1996 Mercury Villager clock

Roadside Emergencies
261
*
[RE05200(ALL)03/95]
Spare Tire Location
[RE05300(ALL)01/93]
The spare tire is stored underneath your vehicle.
%*
[RE05400(ALL)02/95]
To remove the spare tire:
*
[RE05500(ALL)01/93]1.
Open the liftgate and find the plastic hex nut cover in the
carpeting of the cargo area. Lift the cover to expose the hex
nut.
[RE05600(ALL)09/93]
17-1/2 pica
art:0040171-A
The spare tire hex nut
*
[RE05700(ALL)01/93]2.
Find the tapered lug wrench in the tool kit located behind
the jack in the right cargo area side panel.
*
[RE05800(ALL)12/93]3.
Fit the hex-shaped end of the lug wrench over the hex nut
in the floor of the cargo area. Turn counterclockwise until
the cable extends far enough to lower the spare tire to the
ground.
File:12vxren.ex
Update:Tue Jun 4 11:42:14 1996

262
*
[RE05900(ALL)09/93]
10-1/2 pica
art:0040172-B
The spare tire in the lowered position
*
[RE06000(ALL)01/93]4.
Continue to turn the hex nut counterclockwise until the
spare tire retainer can be seen for removal.
*
[RE06100(ALL)01/93]5.
Remove the retainer from the center of the wheel. It may be
necessary to lift one end of the tire to disengage the retainer.
*
[RE06200(ALL)09/93]
10-1/2 pica
art:0040173-B
Removing the spare tire retainer
File:12vxren.ex
Update:Tue Jun 4 11:42:14 1996

Roadside Emergencies
263
*
[RE06300(ALL)01/93]
Stowing the spare tire
[RE06400(ALL)04/95]1.
To raise the tire to the stowed position, lay the tire on the
ground with the inboard side facing up. Install the retainer
through the wheel center and slide the tire under the vehicle.
Fit the hex-shaped end of the wheel lug wrench over the hex
nut in the floor of the cargo area. Turn the wheel lug
wrench clockwise until the tire is raised to its original
position underneath the vehicle.
[RE06500(ALL)01/93]
NOTE: The lug wrench ratchets when the tire is raised to the
stowed position. It will not allow you to over-tighten.
*
[RE06600(ALL)01/93]2.
Check for proper seating against the underbody supports
and retighten if necessary.
*
[RE06700(ALL)05/95]
RWARNING
Make sure spare tires and jacking equipment are stowed
and secured in the proper storage location.
*
[RE06800(ALL)03/95]
Preparing to Change the Tire
*
[RE06900(ALL)05/94]
You should only raise your vehicle with a jack properly placed
at the front or rear jacking points.
*
[RE07000(ALL)06/95]1.
Make sure that your vehicle will not move or roll. Put the
gearshift lever in P (Park). Set the parking brake and block
the wheel Ð in both directions Ð that is diagonally opposite
the tire that you are changing.
*
[RE07100(ALL)06/95]
RWARNING
When one of the front wheels is off the ground, the
transaxle alone will not prevent the vehicle from moving
or slipping off the jack, even if the vehicle is in P (Park).
File:12vxren.ex
Update:Tue Jun 4 11:42:14 1996

Roadside Emergencies
267
[RE07900(ALL)09/93]
13-1/2 pica
art:0040181-B
Removing the optional wheel cap
*
[RE08000(ALL)02/95]4.
Fit the hex-shaped end of the lug wrench over the wheel lug
nuts and loosen them one-half turn (counterclockwise). Do
not remove the wheel lug nuts until you raise the tire off the
ground.
*
[RE08100(ALL)02/95]
If your vehicle has the optional locking lug nuts, you must
use the lug nut removal tool provided with your vehicle's
tool kit.
*
[RE08200(ALL)02/95]
7-1/2 pica art:0040182-A
Anti-theft lug nut
*
[RE08300(ALL)01/93]5.
Fit the jack under the proper jacking point indicated by the
notch in the bottom of the door frame panel.
File:12vxren.ex
Update:Tue Jun 4 11:42:14 1996

270
[RE09100(ALL)09/93]
17-1/2 pica
art:0040175-B
The jack and handle assembly
*
[RE09200(ALL)01/93]7.
Turn the lug nut wrench (attached to the jack handle)
clockwise to raise the vehicle off the ground.
*
[RE09300(ALL)01/93]8.
Remove the wheel lug nuts with the lug nut wrench.
*
[RE09400(ALL)01/93]9.
Remove the flat tire and replace it with the spare tire.
*
[RE09500(ALL)05/94]10.
Place the wheel lug nuts on the spare tire. Use the lug nut
wrench to screw the lug nuts snug against the wheel, but do
not tighten fully.
*
[RE09600(ALL)02/95]11.
Lower the vehicle by turning the jack handle
counterclockwise.
*
[RE09700(ALL)01/93]12.
Use the wheel lug wrench to tighten lug nuts in the
appropriate sequence. Re-check for complete tightness.
File:12vxren.ex
Update:Tue Jun 4 11:42:14 1996

Servicing Your Villager
305
*
[SV07160(ALL)06/95]4.
Replace the fuel cap tightly when you are finished. Turn it
clockwise until you hear at least three clicks. The ratcheting
mechanism allows the fuel cap to be sealed without
overtightening.
*
[SV07170(ALL)10/95]5.
Push the fuel door closed.
%*
[SV07200(ALL)06/95]
Choosing the Right Fuel
[SV07300(ALL)05/96]
Use only UNLEADED FUEL. The use of leaded fuel is
prohibited by law and could damage your vehicle. The damage
may not be covered by your warranty.
[SV07350(ALL)05/96]
Your vehicle was not designed to use fuel containing
manganese-based additives such as MMT. Additionally, vehicles
certified to California emission standards (indicated on the
underhood vehicle Emissions Control Information label) are
designed to operate on California reformulated gasolines. If
California reformulated gasoline is not available when you
refuel, your vehicle can be operated on non-California fuels.
However, even though your engine will perform adequately on
other gasolines, the performance of the emission control devices
and systems may be adversely affected. Repair of damage
casued by using a fuel that your vehicle was not designed for
may not be covered by your warranty.
[SV07370(ALL)05/96]
Octane recommendation
[SV08000(ALL)05/96]
Your vehicle is designed to use regular gasoline with an
(R+M)/2 octane rating of 87. We do not recommend gasolines
labeled as ªregularº in high altitude areas that are sold with
octane ratings of 86 or even less.
File:15vxsvn.ex
Update:Wed Jun 5 12:25:18 1996

350
[SV40600(ALL)09/93]
13-1/2 pica
art:0040222-B
The headlamp bulb assembly
[SV40700(ALL)01/93]3.
Remove the bulb retaining ring by turning it
counterclockwise 1/8 of a turn to free it from the socket.
Then slide the ring off the plastic base. Keep the ring.You
must use it again to hold the new bulb in place.
File:15vxsvn.ex
Update:Wed Jun 5 12:25:18 1996

388
Chime
headlamps on.................... 77
key in ignition.................... 58
safety belt...................... 70
Circuit breakers
checking and replacing............... 346
see also fuses.................... 337
Cleaning your vehicle
chrome and aluminum parts.............. 7
engine compartment................. 302
exterior....................... 6
exterior lamps................... 114
fabric....................... 165
headlamps..................... 114
instrument panel................... 7
plastic parts..................... 7
polishing....................... 6
rustproofing..................... 7
safety belts...................... 23
tail lamps..................... 114
upholstery and interior trim............. 165
washing....................... 6
waxing........................ 6
wheels....................... 329
Climate control system
air conditioning.................... 91
heating........................ 91
Clock......................... 217
Clutch, fluid reservoir................. 333
Cold engine starting................... 60
Combination lap and shoulder belts........... 9,11
Controls
instrument panel................... 89
mirrors....................... 169
steering column................... 123
File:vxixn.ex
Update:Fri Jun 7 09:28:47 1996