1996 Mercury Villager check engine light

62
*
[ST08200(ALL)05/95]
A computer system controls the engine's idle speed. When you
start your vehicle, the engine's idle speed normally runs high.
These faster engine speeds will make your vehicle move slightly
faster than its normal idle speed. It should, however, slow down
after a short time. If it does not, have the idle speed checked.
*
[ST08290(ALL)06/95]
If the engine idle speed does not slow down automatically, do
not allow your vehicle to idle for more than 10 minutes. Have
the vehicle checked.
*
[ST08300(ALL)05/95]
RWARNING
Extended idling at high engine speeds can produce very
high temperatures in the engine and exhaust system,
creating the risk of fire or other damage.
*
[ST08400(ALL)05/95]
RWARNING
Do not park, idle, or drive your vehicle in dry grass or
other dry ground cover. The emission system heats up
the engine compartment and exhaust system, which can
start a fire.
*
[ST08500(ALL)03/95]
If you consistently start your vehicle in subzero temperatures,
use an engine block heater (if your vehicle has this option).
%*
[ST08600(ALL)06/95]
Engine Block Heater (If equipped)
[ST08700(ALL)02/95]
Engine block heaters are strongly recommended if you live in a
region where temperatures reachs10ÊF (s23ÊC) orbelow. An
engine block heater warms the engine coolant, which improves
starting, warms up the engine faster, and allows the
heater-defrost system to respond more quickly.
*
[ST08900(ALL)05/95]
RWARNING
To prevent electrical shock, do not use your heater with
ungrounded electrical systems or two-pronged (cheater)
adapters.
File:04vxstn.ex
Update:Mon Jun 3 08:20:06 1996

64
*
[ST09035(ALL)05/95]
RWARNING
If you see or smell fuel, do not reset the switch or try to
start your vehicle. Have all the passengers get out of the
vehicle and call the local fire department or a towing
service.
*
[ST09040(ALL)02/95]
If your engine cranks, but does not start after a collision:
*
[ST09045(ALL)02/95]1.
Turn the key in the ignition to the OFF position.
*
[ST09050(ALL)03/95]2.
Check under the vehicle for leaking fuel.
*
[ST09055(ALL)02/95]3.
If you do not see or smell fuel, push the fuel pump shut-off
reset button down. If the red button is already set, you may
have a different mechanical or electrical problem.
*
[ST09060(ALL)02/95]4.
Turn the ignition key to the ON position for a few seconds,
then turn it to the OFF position.
*
[ST09065(ALL)02/95]5.
Check under the vehicle again for leaking fuel. If you see or
smell fuel, do not start your vehicle again. If there is no fuel,
you can try to start your vehicle again.
*
[ST09070(ALL)02/95]6.
Check all vehicle warning lights before driving your vehicle.
%*
[ST09100(ALL)05/95]
Guarding Against Exhaust Fumes
*
[ST09200(ALL)02/95]
Carbon monoxide, although colorless and odorless, is present in
exhaust fumes. Take precautions to avoid its dangerous effects.
*
[ST09300(ALL)02/95]
RWARNING
Never let your vehicle idle in an enclosed area, and do
not sit in a parked vehicle, (with the engine running) for
more than a short period of time. Exhaust fumes,
particularly carbon monoxide, might build up. These
fumes are harmful and could kill you.
File:04vxstn.ex
Update:Mon Jun 3 08:20:06 1996

Warning Lights and Gauges
69
[LG00800(ALL)01/93]
The following warning lights and gauges are on the mechanical
cluster. All of the warning lights and gauges alert you to
possible problems with your vehicle. Some of the lights listed
are optional. The following section explains what each of these
indicators means.
*
[LG00850(ALL)01/95]
Indicator Lights and Chimes
*
[LG00900(ALL)06/95]
Brake System Warning Light
*
[LG01000(ALL)03/95]
The warning light for the brakes can show two things Ð that
the parking brake is not fully released, or that the brake fluid
level is low in the master cylinder reservoir. If the fluid level is
low, the brake system should be checked by your dealer or a
qualified service technician.
[LG01100(ALL)09/93]
6 pica art:0040050-A
Brake system and parking brake light
[LG01200(ALL)01/93]
The BRAKE light normally comes on when you turn the
ignition key to the ON position to verify that the indicator bulb
is working. If the light stays on or comes on when the engine is
running and after you have released the parking brake fully,
have the hydraulic brake system serviced.
*
[LG01300(ALL)05/95]
RWARNING
The BRAKE light indicates that the brakes may not be
working properly. Have the brakes checked immediately.
File:05vxlgn.ex
Update:Tue Jun 4 11:35:19 1996

72
[LG02150(ALL)09/93]
6 pica art:0040262-A
Supplemental air bag readiness light
*
[LG02200(ALL)03/95]
Check Engine Warning Light
[LG02300(ALL)01/93]
This light comes on when the electronic engine control system is
not working properly. This is the computer that controls the
operating conditions of the engine.
[LG02400(ALL)09/93]
6 pica art:0040053-A
Check engine warning light
[LG02500(ALL)09/93]
This light comes on briefly when you turn the ignition key to
ON, but should turn off when the engine starts. If the light does
not come on when you turn the ignition to ON or if it comes
on and stays on when you are driving, have your vehicle
serviced as soon as possible. This indicates a possible problem
with one of the engine's emission control systems. You do not
need to have your vehicle towed.
*
[LG02600(ALL)05/95]
If the light turns on and off briefly while you are driving, it
means that the condition is no longer present.
File:05vxlgn.ex
Update:Tue Jun 4 11:35:19 1996

Warning Lights and Gauges
73
*
[LG02700(ALL)01/95]
Charging System Light
*
[LG02800(ALL)03/95]
This light, shown as a battery symbol on your cluster, indicates
that your battery is not being charged and that you need to
have the electrical system checked.
[LG02900(ALL)09/93]
6 pica art:0040054-A
Charging system light
[LG03000(ALL)01/93]
This light comes on every time you turn your ignition key to
the ON or START position. The light should go off when the
engine starts and the alternator begins to charge.
*
[LG03100(ALL)01/95]
If the light stays on or comes on when the engine is running,
have the electrical system checked as soon as possible.
%*
[LG03200(ALL)02/95]
Engine Oil Pressure Warning Light
[LG03300(ALL)04/94]
The oil pressure light is represented by an oil can symbol. It
indicates the engine's oil pressure, not oil level. However, if
your engine's oil level is low, it could affect the oil pressure.
The oil can symbol will flash if the oil pressure drops below the
normal operating level. When you turn the key to the ON
position, the light will illuminate.
[LG03400(ALL)09/93]
6 pica art:0040060-A
Oil pressure light
File:05vxlgn.ex
Update:Tue Jun 4 11:35:19 1996

74
[LG03500(ALL)04/94]
The light should turn off after a few seconds. If the light stays
on or illuminates when the engine is running Ð you have lost
oil pressure and continued operation will cause severe engine
damage.
[LG03550(ALL)02/95]
If you lose engine oil pressure:
[LG03600(ALL)02/95]1.
Pull off the road as soon as safely possible.
*
[LG03700(ALL)03/95]2.
Turn off the engine. If you do not stop the engine as soon as
safely possible, severe engine damage could result.
[LG03800(ALL)04/94]3.
Check the oil level following the instructions on checking
and adding engine oil in this owner guide. (SeeEngine oilin
the index.) Make sure your vehicle is on level ground.
[LG03900(ALL)01/93]4.
If the level is low, add as much oil as necessary before you
drive your vehicle again. Do not drive your vehicle if the oil
pressure light is on, even if the oil level is correct. For more
information about adding oil, seeEngine oil, checking and
addingin the Index.
%*
[LG04000(ALL)01/93]
Door Ajar Warning Light
*
[LG04100(ALL)08/94]
If the ignition switch is in the ON position and any door or the
liftgate is not completely closed, the light will illuminate.
[LG04200(ALL)09/93]
6 pica art:0040061-B
Door ajar warning light
File:05vxlgn.ex
Update:Tue Jun 4 11:35:19 1996

82
[LG09600(ALL)01/93]
The electronic cluster has all of the same warning lights as the
mechanical cluster, however, some of the gauges will be
electronic instead of analog. In addition, the electronic cluster
has a fuel computer for measuring fuel economy, distance to
empty and outside air temperature.
*
[LG09700(ALL)01/95]
Engine Coolant Temperature Gauge
[LG09800(ALL)01/93]
This gauge shows you the temperature of the engine coolant
and is identified by a thermometer symbol. The letter H means
that the coolant is hot, C means that it is cold, and NORMAL
means that the coolant is within the normal operating range.
[LG09900(ALL)09/93]
The indicator bar on the graph will move into the normal
operating range as the engine warms up. When you are in
heavy traffic or stop-and-go driving in hot weather, the gauge
may read at the very top of the NORMAL range. This is
acceptable.
[LG10000(ALL)09/93]
However, if the indicator bar on the graph moves into the
H (hot) position, the engine is overheating and may cause
engine damage. If this happens, you should stop your vehicle as
soon as safely possible. Turn off the engine and let it cool.
Check the coolant level to be sure that it is at the proper level.
If your vehicle needs more coolant, seeEngine coolant, checking
and addingin the Index and read the section regarding adding
coolant.
File:05vxlgn.ex
Update:Tue Jun 4 11:35:19 1996

Driving Your Villager
235
*
[DR06800(ALL)01/93]
Four-Wheel Anti-lock Brakes
*
[DR06900(ALL)01/94]
The Anti-lock Brake System (ABS) prevents wheels from
completely locking up by automatically releasing and
re-applying the brakes. During ABS braking, slight brake pedal
pulsations may be felt on the driver's foot. These pulsations
represent the rapid cycling of the ABS valves. The pedal
pulsations are considered normal ABS operation, and will stop
when normal braking is resumed or when the vehicle comes to
a stop.
%*
[DR07000(ALL)12/93]
During ABS activation, a mechanical noise may be heard as the
ABS system cycles. This is normal ABS operation.
*
[DR07100(ALL)12/93]
The ABS system has self-check capabilities. The system turns on
the ABS warning light each time you start the engine. After the
engine is started and the ABS warning light turns off, the
system performs another test the first time the vehicle reaches
4 mph (6 km/h). A mechanical noise may be heard as the ABS
system performs a self test. This is a normal part of the self test
feature. If a malfunction is found during this check, the ABS
warning light will come on.
*
[DR07200(ALL)12/93]
You should always be careful when braking, even if your
vehicle has the ABS system. Heavy braking on roads with loose
surfaces such as snow or gravel, or roads with severe pavement
irregularities could also cause you to lose control of your
vehicle.
*
[DR07300(ALL)05/95]
RWARNING
If the anti-lock brake system warning light remains on or
comes on while driving, have the braking system checked
by a qualified service technician as soon as possible.
*
[DR07310(ALL)06/95]
NOTE: If a fault occurs in the anti-lock system, and the brake
warning light is not lit, the anti-lock system is
disabled but normal brake function remains
operational.
File:11vxdrn.ex
Update:Tue Jun 4 11:42:50 1996