1997 CADILLAC CATERA clock

Downloaded from www.Manualslib.com manuals search engine If a failure in the power supply system occurs, the power
seats can be manually adjusted by inserting the crank
handle into the slot located below the seat cushion (as
shown in the above illustration). Turn the crank handle
clockwise until you’ve reached your desired seating
position (note that manually moving the seat requires
turning the crank handle many times).
The crank handle is provided in the tool kit located in
the trunk (with the jack).
Memory Seat and Mirrors (Option)
Adjust the driver’s seat to a comfortable position. Also
adjust the interior and exterior mirrors. Press memory
button
“M’ and memory button “1” at the same time.
These buttons are located on the outboard side
of the
driver’s seat. Seat and mirror positions may be
programmed for two additional drivers by repeating the
above steps and pressing memory button
“2” or “3”
instead of memory button 1.
1-5

Downloaded from www.Manualslib.com manuals search engine Rear Seats
Folding the Rear Seat
With the rear folding seatbacks, you can carry long
cargo by folding down part or all of the rear seat. To
unlock the rear seatback, press the pushbutton at the top
of the seat and fold the seatback forward.
To return the seat to the passenger position, lift up on the
seatback and push it rearward
until it latches. After returning the seat
to the passenger position, pull
forward on the seatback to make sure it is locked into
place. Also, return the safety belts to their original
positions,
so they will be available for rear seat
~ passengers to use.
The panel behind the rear seat armrest also folds. Turn
the knob counterclockwise and pull the panel forward to
gain access to the trunk.
1-10

Downloaded from www.Manualslib.com manuals search engine Slide the lock lever down to
lock the
door from the
inside.
To unlock the door,
slide the lock lever
up.
Central Door Unlocking System
When unlocking the driver's door, you can also unlock
the other doors, including the fuel door,
by holding the
key
in a turned position for several seconds (turn the key
counterclockwise). Pressing the unlock button on the
RKE transmitter twice in a row will also open the
other doors.
Power Door Locks
Press the power door lock switch to lock or unlock all of
the doors at once.
Automatic Door Locks
Close the doors and turn on the ignition. Every time you
move the
shift lever out of PARK (P), all of the doors will
lock. The doors will unlock every time you stop the vehicle
and move the shift lever into PARK (P). If someone needs
to get out while your vehicle is not
in PARK (P), have that
person use the manual
or power lock. When the door is
closed again, it
will not lock automatically. Use the manual
or power lock
to lock the door again.
2-4

Downloaded from www.Manualslib.com manuals search engine When you stop your vehicle and turn the ignition key to
LOCK, you can still use the power windows. The
electrical power to operate the windows will not shut off
until a door is opened
-- there is no time limit to this
feature.
As soon as a door is opened, power window
movement will stop immediately.
Programming the Power Windows
If the battery on your vehicle has been disconnected or
is not working, you will need to reprogram each power
window in order for the express-open and close features
to work.
To program each window, press and hold the power
window control until the window has fully opened.
Continue holding the control down for approximately
five more seconds after the window is completely down.
The window is now programmed. Repeat this process
for each window.
Anti-Pinch Feature
If a hand, a head or another object is in the way of the
power window express-closing, the window will
immediately stop at the obstruction and express-open to
a preset factory position.
Note that pressing and holding the power window
control button will override the anti-pinch feature.
Rear Window Lockout
Pressing this button
rearward will disable the
rear passenger window
controls. This is a useful
feature if you have children
as passengers.
Press the
button forward to allow
your passengers to reuse
their window controls.
Horn
The horn can be sounded by pressing either horn symbol
on the steering wheel. The symbols are located at about
the
9 and 3 o’clock positions.

Downloaded from www.Manualslib.com manuals search engine -4
700< Parking lamps, front and rear sidemarker
lamps, taillamps, license plate lamps, ashtray lamps,
backlighting to the radio controls and instrument
panel lights.
so Headlamps .
$0 Fog lamps.
TWILIGHT Twilight sentinel.
OFF Turns the twilight sentinel system off.
@ Instrument panel brightness control.
Turn the lamp control dial clockwise to the first position
to turn on the parking lamps, front and rear sidemarker
lamps, taillamps, license plate lamps, ashtray lamps,
instrument panel lights and backlighting to the center
console controls.
Rotate the lamp control dial counterclockwise to turn
the lamps
off.
Headlamps
Rotate the lamp control dial clockwise to turn on the
low-beam headlamps.
To turn on the high-beam headlamps, the low-beam
headlamps must already be on. Push the turn signal lever
on the left side of the steering wheel away from you to
engage the high-beam headlamps. Pull the lever toward you to return
to the low-beam headlamps. For more
information, see “Headlamp High/Low Changer” earlier
in this section.
Rotate the lamp control dial counterclockwise
to turn
the headlamps off.
Note that if the headlamps are activated while driving
and then you turn your vehicle’s ignition off while the
lamp dial is still turned on, the headlamps will turn
off.
Turn the lamp control dial counterclockwise to turn the
headlamps off and to stop the reminder chime from
sounding. (If you want the headlamps to remain on, you
must manually turn the lamp control dial off and then
back on to the headlamp position. The headlamps will
stay
on until manually turned off again.)
2-39

Downloaded from www.Manualslib.com manuals search engine Storage Compartments
Glove Box
The glove box is located in front of the passenger’s seat.
To lock the glove box door, insert the key into the lock
cylinder and turn it clockwise. Turn
the key
counterclockwise to unlock the door.
Note that the glove box is
air conditioned. This helps
to keep snack items cool while traveling. Use the slide
control inside
of the glove box to turn the air conditioning
on and off. Moving the slide control over the small hole
turns the air conditioning off and moving the control away
from the hole turns the air conditioning on.
Map Pockets
The mapktorage pockets are located on each front
door as well as on the passenger’s and driver’s front
seatbacks. Also located on the driver’s door map pocket
is a coin holder. The
front storage area comes with a small storage bin
and a dual cupholder that unfolds for use.
2-48

Downloaded from www.Manualslib.com manuals search engine C
L
G
A. Fully Open
B. About 80% Open
C. About 50% Open
D. About 25% Open
E. Fully Closed
E About 40% Tilted
G. Fully Tilted Rotating the control dial
to position
A fully opens the
glass panel and sunshade. The sunshade can also be
opened by hand. If
you want to stop the roof in a
partially opened position, rotate the control dial to any
position between
A and E. The positions range from
about 25% open to approximately 80% open. Rotate the
dial to position
E to fully close the glass panel. To close
the sunshade, pull it forward.
To raise the glass panel, rotate the control dial
counterclockwise to one
of the three tilt positions.
The positions range from about
40% tilted (F) to fully
tilted
(G). To close the vent, rotate the dial clockwise to
position
E.
Anti-Pinch Feature
If a hand, a head or another object is in the way of
the power sunroof closing, the glass panel will
immediately stop at the obstruction and open to
a
preset factory position.
Note that pressing and holding the power sunroof
control dial up will override the anti-pinch feature.
2-52

Downloaded from www.Manualslib.com manuals search engine Manual Operation
If a failure in the power supply system occurs, the
sunroof can, be manually closed by inserting a screw
driver into the slot
as shown. Turning the screwdriver
counterclockwise will close the sunroof.
The screwdriver
is provided in the tool kit in the trunk
(with the jack).
Programming the Sunroof
If the battery on your vehicle has been disconnected or
is not working, you will need to reprogram the sunroof
following these steps.
With your vehicle’s ignition on:
1. If the sunroof is closed, rotate the control dial to
position
E. Press the dial for about five seconds.
If the sunroof
is open, rotate the control dial to E and
press
until the glass panel has closed. Now continue
pressing the dial for approximately five more seconds.
2. Rotate the control dial to position G and press until
3. Now rotate the control dial to position E and keep
the sunroof is
fully tilted.
pressing
until the sunroof is fully closed.
2-53