Page 1109 of 1503
Dashboard
Component Removal/Installation
Clock and center air vent removal:
NOTE: Take care not to scratch the dashboard and
related parts.
1. Remove the clock by pulling it backward from the
center air vent, then disconnect the connector.
2. Remove the center air vent mounting screws.
4. To make a gap between the center air vent and
dashboard, pull the top of the center air vent while
lowering it as shown.
CLOCK
Disconnect the connector.
CENTER AIR
VENT
CENTER AIR VENT
MOUNTING SCREWS
3. Insert a plastic between the center air vent and
center console panel to prevent damaging them.
CENTER AIR VENT
CENTER CONSOLE
PANEL
PLASTIC PLATE
(Thin plate)
NOTE: Make as large a gap as possible.
DASHBOARD
CENTER AIR
VENT
PLASTIC
PLATE
5. Insert a flat tip screwdriver between the center air
vent and dashboard as shown.
NOTE: Use the correct size flat tip screwdriver as
shown.
3.3 mm
(0.13
in)
max.
CENTER AIR
VENT
DASHBOARD
PLASTIC
PLATE
FLAT TIP
SCREWDRIVERProCarManuals.com
Page 1112 of 1503
Climate control unit, stereo cassette/radio and glove box removal:
Disassemble in numbered sequence.
NOTE: Remove the center console panel.
CLIMATE CONTROL
UNIT
Disconnect the connectors.
SRS UNIT
Passenger's:
STEREO
CASSETTE RADIO
Disconnect the connectors.
GROUND CABLE
GLOVE BOX
Disconnect the connectors.
TRUNK LID OPENER
MAIN SWITCH
PASSENGER'S
AIRBAG
DLC
CONNECTOR
GLOVE BOX
LID
DASHBOARD LOWER
COVER (Passenger's)
Installation is the reverse of the removal procedure.
NOTE: Make sure the connectors are connected properly.
(cont'd)ProCarManuals.com
Page 1191 of 1503
5. Remove the three screws and center console
panel, then disconnect the 3P connector and 4P
connector from the floor wire harness.
CENTER CONSOLE PANEL
6. Remove the four screws, then disconnect the 14P
and 30P connectors from the automatic climate
control unit and remove it.
CLIMATE
CONTROL UNIT
UP CONNECTOR
30P CONNECTOR
7. Install in the reverse order removal.ProCarManuals.com
Page 1384 of 1503
5. Remove the five screws and center console panel,
then disconnect the 3P connector and 4P connector
from the floor wire harness.
CENTER CONSOLE PANEL
4P
CONNECTOR
3P CONNECTOR
6. Remove the four screws, then disconnect the 14P
and 30P connectors from the floor wire harness and
take out the climate control unit.
CLIMATE
CONTROL UNIT
30P CONNECTOR
14P CONNECTOR
7. Remove the four screws, then disconnect the 16P
connector, mast antenna lead, and window antenna
lead and take out the stereo radio/cassette player.
STEREO RADIO/
CASSETTE PLAYER
16P CONNECTOR
WINDOW ANTENNA LEAD
MAST ANTENNA LEADProCarManuals.com
