Page 57 of 2062
Downloaded from www.Manualslib.com manuals search engine − PREPARATIONENGINE MECHANICAL (3RZ−FE)
PP−3
52 Author: Date:
1996 TOYOTA T100 (RM449U)
(09248−05420)Valve Lifter Stopper
09325−20010Transmission Oil Plug
09330−00021Companion Flange Holding ToolCrankshaft pulley
09550−10012Replacer Set ”B”
(09252−10010)No. 1 Replacer Handle−Valve guide busing
09608−30012Front Hub & Drive Pinion Bearing
Tool Set−
(09951−07100)Handle 100Crankshaft rear oil seal
09636−20010Upper Ball Joint Dust Cover
ReplacerCrankshaft timing gear
09816−30010Oil Pressure Switch SocketKnock sensor
09843−18020Diagnosis Check Wire
09950−40010Puller B Set
(09951−04010)Hanger 150
(09952−04010)Slide Arm
Page 63 of 2062
Downloaded from www.Manualslib.com manuals search engine − PREPARATIONENGINE MECHANICAL (5VZ−FE)
PP−9
58 Author: Date:
1996 TOYOTA T100 (RM449U)
(09248−05420)Valve Lifter Stopper
09330−00021Companion Flange Holding ToolCrankshaft pulley
09816−30010Oil Pressure Switch SocketOil pressure switch
09843−18020Diagnosis Check Wire
09950−50010Puller C Set
(09951−05010)Hanger 150Crankshaft pulley
Crankshaft timing pulley
(09952−05010)Slide ArmCrankshaft pulley
Crankshaft timing pulley
(09953−05020)Center Bolt 150Crankshaft pulley
Crankshaft timing pulley
(09954−05010)Claw No.1Crankshaft timing pulley
(09954−05030)Claw No.3Crankshaft pulley
09950−70010Handle Set
(09951−07150)Handle 150Crankshaft rear oil seal
Valve guide bushing
09960−10010Variable Pin Wrench Set
Page 73 of 2062
Downloaded from www.Manualslib.com manuals search engine PP0GC−02
− PREPARATIONMFI (3RZ−FE)
PP−19
68 Author: Date:
1996 TOYOTA T100 (RM449U)
MFI (3RZ−FE)
SST (Special Service Tools)
09268−41046Injection Measuring Tool Set
(09268−41091)NO.7 Union
(90405−09015)No.1 Union
09268−45012EFI Fuel Pressure Gauge
09631−22020Power Steering Hose Nut
14 x 17 mm Wrench SetFuel line flare nut
09816−30010Oil Pressure Switch SocketKnock sensor
09842−30070Wiring ”F” EFI Inspection
09843−18020Diagnosis Check Wire
Page 76 of 2062
Downloaded from www.Manualslib.com manuals search engine PP330−01
PP−22
− PREPARATIONSFI (5VZ−FE)
71 Author: Date:
1996 TOYOTA T100 (RM449U)
SFI (5VZ−FE)
SST (Special Service Tools)
09268−41046Injection Measuring Tool Set
(09268−41091)NO.7 Union
(09268−52011)Injection Measuring Attachment
09268−45012EFI Fuel Pressure Gauge
09631−22020Power Steering Hose Nut
14 x 17 mm Wrench SetFuel line flare nut
09816−30010Oil Pressure Switch Socket
09842−30070Wiring ”F” EFI Inspection
09843−18020Diagnosis Check Wire
Page 272 of 2062

Downloaded from www.Manualslib.com manuals search engine P00495
Outside
Inside
DI−8
− DIAGNOSTICSENGINE (3RZ−FE)
1996 TOYOTA T100 (RM449U)
6. BASIC INSPECTION
When the malfunction code is not confirmed in the DTC check, troubleshooting should be performed in the
order for all possible circuits to be considered as the causes of the problems. In many cases, by carrying
out the basic engine check shown in the following flow chart, the location causing the problem can be found
quickly and efficiently. Therefore, use of this check is essential in engine troubleshooting.
1 Is battery positive voltage 11 V or more when engine is stopped?
NO Charge or replace battery.
YES
2 Is engine cranked?
NO Proceed to page ST−15 and continue to trouble-
shoot.
YES
3 Does engine start?
NO Go to step 7.
YES
4 Check air filter.
PREPARATION:
Remove the air filter.
CHECK:
Visual check that the air filter is not dirty or excessive oily.
HINT:
If necessary, clean the filter with compressed air. First blow from
inside thoroughly, then blow from outside of the filter.
NG Repair or replace.
OK
Page 324 of 2062
Downloaded from www.Manualslib.com manuals search engine P03792
P25086
A00065
DI−60
− DIAGNOSTICSENGINE (3RZ−FE)
1996 TOYOTA T100 (RM449U)
INSPECTION PROCEDURE
1 Check spark plug and spark of misfiring cylinder.
PREPARATION:
(a) Disconnect the high−tension cord.
(b) Remove the spark plug.
CHECK:
(a) Check the carbon deposits electrode.
(b) Check the electrode gap.
OK:
(1) No large carbon deposit present. Not wet with gas-
oline or oil.
(2) Electrode gap: 0.8 mm (0.031 in.)
PREPARATION:
(a) Install the spark plug to the high−tension code.
(b) Disconnect the injector connector.
(c) Ground the spark plug.
CHECK:
Check if the spark occurs while the engine is being craked.
NOTICE:
To prevent excess fuel being injected from the injectors
during this test, don’t crank the engine for more than 5 − 10
seconds at a time.
OK:
Spark jumps across electrode gap.
NG Replace or check ignition system (See page
IG−1).
OK
Page 334 of 2062

Downloaded from www.Manualslib.com manuals search engine DI−70
− DIAGNOSTICSENGINE (3RZ−FE)
1996 TOYOTA T100 (RM449U)
DTC P0340 Camshaft Position Sensor Circuit
Malfunction
CIRCUIT DESCRIPTION
Camshaft position sensor (G signal) consist of signal plate and pickup coil. The G signal plate has one tooth
on its outer circumference and is built into the distributor.
When the camshafts rotate, the protrusion on the signal plate and the air gap on the pickup coil change,
causing fluctuations in the magnetic field and generating an electromotive force in the pickup coil.
The NE signal plate has 34 teeth and is mounted on the crankshaft. The NE signal sensor generates 34
signals for every engine revolution. The ECM detects the standard crankshaft angle based on the G signals
and the actual crankshaft angle and the engine speed by the NE signals.
DTC No.DTC Detecting ConditionTrouble Area
P0340
No camshaft position sensor signal to ECM during cranking
(2 trip detection logic)Open or short in camshaft position sensor circuit
Camshaft position sensor
Distributor
Starter
ECM
No camshaft position sensor signal to ECM during engine run-
ning
WIRING DIAGRAM
Refer to DTC P0335 on page DI−66.
INSPECTION PROCEDURE
1 Check resistance of camshaft position sensor (See page EM−3).
Reference: INSPECTION USING OSCILLOSCOPE
Refer to DTC P0335 on page DI−66.
NG Replace distributor housing.
OK
2 Check for open and short in harness and connector between ECM and
distributor (See page IN−26).
NG Repair or replace harness or connector.
OK
DI0TT−03
Page 372 of 2062
Downloaded from www.Manualslib.com manuals search engine DI−108
− DIAGNOSTICSENGINE (3RZ−FE)
1996 TOYOTA T100 (RM449U)
8 Check for open and short in harness and connector between ignition switch and
ignition coil, ignition coil and igniter (See page IN−26).
NG Repair or replace harness or connector.
OK
9 Check ignition coil (See page IG−1).
NG Replace ignition coil.
OK
Replace igniter.