1997 FORD F150 transmission

Before adding any fluid, make sure
the correct type will be used. This
information is indicated on the
dipstick.
Do not drive the vehicle if the fluid
level is below the bottom hole on
the blade type dipstick (4R70W
transmission) or below the COLD
area on the bullet type dipstick
(E4OD transmission) and outside
temperatures are above 10ÉC
(50ÉF).
Your vehicle does not use up
transmission fluid. However, it is
recommended that you check the
transmission fluid at least twice a
year. The fluid level should be
checked if the transmission is not
working properly, i.e., if the
transmission slips or shifts slowly
or if you notice some sign of fluid
leakage.
It is preferable to check the
transmission fluid level at normal
operating temperature, after
approximately 32 km (20 miles) of
driving. However, you can check
the fluid level without driving to
obtain a normal operating
temperature if the outside
temperature is above 10ÉC (50ÉF).
If your vehicle has been operated
for an extended period at high
speeds, in city traffic during hot
weather or pulling a trailer, the
vehicle should be turned off for
about 30 minutes to allow the fluid
to cool before checking.
Maintenance and care
174

1. Park the vehicle on a level
surface.
2. Start the engine and move the
gearshift lever through all of the
gear ranges. Allow sufficient time
for each gear to engage.
3. Latch the gearshift lever in P
(Park), set the parking brake and
leave the engine running.
4. Remove the dipstick, wiping it
clean with a clean, dry rag.
5. Install the dipstick.
6. Remove the dipstick and inspect
the fluid level.
²For 4R70W transmissions, the
fluid level should be within the
crosshatched area, or if the
vehicle has not been driven,
DON'T ADD IF IN CROSSHATCHED AREA • CHECK WHEN HOT IDLING IN PARK
Maintenance and care
175

between the holes near the
bottom of the indicator.
²For E4OD transmissions, the
fluid level should be within the
HOT area, or if the vehicle has
not been driven, within the
COLD area.
7. If necessary, add fluid in .25L
(1/2 pint) increments through the
filler tube until the level is at the
correct area on the dipstick. If an
overfill occurs, excess fluid should
be removed by a qualified
technician.
f12_check_add_man_trans_fluid
Maintenance and care
176

Checking and adding manual
transmission fluid (if equipped)
1. Clean the filler plug.
2. Remove the filler plug and
inspect the fluid level.
3. Fluid level should be at bottom
of the opening.
4. Add only enough fluid through
the filler opening so that the fluid
level is 6 mm (3/8 in) from the
bottom of the opening.
Use only fluid that meets Ford
specifications. Refer to the
Capacities and specifications
chapter.
f12_check_add_tcase_fluid
Maintenance and care
177

have the charging system checked
for a possible malfunction.
Your vehicle is equipped with a
battery saver feature designed to
prevent your battery from
accidental wear down due to doors
left ajar. For information on this
system, refer to theControls and
featureschapter.
Relearning idle conditions
Because your vehicle's engine is
electronically controlled by a
computer, some control conditions
are maintained by power from the
battery. When the battery is
disconnected or a new battery is
installed, the computer must
ªrelearnº its idle conditions before
your vehicle will drive properly. To
complete this process:
1. Put the gearshift in P
(Park)(automatic transmission) or
N (Neutral)(manual transmission).
2. Turn off all accessories, and
start the engine.
3. Let the engine idle for at least
one minute.
4.The relearning process will
automatically complete as you
drive the vehicle.
²If you do not allow the engine to
relearn its idle, the idle quality
of your vehicle may be adversely
affected until the idle is
eventually relearned.
²If the battery has been
disconnected or a new battery
has been installed, the clock and
Maintenance and care
180

FluidFord part
nameVehicle type Capacity
Axle; rearFord 26.03
cm (10.25 in)
Conventional
and Traction
Lok (2)F-250 3.3L (7.0 pts.)
Engine
coolantPremium
Cooling
System Fluid4.2L w/o A/C
4.2L with A/C
4.6L w/o A/C
4.6L with A/C
5.4L w/o A/C
5.4L with A/C14.9L (15.7 qts.)
16.4L (17.3 qts.)
16.9L (17.9 qts.)
18.4L (19.4 qts.)
16.9L (17.9 qts.)
18.3L (19.4 qts.)
Engine oil
1
Super
Premium
Motorcraft
Motor Oil
5W-304.2L
4.6L
5.4L5.7L (6.0 qts.)
5.7L (6.0 qts)
5.7L (6.0 qts.)
FuelUnleaded 87
octane4x2 Reg. Cab
4x2 SuperCab
4x4 Reg. Cab
4x4 SuperCab
Long Wheelbase94.6L (25.0 gal)
94.6L (25.0 gal)
92.7L (24.5 gal)
94.6L (25.0 gal)
113.6L (30.0 gal)
Power
steering
fluidMotorcraft
MERCONT
Multi-purpose
AT FAll 2.3L (2.4 pts.)
Transfer
case
fluid
3(if
equipped)Motorcraft
MERCONT
Multi-purpose
AT F4-wheel drive
transfer case1.9L (2.0 qts.)
Transmission
fluid;
automaticMotorcraft
MERCONT
Multi-purpose
AT F4R70W
E4OD (4x2)
E4OD (4x4)13.1L (13.9 qts.)
15.04L (15.9 qts.)
15.51L (16.4 qts.)
Capacities and specifications
214

FluidFord part
nameVehicle type Capacity
Transmission
fluid;
manual
2
Motorcraft
MERCONT
Multi-purpose
AT F5-speed manual 3.5L (3.75 qts.)
Windshield
washer fluidUltra-clear
windshield
washer fluid
concentrateAll 4.0L (4.25 qts.)
(1) Add 118 ml (4 oz.) of additive friction modifier C8AZ-19B546-A,
Ford specification EST-M2C118±A, for complete fill of 22.35 cm (8.8
in.) and 24.76 cm (9.75 in) ring gear Traction-Lok axles.
(2) Add 236 ml (8 oz.) of additive Friction Modifier C8AZ-19B546-A,
Ford Specification EST-M2C118-A, for complete fill of 26.03 cm
(10.25 in) Ring Gear Traction-Lok axles.
1Includes filter replacement.
2Fill to 6 mm (3/8 in) below
bottom of filler hole.
3Fill to bottom of filler hole.
LUBRICANT SPECIFICATIONS
FluidFord part name
or equivalentFord part
numberFord
specification
Axle lubricant;
frontSAE 75W90 XY-75W90-QL
(Thermally
Stable)WSP-M2C201-A
Axle lubricant;
rearHigh
Performance
Rear Axle
LubricantF1TZ-19580-B WSL-M2C192-A
f12_lube
Capacities and specifications
215

FluidFord part name
or equivalentFord part
numberFord
specification
Brake fluid and
clutch fluidHigh
Performance
DOT 3 brake
fluidC6AZ-19542-AB ESA-M6C25-A
and DOT 3
Engine coolantPremium engine
coolantE2FZ-19549-AA
or BESE-M97B44-A
Engine oilSuper Premium
Motorcraft Motor
Oil 5W30XO-5W30-BSP
or QSPWSS-M2C153-F
Grease; body
hinges, latches
and seat tracks.Multi-Purpose
GreaseD0AZ-19584-AA
or
D7AZ-19584-AAESB-M1C93-A
or
ESB-M1C106-B
Grease;
transmission
/steering/parking
brake linkages
and pivots.
Brake and
clutch pedal
shaft.Premium
Long-Life
GreaseXG-1-C ESA-M1C75-B
Parking brake
cableSpeedometer
cable lubricantE6TZ-19581-A ESF-M1C60-A
Power steering
fluid, transfer
case fluid and
transmission
fluid (manual
and automatic)Motorcraft
MERCONT
Multi-purpose
AT FXT-2-BDX or
QDXMERCONT
Windshield
washer fluidUltra-clear
windshield
washer
concentrateC9AZ-19550-AC
or BCESR-M17P5-A
Capacities and specifications
216