1996 PONTIAC FIREBIRD key battery

0
0
Your vehicle is equipped with a crash sensing and
diagnostic module, which records information
about the air bag system.
The module records
information about the readiness of the system,
when the sensors are activated and driver’s safety
belt usage at deployment.
Let only qualified technicians work
on your air bag
system. Improper service can mean that your air
bag system won’t work properly. See your dealer
for service.
~~
NOTICE:
If you damage the cover for the driver’s or the
right front passenger’s air bag, they may not
work properly. You may have to replace the air
bag module in the steering wheel or both the
air
bag module and the instrument panel for the
right front passenger’s air bag.
Do not open or
break the air bag covers.
Servicing ,Your Air Bag-Equipped Pontiac
Air bags affect how your Pontiac should be serviced.
There are
parts of the air bag system in several places
around your vehicle. You don’t want the system to
inflate while someone is working on your vehicle. Your
Pontiac dealer and the Firebird Service
Manual have
information about servicing your vehicle and the air bag
system.
To purchase a service manual, see “Seririce and
Owner Publications” in the Index.
I A CAUTION:
II
For up to 10 minutes after the ignition key is
turned off and the battery is disconnected, an air
bag can still inflate during improper service. You
can be injured if you are close to an air bag when
it inflates. Avoid wires wrapped with yellow tape
or yellow connectors. They are probably part of
the
air bag system. Be sure to follow proper
service procedures, and make sure’ the person
performing work for you is qualified to do
so.
’he air bag system does not need regular maintenance.
ProCarManuals.com

Leaving Your Vehicle
If you are leaving the vehicle, take your keys, open your
door and set the locks from inside. Then get out and
close the door.
Remote Lock Control (Option)
3-Button Transmitter 4-Button Transmitter
If your Pontiac has this option, you can lock and
unlock your doors or unlock your hatch up to about
30 feet (9 m) using the key chain transmitter supplied
with your car. Your
Remote
Lock Control operates on a radio
frequency subject to Federal Communications
Commission (FCC) Rules.
This device complies with Part
15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired
operation.
Should interference to this system occur, try this:
Check to determine if battery replacement is
necessary. See the instructions on battery
replacement.
vehicle. This product has a maximum range.
be blocking the signal.
Cheek the distance. You may be too far from your
Check the location. Other vehicles or objects may
See your Pontiac dealer or a qualified technician
Changes or modifications to this system by other than
an authorized service facility could void authorization to
use this.equipment.
for
service.
ProCarManuals.com

Manual transmission
The gear selector should be in NEUTRAL (N).’Hold the
clutch pedal to the floor and start the engine. Your
vehicle won’t start
if the clutch pedal is not all the way
down
-- that’s a safety feature.
Starting Your 3800 Engine
1. Without pushing the accelerator pedal, turn your
ignition key to START. When the engine starts, let
go of the key. The idle speed will go down as your
engine gets
warm.
NOTICE:
Holding your key in START for longer than
15 seconds at a time will cause your battery to be
drained much sooner.
And the excessive heat can
damage your starter motor.
2. If it doesn’t start right away, hold your key in
START for about three to five seconds at a time until
your engine starts. Wait about
15 seconds between
each try to help avoid draining your battery.
3. If your engine still won’t start (or starts but then
stops), it could be flooded with too much gasoline.
Try pushing your accelerator pedal all the way to the
floor and holding
it there as you hold the key in
START for about three seconds. If the vehicle starts
briefly but then stops again, do the same thing, but
this time keep the’ pedal down for five or six seconds.
This clears the extra gasoline
from the engine.
After waiting about
15 seconds, repeat the normal
starting procedure.
NOTICE:
Your engine is designed to work with the
electronics
in your vehicle. If you add electrical
parts or accessories, you could change the
way
the engine operates. Before .adding electrical
equipment, check with your dealer.
If you don’t,
your engine might not perform properly.
If you ever have to have your vehicle towed, see
the part
of this manual that tells how to do it
without damaging
your vehicle. I See c6To~g
Your Vehicle” in the Index.
2-24
ProCarManuals.com

Starting Your 5.7 Liter LT1 Engine
1. Without pushing the accelerator pedal, turn the
ignition key to START. When the engine starts,
let
go of the key. The idle speed will go down as your
engine gets warm.
NOTICE:
Holding your key in START for longer than
15 seconds at a time will cause your battery to be
drained much sooner. And the excessive heat can
damage your starter motor.
2. If it doesn't start wihn 10 seconds, push the
accelerator pedal
all the way to the floor, while you
hold the ignition key in START. When the engine
starts, let go of the key and let up on the accelerator
pedal. Wait about
15 seconds between each try to
help avoid draining your battery.
When starting your engine in very cold weather (below
0°F or -18"C), do this:
1. With your foot off the accelerator pedal, turn the
ignition key to START and hold it there. When the
engine starts,
let go of the key. Use the accelerator pedal
to maintain engine speed, if you have to, until
your engine
has run for a while.
stops), it could be flooded with too much gasoline.
Try pushing your accelerator pedal
all the way to the
floor and holding it there as you hold the key in
START for about three seconds. If the vehicle starts
briefly but then stops again, do the same thing, but
this time keep the pedal down for five or six seconds.
This clears the extra gasoline from the engine.
2. If your engine still won't start (or starts but then
I NOTICE:
Your engine is designed to work with the
electronics in your vehicle.
If you add electrical
parts or accepsories, you could change the
way
the engine operates. Before adding electrical
equipment, check with your dealer.
If you don't,
your engine might not perform properly.
If you ever have to have your vehicle towed, see
the part of this manual that tells how to do
it
without damaging your vehicle. See 4'Towing
Your Vehicle" in the Index.
2-25
ProCarManuals.com

Interior Lamps
Instrument Panel Brightness Control
This switch controls the brightness of your
instrument panel lights. Turn the switch to brighten
or
dim the lights. If you turn the switch all the way up your
courtesy lamps will come on.
Courtesy Lamps
When any door is opened, several interior lamps go on.
These lamps are courtesy lamps. They make it easier for
you to enter and leave your vehicle.
Courtesy lamps include the dome lamp and other
lamps
throughout the interior of your vehicle.
To prevent battery rundown, your interior lamps will be
disabled about
10 minutes after the ignition is turned to
OFFm The 10 minute timer will be restarted if you do any
of the following:
1. Turn the ignition on.
2. Open either door.
3.
4.
5.
Press any button on your Remote Lock
Control transmitter.
Turn the interior lamp switch from off to on.
Open the hatch.
Delayed Illumination (Option)
With delayed illumination, when you open a door, your
courtesy lamps will come
on and stay on for 25 seconds
after the doors
are closed. The 25 seconds is shortened
if the ignition is turned to
the RUN position or if the
power locks
are activated. To turn this feature on or off,
see “Feature Customization” in the Index.
Exit Lighting (Option)
With exit lighting, the interior lamps will come on when
you remove the key from the ignition to help you see
while exiting the vehicle. To turn
this feature on or off,
see “Feature Customization” in the Index.
..
ProCarManuals.com

5. Push and hold the top
of the convertible
top switch.
6. Pull down on center opening and align hooks with
holes. Push forward on the larger part of the latch until
it clicks.
Do not force the latch. If it is hard to
lock, the top is not properly aligned.
If
your vehicle suffers a power loss, such as a dead
battery, you can still raise or lower the top manually by
rotating the valve in the left side
of the trunk.
Open the
trunk and find the tab along the left side trim
panel. Lift up the tab and turn the valve clockwise to
release the hydraulic pressure. Turn the ignition
key to
the LOCK position. You can now raise or lower your top
manually. Be sure to close
the valve after installing your
top
so you can raise or lower it electronically later.
ProCarManuals.com