traffic with at least four idle periods.
q
At least ten minutes of driving on an
expressway or highway.Before completing the above driving modes, the
engine must be warmed up and at operating
temperature. Once started, the vehicle must not be
turned off during these driving modes.
Lights and Bulb ReplacementIt is a good idea to check the operation of the
following lights frequently:q
headlamps
q
high-mount brakelamp
q
tail lamps
q
brakelamps
q
hazard flasher
q
turn signals
q
license plate lamps
File:11fnmc8.ex
Update:Thu Jun 20 14:28:32 1996

301
proper solution........... 235
recovery reservoir.......... 228
refill capacities............ 264
specifications............ 265
temperature gauge.......... 17
Engine coolant temperature gauge..... 17
Engine fan............... 217
Engine knocking............ 246
Engine oil............... 222
ªbreak-inº oils............. 5
changing oil and oil filter....... 224
checking and adding......... 223
check oil warning light........ 11
dipstick............... 223
disposal............... 216engine oil pressure warning light.... 11
filter, specifications.......... 263
refill capacities............ 264
specifications.........222, 265
synthetic oil............. 222
viscosity.............. 222
Exhaust fumes............. 169
Extended Service Plan, Ford........ 4
F
Fan.................. 217
engine fan, avoiding injury...... 217
Flashers, hazard............ 89
Flashing the lights........... 86
Flat tire................ 201
Fluid refill capacities.......... 264
Ford Dispute Settlement Board...... 272
Ford Extended Service Plan........ 4
Ford Motor Company of Canada..... 276
File:fnix8.ex
Update:Thu Jun 27 10:02:38 1996

303
G
Gas cap (see Fuel cap)......... 243
Gas mileage (see Fuel economy) . . . 25, 248
Gasoline (see Fuel)........... 243
Gauges
engine coolant temperature gauge . . . 17
fuel gauge.............. 19
odometer.............. 16
speedometer............. 16
tachometer............. 17
GAWR (Gross Axle Weight Rating)
calculating............. 183
definition.............. 182
driving with a heavy load....... 182
location............... 182Gearshift
automatic operation.......... 177
locking the gearshift......... 83
positions.............. 177
shifting the gears........... 177
GVWR (Gross Vehicle Weight Rating) . . . 182
calculating.............. 183
definition.............. 182
driving with a heavy load....... 182
location............... 182
H
Hazard flashers............. 89
Headlamps
aiming............... 256
autolamp system........... 80
checking alignment.......... 253
cleaning............... 261
daytime running lights........ 78
File:fnix8.ex
Update:Thu Jun 27 10:02:38 1996

304Headlamps (continued)
flashing............... 86
high beam............. 86
replacing bulbs........... 253
turning on and off.......... 79
warning chime............ 15
Head restraints............. 131
Heated seats.............. 135
Heating
electronic automatic temperature
control system........... 69
High beams
indicator light............ 14
operation.............. 86
Hitch................. 186
Hood................. 219
latch location............ 219
lubrication specifications....... 265
release lever............. 219
working under the hood....... 217
Horn................. 90
I
Idle, relearning..........212, 217
Ignition
chime............... 84
positions of the ignition........ 83
removing the key.......... 84
Indicator lights and chimes (see Lights) . . . 7
Infant seats (see Safety seats)....150, 151
Instrument panel............. 7
Interval wipers............. 86
J
Jack.................. 202
operation.............. 203
positioning............. 205
storage............... 202
Jump-starting your vehicle
attaching cables........... 211
disconnecting cables......... 212
File:fnix8.ex
Update:Thu Jun 27 10:02:38 1996

305
K
Keyless entry system
locking and unlocking doors...... 119
programming entry code....... 120
Keys
key in ignition chime......... 84
positions of the ignition........ 83
removing from the ignition...... 84
stuck in lock position......... 83
L
Lamps
autolamp delay system........ 80
checking.............. 253
daytime running light system..... 78
dome lamps............. 96
flashing the lamps.......... 86
hazard flashers............ 89
headlamps............. 79
high beams............. 86
interior lamps............ 78map lamps............. 96
replacing bulbs............ 253
trailer............... 187
Lane change indicator (see Turn signal) . . 85
Lap belts............... 143
Lights, warning and indicator
airbag............... 45
anti-lock brakes (ABS)......... 11
brake................ 10
charging system........... 13
check engine............ 45
engine oil pressure.......... 11
hazard warning light......... 89
high beam............. 14
overdrive off............. 46
safety belt.............. 44
turn signal indicator......... 14
File:fnix8.ex
Update:Thu Jun 27 10:02:38 1996

311
Tires................. 238
changing.............. 201
checking the pressure......... 238
cleaning.............. 262
inspection and maintenance...... 238
replacing.............. 240
rotating............... 239
snow tires and chains........ 242
spare tire.............. 202
storing your vehicle......... 268
tire grades............. 241
treadwear.............. 241
wear bands............. 240
Towing a trailer (see Trailer towing) . . . 184
Towing your vehicle.......... 213
using wheel dollies.......... 213
with a tow truck........... 213
Traction Control active light....... 12Trailer towing............. 184
calculating maximum trailer weight . . . 184
safety chains............. 186
tips................ 187
trailer brakes............ 187
trailer lamps............. 187
Transmission
automatic operation.......... 177
fluid, checking and adding....... 235
fluid, refill capacities......... 264
lubricant specifications........ 265
Transmission control switch....... 180
Trunk, using the remote entry system
to open............... 123
Trunk, power release.......... 118
Tune-up specifications (VECI)....... 252
Turn signal.............. 85
indicator lights............ 14
lever................ 85
File:fnix8.ex
Update:Thu Jun 27 10:02:38 1996