Air Bag Readiness Light
There is an air bag readiness light on the instrument
panel, which shows AIR
BAG. The system checks the
air bag’s electrical system for malfunctions. The light
tells you if there
is an electrical problem. The system
check includes
the air bag sensors, the air bag modules,
the wiring and the crash sensing and diagnostic module.
For more information on the air bag system, sed “Air
Bag” in the Index.
AIR
BAG
You will see this light flash
for a few seconds when you
turn your ignition to
RUN
or START. Then the light
should go out. This means
the system is ready.
If the air bag readiness light doesn’t come on when you
start your vehicle, or stays on, or comes on when you
are driving, your air bag system may not work properly.
Have your vehicle serviced right away.
Voltmeter
I p4
You can read battery
voltage on
your voltmeter.
If it reads less than 11 volts
or more than 16 volts while
your engine
is running,
and it stays there, you may
have
a problem with the
electrical charging system.
Have it checked right away. Driving with the voltmeter
reading in a warning zone could drain your battery.
If you idle your engine for a while, the voltmeter
reading might move into the yellow zone, If the reading
stays in the yellow zone while you are driving, you may
have a problem with the electrical charging system.
Have it checked. While the voltmeter reads in the
yellow
zone, your battery may not be able to power certain
electrical accessories,
like ABS. (If this happens, your
ABS INOP light will come on. See “Anti-Lock Brake
System Warning Light” in this
part.)
If you must drive a short distance with the voltmeter
reading in a warning zone,
turn off all your accessories,
including your comfort control and audio system.
ProCarManuals.com
Brake System Warming Light
Your Pontiac’s hydraulic brake system is divided into
two parts. If one part isn’t working, the other part can
still work and stop
you. For good braking, though, you
need both parts working well.
If the warning light comes on, there could be a brake
problem. Have your brake system inspected right away.
BRAKE
This light should come on
briefly when you turn the
ignition key
to RUN. If it
doesn’t come on then,
have it-fixed so it will be
ready to warn you if there’s
a problem.
If the light comes on while you are driving, pull off the
road and
stop carefully. You may notice that the pedal is
harder to push. Or,
the pedal may go closer to the floor.
11 may take longer to stop. IE the light is still on, or if the
anti-lock brake system warning light is flashing, have
the vehicle towed for service. (See “Anti-Lock Brake
System Warning Light”
and “Towing Your Vehicle” in
the Index.)
Your brake system may not be working properly
if the brake system warning light is on. Driving
with the brake system warning light on can lead
to an accident. If the light is still on or if the
anti-lock brake system warning light is flashing
after you’ve pulled
off the road and stopped
carefully, have the vehicle towed for service.
When the ignition is on, the brake system warning light
will also come on when you set your parking brake. The
light will stay on if your parking brake doesn’t release
fully.
If it stays on after your parking brake is fully
released,
it means .;.; -< . . you have a brake problem. ?>- ?-L,- .‘ ., : .
Anti-Lock Brake System Warning Light
ABS
INOP
With the anti-lock brake system, this light will
come on when you start
your engine and it will
stay on for three seconds.
That’s normal.
,4 :._ :< If he fight flashes when driving, fbu ~~$~~~~e
anti-lock brakes and there could be a problem with your
regular brakes. Pull
off the road and stop carefully. You
may notice that the pedal is harder to push.
Or, the pedal
Have the vehicle towed for service. (See “Towing
Your
Vehicle” in the Index.)
, may go closer to the floor. It may take longer to stop.
Your regular brake system may not be working
properly
if the anti-lock brake system warning
light is flashing. Driving with the anti-lock
brake system warning light flashing can lead
to an accident. After you’ve pulled
off the road
and stopped carefully, have the vehicle towed
for service.
If the anti-lock brake system warning light stays on
longer than normal after you’ve started your engine, turn
the ignition
off. Or, if the light comes on and stays on
when you’re driving, stop as soon as possible and turn
the ignition off. Then start the engine again to reset
the
system. If the light still stays on, or comes on again
while you’re driving, your Pontiac needs service.
If the
light is on but not flashing and the regular brake system
warning light isn’t on, you still have brakes, but you
don’t have anti-lock brakes.
The anti-lock brake system warning light should come
on
briefly when you turn the ignition key to RUN. If the
light doesn’t come on then, have it fixed so it will be
ready to warn you
if there is a problem.
2-79
ProCarManuals.com
Traction Control System Warning Light (Option)
T’CS
OFF
This warning light should
come on briefly as you start
the engine.
If the warning
light doesn’t come on then,
have it fixed
so it will be
ready to
warn you if there’s
a problem.
I. . . -,.L-,-
If it stays on, or comes‘0n’’when you’re driving, there
may be a problem with
your traction control system and
your vehicle may need service. When this warning light
is
OW, the system will not lifnit wheel spin. Adjust your
driving accordingly.
If your brakes begin to overheat, the brake portion of the
traction control system will shut down, but the throttle
and engine spark control wiil continue to work. The
warning light will not
come on when this happens.
The traction control system warning light may come on
for the following reasons:
If you turn the system off by pressing the button
located on the center of the console behind the shift
lever (Automatic Transmission) or in front of the
shiftboot (Manual Transmission), the warning light
will
come on and stay on. To turn the system back
on, press the button again. The warning light should
go
off. (See “Traction Control System’’ in the Index
for more information.)
If the temperature of the throttle control begins
to rise, the system will turn off and the warning
light will come on until the system cools down.
The system,does this
to prevent damage from
overheating.
If the tmchan CQII~XQ~ system warning light comes on
and stays on
for an extended period of time when the
system is turned on, your vehicle needs service.
ProCarManuals.com
Low Traction Light
LOW
TRAC
When your anti-lock system
is adjusting brake pressure
to help avoid a braking skid,
this light will come on.
If you have the traction control system, this light will
also come on when the system is limiting wheel spin.
Slippery road conditions may exist if the low traction
light comes
on, so adjust your driving accordingly. The
light will stay on for a few seconds after the anti-lock
system stops adjusting brake pressure or the traction
control system stops limiting wheel spin.
The low traction light also comes
on briefly wlien you
turn the ignition key to
RUN. If the light doesn’t come
on then, have
it fixed so it will be there to tell you
when the anti-lock brake system or traction control
system
is active.
Engine Coolant Temperature Gage
This gage shows the engine
coolant temperature.
If ’
‘the gage pointer moves
into the red area, your
engine is too hot! It means
that your engine coolant
has overheated.
If you have been operating your vehicle under normal
driving conditions, you should pull
off the road, stop
your vehicle and turn
off the engine as soon as possible.
In “Problems on the Road”, this section
shows what to
do. See “Engine Overheating” in the Index.
ProCarManuals.com
Low Coolant Light (V8 Engine)
LOW
COOLANT
I
This warning light should
come on while
you are
starting your engine. If the
light doesn’t come on, have
it repaired.
Your Firebird
is equipped with a LOW COOLANT
indicator which is designed to detect when the coolant
level
drops below set limits. If the low coolant level
sensor (on the radiator)
drops while the engine is
running, ‘the LOW COOLANT indicator will light
and remain lit until the ignition switch is turned to
the
OFF position. Check coolant level and add coolant
as needed. The LOW COOLANT light might stay on
after filling the radiator., Turn the ignition switch to the
OFF position, then restart the engine to verify that the
LOW COOLANT light goes out. See “Engine Coolant”
in the Index.
~
NOTICE:
Driving with the LOW COOLANT light on could
cause your Pontiac to overheat. See “Engine
Overheating’’
in the^ Index. Your Pontiac could be
damaged md it wouldn’t be covered by your
warranty.
2-82
ProCarManuals.com
Malfunction Indicator Lamp (Service Engine Soon Light)
SERVICE
ENGINE
SOON
Your Pontiac is equipped
with a computer which
monitors operation of the
fuel, ignition and emission
control systems.
. . , , ..** , .- ,_ , . ,I , - . 'G, .. .. . .. .-
This system is called OBD I1 (On-Board
Diagnostics-Second Generation) and is intended to
assure that emissions are at acceptable levels for the life
of the vehicle, helping to produce a cleaner
environment. (In Canada, OBD
11 is replaced by
Enhanced Diagnostics.) The SERVICE ENGINE SOON
light comes on to indicate that there is a problem and
service
is required. Malfunctions often will be indicated
by the system before any problem is apparent, which
may prevent more serious damage to your vehicle. This
system
is also designed to assist your service technician
in correctly diagnosing any malfunction.
NOTICE:
If you keep driving your vehicle with this light
on, after a while, your emission controls may not
work as well, your fuel economy may
not be as
good and your engine may not run as smoothly.
This could lead to costly repairs that may not be
covered by your warranty.
This light should come on, as a check to show you it is
working, when the ignition is on and the engine is not
running:If the light doesn't come on, have it repaired.
This light will also come on during a malfunction in one
of two ways:
0 Light Flashing -- A misfire condition has been
detected.
A misfire increases vehicle emissions and
may damage the emission control system on your
vehicle. Dealer or qualified service center diagnosis
and service
is required.
0 Light On Steady -- An emission control system
malfunction has been detected on your vehicle.
Dealer
or qualified service center diagnosis and
service may be required.
~ 2-83
ProCarManuals.com
If the Light Is Flashing
The following may prevent more serious damage to
your s&ide:
Reduce vehicle speed.
Avoid hard accelerations.
Avoid steep uphill grades.
If towing a trailer, reduce the amount of cargo being
hauled
as soon as it is possible.
If the light stops flashing and remains on steady, see “If
the Light Is On Steady” following.
If the light continues to flash, whenit is safe to do so, ’
stop the vehicle. Put your vehicle in PARK (P). Turn the
key
off, wait at least 10 seconds and restart the engine.
If the light remains on steady, see “If the Light Is On
Steady” following.
If the light is still flashing follow the
previous steps, and drive the vehicle to your dealer or
*qualified service center for service.
If the Light Is On Steaay
You may be able to correct the emission system
malfunction by considering
the following:
Did you just put
fuel into your vehicle?
If so, reinstall the fuel cap, making sure to fully install
the cap. The diagnostic system can determine if the fuel
cap has been left
off or improperly installed. This will
dow fuel to evaporate into the atmosphere. A few
driving trips
should turn the light off.
Did you just drive through a deep puddle of water?
If so, your el’ectrical system may be wet. The condition
will usually
be corrected when the electrical system
dries
out. A few driving trips should turn the light off.
Are you low on fuel?
As your engine
starts to run out of fuel, your engine may
not bun as efficiently as designed since small amounts of
air are sucked into the fuel line causing a misfire. The
system can detect this. Adding fuel should correct this
condition. Make sure to install the fuel cap properly. It
will take a few driving trips to turn the light off.
ProCarManuals.com