1997 CADILLAC DEVILLE instrument panel

Downloaded from www.Manualslib.com manuals search engine Reach under the driver’s side of the instrument panel
and pull on the manual release lever, which is located
above the parking brake pedal.
If the parking brake does
not release, you should either drive to the nearest service
station or have your vehicle towed.
If your hand or arm is in the way of the pedal,
you could be hurt. The pedal springs back
quickly. Keep your hand and arm
away when you
use the manual release lever.
NOTICE:
Driving with the parking brake on can cause
your rear brakes to overheat. You may have to
replace them and you could also damage other
parts
of your vehicle.
If you are towing a trailer and are parking on a hill, see
“Towing
a Trailer” in the Index. This section shows
what to
do first to keep the trailer from moving.

Downloaded from www.Manualslib.com manuals search engine lhrn SignaVMultifunction Lever
’hrn and Lane Change Signals
To signal a turn, move the lever all the way up or down.
The lever returns automatically when the turn is complete.
An arrow on the instrument
panel will flash in the
direction of the turn or
lane change. If
the turn signal is left on, a warning chime will sound
and the
DIC will display TURN SIGNAL ON (after
driving about
a mile) to remind you to turn it off.
Arrows that flash rapidly when signaling for a turn or
lane change may be caused by a burned out signal bulb.
Other drivers won’t see the turn signal.
Replace burned-out bulbs to help avoid possible
accidents. Check the fuse (see “Fuses and Circuit
Breakers” in the Index) and for burned-out bulbs if the
arrow fails to work when signaling
a turn.
r Beam Changer Headlamp High/Low
Raise or lower the lever until the arrow starts to flash to
signal a lane change. Hold it there until
the lane change
is complete. The lever returns when it’s released. Pull the turn signal lever all
the way toward
you and
then release it to change the
headlamps from low beam
to high or from high beam
to low. This light on the
instrument panel will be on,
indicating high beam usage.
2-37

Downloaded from www.Manualslib.com manuals search engine Passing Another Vehicle While Using Cruise Control
Use the accelerator pedal to increase your speed. When
you take your foot
off the pedal, your vehicle will slow
down to the cruise control speed you set earlier.
Using Cruise Control on Hills
How well your cruise control will work on hills depends
upon your speed, load and the steepness
of the hills.
When going up steep hills, you may have to step
on the
accelerator pedal to maintain your speed. When going
downhill, you may have to brake or shift to a lower gear
to keep your speed down.
Of course, applying the brakes
or downshifting into
FIRST (1) takes you out of cruise
control. Many drivers find this to be too much trouble
and don’t use cruise control on steep hills.
Ending Cruise Control
There are two ways to end cruise control:
0 Step lightly on the brake pedal.
0 Move the CRUISE switch to OFF.
Erasing Speed Memory
The cruise control set speed memory is erased when you
turn
off the cruise control or the ignition.
Lamps
The control on the
left side
of the instrument
panel controls these
lamp systems:
Headlamps
0 Taillamps
Parking Lamps
Sidemarker Lamps
0 License Plate Lamp
0 Underhood Lamp
Fog Lamps (DeVille Concours Only)
0 Instrument Panel Lights
Interior Courtesy Lamps
2-45

Downloaded from www.Manualslib.com manuals search engine Pull the lamp control knob out to the first stop to turn on
the parking and taillamps, sidemarker lamps and
instrument panel lights. Pull the knob out all the way to
turn
on the headlamps. Push the control knob all the way
back in to turn the lamps and lights
off.
Cluster lighting as well as instrument panel backlighting
will dim only when it is dark outside.
Headlamps
The control for the headlamps is on the left side of the
instrument panel. Pull the lamp control
knob all the way
out to turn the headlamps on. Push the control knob all
the way back in to turn the headlamps off.
Wiper Activated Headlamps
This feature activates the headlamps and parking lamps
after the windshield wipers have been in use for
approximately
20 seconds.
In order to operate the wiper activated headlamps, the
twilight sentinel must be in the on position.
This feature
lights the way
in poor weather and it also makes your
vehicle more visible to other drivers.
If the wiper activated
headlamps
are on, and the ignition switch is turned off, the
wiper activated headlamps will immediately
turn off.
The wiper activated headlamps will deactivate if you
turn
off the twilight sentinel or if the windshield wipers
have been turned off for a period of one or two seconds.
Lamps on Reminder
You will hear a warning chime if you open any door
while leaving the lamps
on, if the manual headlamp
control is activated. An exception to this
is when you’re
using twilight sentinel.
Daytime Running Lamps
Daytime Running Lamps (DRL) can make it easier for
others to see the front of your vehicle during the day.
DRL can be helpful in many different driving
conditions, but they can be especially helpful in the
short periods after dawn and before sunset.
The
DRL system will make the low-beam headlamps
come on at reduced brightness when:
the ignition is on,
the headlamp switch is off and
the transaxle is not in PARK (P).
When DRL are on, only your low-beam headlamps (at
reduced brightness) will be on.
No other exterior lamps
such as the parking lamps, taillamps, etc. will be on
when the
DRL are being used. Your instrument panel
won’t be lit up either.
2-46

Downloaded from www.Manualslib.com manuals search engine Light Sensor
The light sensor for the DRL and the twilight sentinel is
located in
the center of the front defogger grille. If you
cover the sensor, it will read “dark” and the lamps will
come
on.
Exterior Lighting Battery Saver
If the manual park lamp control has been left on, the
exterior lamps will
turn off approximately 10 minutes
after the ignition
is turned to LOCK or ACCESSORY
This protects draining the battery in case you have
accidently left the headlamps or parking lamps
on. If
you need to purposely leave the lamps on for more
than
10 minutes with the ignition in LOCK or ACC, turn the
manual control
knob off and then back on. To delay the
lamps from turning
off, see “Twilight Sentinel” earlier
in
this section.
Interior Lamps
Instrument Panel Brightness Control
Cluster lighting as well as instrument panel lighting
automatically dims when it becomes dark outside. When
it’s dark, the brightness control can be manually adjusted. Cluster lighting and instrument panel lighting
automatically brighten when it becomes light outside.
2-50

Downloaded from www.Manualslib.com manuals search engine Courtesy Lamps (DeVille Only)
The courtesy lamps are located in the roof in the rear
seat. These lamps come on with the lamp
knob or when
any door is opened and it is dark outside.
Illuminated Entry
The illuminated entry system turns on the courtesy
lamps and the backlighting to the door switches and to
the lamp control knob when a door is opened or if you
press a
RISE transmitter button. Since the illuminated
entry system has
a photocell, this means that it must be
dark outside in order for the courtesy lamps
or
backlighting to turn on. The courtesy lamps turn off
approximately 20 seconds after the last door is closed or
after the ignition key is placed in the ignition.
Parade Dimming
This feature prohibits the dimming of the instrument
panel lights during daylight while the headlamps are on.
This feature operates with the light sensor for the
twilight sentinel and is fully automatic. When the light
sensor reads darkness outside, the instrument panel
lights can be adjusted. Backlighting to the instrument
panel will
also turn on.
Reading Lamps (DeVille d’Elegance and
DeVille Concours Only)
The reading lamps are located in the roof. These lamps
come on when any door is opened and it is dark outside.
Press the button
to turn them on. Press it again to turn
them
off.
If the reading lamps are left on, they automatically shut
off 10 minutes after the ignition has been turned off.
2-51

Downloaded from www.Manualslib.com manuals search engine Map Lamps
These lamps are located in the front overhead panel.
Press the button to turn them on. Press it again to turn
them
off.
Inadvertent Power Battery Saver
This feature is designed to protect your vehicle’s battery
against drainage from the interior lamps,
trunk lamp,
glove box lamp, cigarette lighters or the garage door
opener. When
the ignition is turned off, the power
to these features will automatically
turn off after
10 minutes (three minutes if a new car has 15 miles
or less). Power will be restored for
an additional
10 minutes if any door is opened, the trunk is opened
or the courtesy lamp switch is turned
on.
Battery Guard Storage
This feature is for long term use and must be
programmed through the
DIC while the ignition is in the
RUN position. Battery guard storage protects the battery
by placing the vehicle in a storage mode
so that the
radio, amplifiers, instrument cluster and
RKE will not
drain the battery over a long period of time.
2-52

Downloaded from www.Manualslib.com manuals search engine The Instrument Panel: Your Information System