Downloaded from www.Manualslib.com manuals search engine Outside Temperature Display
The outside temperature is always displayed when your
vehicle's ignition is on. If the outside temperature
display begins to flash, this means that icy road
conditions are possible. Adjust your driving if needed.
The display will flash for about
30 seconds and then
remain
on steady.
Mode Button
Press this button to deliver air through the floor, middle,
side or windshield outlets. The climate control system
will stay in the selected ECC mode until the MODE
button is pressed again or until the TEMP/AUTO knob
is pressed. Press the up or down arrow to see the
available modes.
EnglisWetric Display
You can change the temperature display from English
(degrees Fahrenheit) to metric (degrees Celsius) by
pressing and holding the driver's side TEMP/AUTO
knob for approximately three seconds. Repeat the
process to change back to English from metric.
Automatic Operation
Pressing the driver's side TEMP/AUTO knob sets the
system for automatic operation. Once the system
is set,
sensors will control the air delivery mode. Air will come
from the floor, middle, side
or windshield outlets. The
fan speed will vary as the system maintains the selected
temperature setting. (All previous manually set mode
settings will change back to a fully automatic mode
when the climate control system is turned on this way.)
Be careful not to put anything over the solar sensor
located in
the middle of the instrument panel near the
windshield. This sensor
is used by the automatic system
to regulate temperature.
To find your comfort zone, start with the
75 OF (24" C j
setting and allow about 20 minutes for the system to
regulate. Adjust the temperature if necessary. If you
choose
60°F (1 6"C), the system will remain at that
maximum cooling setting and will not regulate
fan
speed. If you choose the temperature of 90°F (32°C)'
the system will remain at that maximum heating setting
and will not regulate fan speed. Choosing either
maximum setting will not cause the system to heat or
cool any faster.
3-3
Downloaded from www.Manualslib.com manuals search engine * FAN SPEEDS: Press the driver’s side
TEMP/AUTO knob to set the fan speed for automatic
operation. At this setting, the fan speed is automatically
controlled. If it is cold outside, the blower may not run
in the maximum high fan speed right away. The system
checks the temperature of the engine coolant to assure it
is warm enough to provide heat. When the engine
coolant is warm, the controller allows the fan to
gradually increase to a higher speed. This prevents cold
air from blowing into the passenger compartment. If you
want the blower fan at a high speed, press the up arrow
button until you reach the highest position of the display.
If you want the blower fan at a low speed, press the
down arrow button until the lowest position is displayed.
ON/OFF: Press this button to turn the system off.
Press this button again to turn the system back on.
Turning the climate control system on in this way
will recall all previous manually set mode settings.
If the system is turned on by pushing the driver’s
TEMP/AUTO knob for automatic operation, all
of the
previous manually set mode settings will be changed
back to the fully automatic mode.
AC: Press this button to turn the air conditioning on and
off. The system will cool and dehumidify the air inside
the vehicle. In the automatic operation
mode, the display
will show
AC OFF when the air conditioning has been
turned
off.
RECIRCULATION: Press this button to limit the
amount of fresh air entering your vehicle. This is helpful
when you are trying to cool the air quickly or limit
odors
entering your vehicle. In the automatic operation mode,
the system will use recirculation as necessary to cool the
air. Pressing the recirculation button will change the
operation to a manual mode and the air will recirculate
non-stop. Press this button again to turn
off the
recirculation feature.
If you notice the windows fogging, press the
recirculation button to exit the recirculation mode.
3-5
