1997 CADILLAC CATERA change wheel

Downloaded from www.Manualslib.com manuals search engine Manual Lumbar Support
The lumbar controls are
located on the outboard side
of each front seat. They
provide additional support
to your lower back and
work independently
of
other seat controls.
To raise the seat cushion up or down, press one of the
rocker switch buttons located on the outboard side
of the
passenger’s seat. The top button raises the seat cushion
and the bottom button lowers the seat cushion. Use manual
or power seat controls first to get the proper
seating position. Then proceed with the lumbar adjustment.
The upper and lower seatback can be adjusted using the
two small hand-wheel controls. The top hand-wheel
control adjusts the upper seatback and the bottom
control adjusts the lower seatback. Turn the controls
forward to increase support and rearward to
decrease support.
Keep in mind that as your seating position changes, as it
may during long trips,
so should the position of the
lumbar support. Adjust the seat as needed.
1-3

Downloaded from www.Manualslib.com manuals search engine Tilt Wheel lbrn SignaVMultifunction Lever
D
P
Tilt steering allows you to adjust the steering wheel
before you drive. Raising the steering wheel to the
highest level gives your legs more room when you enter
and exit your vehicle.
Hold the steering wheel and pull the lever toward you to
tilt
the wheel. Adjust the steering wheel to a comfortable
position and then release the lever to lock the wheel
in place.
Turn and Lane Change Signals
To signal a turn, move the lever all the way up or down.
The lever returns automatically when the
turn is complete.
This arrow on the
instrument panel will flash
in the direction
of the turn
or lane change.
Raise or lower the lever until
the arrow
starts to flash to
signal a lane change. Hold it
there until the lane change is
complete. The lever returns
when it’s released.
Arrows that flash rapidly when signaling
for a turn or
lane change may be caused by a front burned-out signal
bulb (this does not occur with a rear burned-out bulb).
Other drivers won’t see the turn signal. Replace
burned-out bulbs to help avoid possible accidents. Check the fuse (see “Fuses and Circuit Breakers” in the
Index) and for burned-out bulbs if the arrow fails to
work when signaling a turn.
2-32

Downloaded from www.Manualslib.com manuals search engine Headlamp High/Low Changer Windshield Wipers
With
the twilight sentinel on or with the lamp control
dial turned to the headlamp position, push the turn
signal lever on the driver’s side of the steering wheel
away from you to turn on the high-beam headlamps.
This light on on the
instrument panel will be
on,
indicating high-beam usage.
Pull the lever back to the original position to return to
low-beam headlamps. For more information, see
“Headlamps” later in this section.
Flash-To-Pass
This lets you use the high-beam headlamps to signal the
driver in front of you that you want to pass.
Pull the turn signal lever toward you and release. The
high-beam headlamps will briefly
turn on and then off.
L
L
b
I
WIPER: Move the lever on the passenger’s side of the
steering wheel up and down to control the wipers.
MIST Tap the lever up and then release it for a single
wipe cycle. For more cycles, pull and hold the lever.
= (HIGH): Move the lever all the way up for a fast
wiper speed.
- (LOW): The third position up controls the low
wiper speed.
-- (DELAY): This is for a controlled delay setting.
Rotate the control dial on the lever to increase
or
decrease the delay between wipe cycles.
o (OFF): This position turns off the wipers.
2-33

Downloaded from www.Manualslib.com manuals search engine Cruise Control
1
With cruise control, you can maintain a speed of about
25 mph (40 km/h) or more without keeping your foot
on the accelerator. This can help on long trips. Cruise
control does not work at speeds below about
25 mph
(40 km/h).
Cruise control shuts off when you apply the brakes or
when the
OFF button at the end of the cruise lever is
pressed.
I
Cruise control can be dangerous where you
can’t drive safely at a steady speed.
So,
don’t use your cruise control on winding
roads or in heavy traffic.
slippery roads. On such roads, fast changes
in tire traction can cause needless wheel
spinning, and you could lose control. Don’t
use cruise control on slippery roads.
Cruise control can be dangerous on
If your vehicle is in cruise control when the traction
control system begins to limit wheel spin, the cruise
control will automatically disengage. (See “Traction
Control System” in the Index.) When road conditions
allow you to safely use it again, you may turn the cruise
control back on.

Downloaded from www.Manualslib.com manuals search engine -4
700< Parking lamps, front and rear sidemarker
lamps, taillamps, license plate lamps, ashtray lamps,
backlighting to the radio controls and instrument
panel lights.
so Headlamps .
$0 Fog lamps.
TWILIGHT Twilight sentinel.
OFF Turns the twilight sentinel system off.
@ Instrument panel brightness control.
Turn the lamp control dial clockwise to the first position
to turn on the parking lamps, front and rear sidemarker
lamps, taillamps, license plate lamps, ashtray lamps,
instrument panel lights and backlighting to the center
console controls.
Rotate the lamp control dial counterclockwise to turn
the lamps
off.
Headlamps
Rotate the lamp control dial clockwise to turn on the
low-beam headlamps.
To turn on the high-beam headlamps, the low-beam
headlamps must already be on. Push the turn signal lever
on the left side of the steering wheel away from you to
engage the high-beam headlamps. Pull the lever toward you to return
to the low-beam headlamps. For more
information, see “Headlamp High/Low Changer” earlier
in this section.
Rotate the lamp control dial counterclockwise
to turn
the headlamps off.
Note that if the headlamps are activated while driving
and then you turn your vehicle’s ignition off while the
lamp dial is still turned on, the headlamps will turn
off.
Turn the lamp control dial counterclockwise to turn the
headlamps off and to stop the reminder chime from
sounding. (If you want the headlamps to remain on, you
must manually turn the lamp control dial off and then
back on to the headlamp position. The headlamps will
stay
on until manually turned off again.)
2-39

Downloaded from www.Manualslib.com manuals search engine Traction Engaged
When your traction control system is limiting wheel
spin, the traction control system warning light will flash.
Slippery road conditions may exist if this warning light
is flashing,
so adjust your driving accordingly.
Traction Control System Warning Light
This warning light should
come on briefly as you start
the engine. If the warning
light doesn’t come on then,
have it fixed
so it will be
ready to warn you if there’s
a problem. The warning
light will flash when
the system senses a
traction change.
If it stays on, or comes on and stays on steady when
you’re driving, there may be a problem with your
traction control system and
your vehicle may need
service. When this warning light is
on, the system will
not limit wheel spin. Adjust your driving accordingly. The
traction control system warning light may come on
for the following reasons:
If there’s a brake system problem that is specifically
related to traction control, the traction control system
will turn
off and the warning light will come on.
If the traction control system is affected by an
engine-related problem, the system will turn off and
the warning light will come on.
If the traction control system warning light comes on
and stays on for an extended period
of time when the
system is turned on, your vehicle needs service.

Downloaded from www.Manualslib.com manuals search engine Section 3 Comfort Controls and Audio Systems
In this section, you'll find out how to operate the comfort control and audio systems offered with your Catera.
Be sure to read about the particular systems supplied with your vehcle.
3-2
3-6
3-6 3-7
3-8
3-9
3-9
3-
10
Comfort Controls
Air Conditioning
Heating
Ventilation System
Defrosting
Rear Window Defogger
Setting the Clock
AM-FM Stereo with Cassette Tape Player and
Optional Compact Disc Player
3-13
3-17
3-20
3-20
3-21
3-21
3-22
3-23
3-24
Bose" AM-FM Stereo with Cassette Tape
and Compact Disc Player
Trunk Mounted CD Changer
Theft-Deterrent Feature
Audio Steering Wheel Controls
Understanding Radio Reception
Tips About Your Audio System
Care of Your Cassette Tape Player
Care of Your Compact Discs
Heated Backlite Antenna
3-1

Downloaded from www.Manualslib.com manuals search engine CHEK DOOR or CD CHANGER DOOR OPEN is
displayed when the
CD changer door is left open.
Completely close the changer door to restore
normal operation.
CD CHANGER
NO DISCS is displayed when an empty
magazine is inserted in the CD changer. Try the
magazine again with a disc loaded on one
of the trays.
(This message does not appear in the display on the
standard
AM-FM Stereo radios.)
If any error occurs repeatedly or if an error cannot be
corrected, please contact your dealer.
If your radio
displays an error number, write
it down and provide it to
your dealer when reporting the problem.
Theft-Deterrent Feature
Your Catera has a “built-in” theft-deterrent feature on
each radio that is automatic
-- there is no programming
required. The radio in your Catera cannot be used in
any other vehicle besides another Catera if
it were to
be removed.
Audio Steering Wheel Controls
Some audio controls can be adjusted at the steering
wheel. They include the following:
+: Pressing this button increases volume.
-: Pressing this button decreases volume.
o (SOURCE): To change to a tape or CD, press
this button.
3-20