1996 Oldsmobile Cutlass Supreme clock

Filling Your Tank The cap. is behind a hinged door on the left side of
your vehicle.
I A CAUTION:
Gasoline vapor is highly flammable. It burns
violently, and that can cause very bad injuries.
Don’t smoke
if you’re near gasoline or refueling
your vehicle. Keep sparks, flames, and smoking
materials away from gasoline.
While refueling, hang the
cap inside the fuel door.
To take off the cap, turn it slowly to the left
(counterclockwise).

7. Plug the electrical connector into the headlamp socket. Headlamps (4-Door Models)
Make sure the locking: tabs snap onto the socket. v L
8. Put the new headlamp in position.
0 Make sure the socket points in the same direction
as it did with the old headlamp.
9. Insert the tabs on the
aiming ring into
the slots in the
headlamp assembly.
WI 1. Turn the socket counterclockwise one-sixth of a turn
until the tabs on the bulb socket align with the slots
in the housing.
10. Holding the aiming ring closed, insert the screws at the 2. pull out the bulb socket.
end of the ring. Tighten the screws until the aiming ring
touches the plastic nuts on both the top and bottom.
0 Do not overtighten.
Do not damage the vertical aiming bubble.
6-32
I

3. Lift the plastic locking
tab on the electrical
.connector and pull the connector from the
bulb socket.
4.
5.
Snap the electrical connector into a new bulb socket.
Replace the bulb socket into the housing and
turn clockwise.
Headlamp Aiming
This section only -applies to two-door Oldsmobiles. If
you have a four-door Oldsmobile, see your retailer when
your headlamp aim needs to be checked or adjusted.
6-33

2.
3.
Squeeze the tab
on the socket.and
turn the socket
counterclcsckwise-;
.
Pud out the socket.
.. Jj
4. ell the bulb out of the socket.
5. Push in a new bulb.
.6. Replace the socket into the housing and
tum clockwise. ..
7. Reposition the carpet.and tighten the plastic screws. G>;J;L~ + '... .,::.,,j1 !,.
I p <+: ..< .-\' ', 6 , : :L
1. Remove the two. large plastic screws and pull the
carpet away,from the rear corner
of the trunk.

9
2. Remove the two wing nuts. 3. Pull the taillamp housing away from the body of
the vehicle.
4. Squeeze the tab on the socket and turn the socket
counterclockwise.

.. .. ..
5; Pull out the socket.^ W’indshied’wiper Blade‘Replacement
6. Pull the buIb out of
the socket.
7. Push innew bulb. .’
.’ 8. ’ .Replace the socket into the housing and
turn clockwjse. -
9. Replace the .taillamp housing to -the body of
the vehicle.
10. Install the two wing nuts.
1.1. Reposition the carpet and tighten the plastic screws.
3. Push the new wiper blade securely onto the
Fog Lamps I wiper arm/‘
Don’t trY to change a fog lamp bulb unless.You have the
For replacement wiper blade length and type; see
proper aiming. equipment.
See your Oldsmobile retailer. “Reeplacement Parts” in the Index. -
6-41

.
_I
1.
..
PedalTravel 6-29 ..................................
.Replacing System Parts ................ ; ...... .. 6-29
'System Warning Light
.......................... 2-47
Trailer
........................................ 4-32
Transaxle Shift Interlock
... i .. : ................. 2-22.
Y
Transaxle Shift Interlock Check ................... 7-38
.. Wear ....................................... 6-28
Braking
......................................... 4-5
Braking in Emergencies
............ 1 ............... 4-8
Bre&-In. New Vehicle
........................... 2-10
Brightness Control
.............................. 2-33
kulb Replacement
............................... 6-30
BTSI
........................................... 2-22
BTSICheck
................................... 7-38
Chadian Roadside Assistance .I ................... 8-5
Capacities and Specifications ........................ 6-69
..Cassette Deck Service
........................... 7-36
Cassette Tape Player
..... .I ............ ; ........... 3-10
Cassette Tape Player Errors
.................... 3-12, 3-17
. .. ~ Carbon Monoxide .................... 2-22.4-26. 4-32
Cassette Tap.e Player Care
.. ..................... 3-27
.. CD Player Theft-Deterrent Feature ................. 3-23
$enter High-Mounted Stoplamp
............... 6-36, 6-37
Center Passenger Position
......................... 135
Certification Label
.............................. 4-27 Securing in a Rear Outside $eat Position
....... , l-40, 1-412
Securing in the Center Rear Seat Position .......... 1-44 ..
Securing in the Passenger
Seat, Position 1-46
Securing in the Right Front Seat Position 1-46 .. .........
. TopStrap ................................... 1-39
.Where to
Put ............................... ... 1-38
Cigarette Lighter .............. .; ................ ' 2-39:
Circuit Breakers and Fuses
........................ 6-61
Cleaner.
Air 646 ............................... ..
Cleaning
Fabric
..... .................................. 6-50
Inside
of Your Oldsmobile ......... : ... .' ...... : . 6-50
Instrument Panel
......................... ... ' . 6-53
Leather
.....................................'6-53
. ...........
..
..
... 1
Aluminum Wheels .. .-. ........................ 6-56
Glass
........................................ 6-54
Outside
of Your Oldsmobile .................... 6-55
Special Problems
.............................. 6-52 ..
stains ....................................... 6-50
. Tires .............. : ............................. 6-56
Viiyl ............................... : ........... 6-53
Wheels
............................. : ... : .... 6-56
Windshield and Wiper Blades
.................... 6-54
Climate Control. Steering Wheel Touch Control ........ 3-9
Climate Control System
............................ '3-1
Clock. Setting the
................................. 3-9