1996 TOYOTA LAND CRUISER Power steering pressure hose

PP3KU−01
−
PREPARATION SFI
PP−11
60
Author: Date:
1996 LAND CRUISER (RM451U)
SFI
SST (Special Service Tools)
09268−41047Injection Measuring Tool Set
(09268−41091)NO.7 Union
(90405−09015)No.1 Union
09268−45012EFI Fuel Pressure Gauge
09631−22020Power Steering Hose Nut
14 x 17 mm Wrench SetFuel line flare nut
09816−30010Oil Pressure Switch SocketKnock sensor
09842−30070Wiring ”F” EFI Inspection
Brought to you by BirfMark
Brought to you by BirfMark
Version 1.11 - 03/16/2010

PP3KM−01
PP−56
−
PREPARATION STEERING
105
Author: Date:
1996 LAND CRUISER (RM451U)
STEERING
SST (Special Service Tools)
09527−10011Rear Axle Shaft Bearing RemoverPS vane pump
09610−55012Pitman Arm PullerSteering linkage
09611−22012Tie Rod End PullerSteering linkage
09616−00011Steering Worm Bearing Adjusting
SocketPS gear
09628−62011Ball Joint PullerSteering linkage
09630−00014Power Steering Gear Housing
Overhaul Tool Set
(09631−00051)No.3 WrenchPS gear
(09631−00121)Teflon Ring FormerPS gear
(09631−00142)Overhaul StandPS gear
09631−10030Oil Seal RemoverPS vane pump
09631−22020Power Steering Hose Nut
14 x 17 mm Wrench SetPS gear
09640−10010Power Steering Pressure Gauge
Set
Brought to you by BirfMark
Brought to you by BirfMark
Version 1.11 - 03/16/2010

SR16G−01
R13336
−
STEERING POWER STEERING VANE PUMP
SR−23
1996 LAND CRUISER (RM451U)
REMOVAL
1. DISCONNECT RETURN HOSE
2. DISCONNECT PRESSURE FEED TUBE
Remove the union bolt and 2 gaskets.
3. REMOVE PS VANE PUMP ASSEMBLY
(a) Remove the 2 nuts.
(b) Remove the O−ring from the vane pump assembly.
Brought to you by BirfMark
Brought to you by BirfMark
Version 1.11 - 03/16/2010

SR16K−01
R13336
R13315
Stopper
SR−32
−
STEERING POWER STEERING VANE PUMP
1996 LAND CRUISER (RM451U)
INSTALLATION
1. INSTALL PS VANE PUMP ASSEMBLY
(a) Coat a new O −ring with power steering fluid and install it
to the vane pump assembly.
(b) Torque the 2 nuts. Torque: 36 N·m (370 kgf·cm, 27 ft·lbf)
2. CONNECT PRESSURE FEED TUBE
Torque the union bolt with 2 new gaskets. Torque: 56 N·m (575 kgf·cm, 42 ft·lbf)
HINT:
Make sure the stopper of the tube is touching the PS pump
body, as shown then torque the union bolt.
3. CONNECT RETURN HOSE
4. BLEED POWER STEERING SYSTEM (See page SR−3 )
Brought to you by BirfMark
Brought to you by BirfMark
Version 1.11 - 03/16/2010