Q07131
SST
TF0867
I19645
Push
Free
−
TRANSFER TRANSFER ASSEMBLY
TR−9
1996 LAND CRUISER (RM451U)
22. REMOVE 2 BEARING RACES FROM FRONT CASE
(a) Using SST, remove the bearing race (for idler gear).
SST 09950−40010, 09950 −60010 (09951−00320)
HINT:
At the time of reassembly, please refer to the following item.
Using SST and a press, install the bearing race (for idler gear).
SST 09316−60011 (09316 −00011, 09316−00041)
(b) Using a brass bar and hammer, remove the bearing race
(for output shaft).
HINT:
At the time of reassembly, please refer to the following item.
Using SST and a press, install the bearing race (for the out put
shaft). SST 09316 −20011, 09316 −60011 (09316 −00011,
09316 −00031)
23. INSPECT TRANSFER INDICATOR SWITCH
Check that there is continuity between the terminals, as shown.
Switch PositionSpecified
PushContinuity
FreeNo continuity
If continuity is not as specified, replace the switch.
Brought to you by BirfMark
Brought to you by BirfMark
Version 1.11 - 03/16/2010
Q02622
Light upGoes off
L
NH
DIFF LOCK
DIFF LOCK
TR0BM−03
Z15367
Relay Side
V01699
V06651
−
TRANSFER MOTOR SHIFT CONTROL SYSTEM
TR−37
1996 LAND CRUISER (RM451U)
INSPECTION
1. INSPECT SHIFT LEVER POSITION
(a) Start the engine, and turn the center diff lock switch to
OFF.
(b) Check that the center diff indicator light comes on when the transfer shift lever shifted to the ”L” position. Check
that the light goes off when the lever is shifted to the ”N”
or ”H” position.
2. INSPECT CENTER DIFF LOCK CONTROL RELAY
(a) Check that there is continuity between the terminals, as shown in the chart.
HINT:
There is a diode between the terminals 6 and 7. If the circuit
shown no continuity, change the positive (+) and negative ( −)
probes and recheck the circuit.
(b) Apply battery positive voltage between the terminals and check that there is continuity between the terminals, as
shown in the chart.
If continuity is not as specified, replace the relay.
Brought to you by BirfMark
Brought to you by BirfMark
Version 1.11 - 03/16/2010
