1996 Mercury Villager clock

Instrument Panel Controls
91
[IP01400(ALL)01/93]
The controls for the climate control systems, headlamps, clock,
radio, rear window washer and wiper, hazard flasher, power
switch, and speed control are all on the instrument panel.
*
[IP01500(ALL)01/93]
Climate Control Systems
[IP01600(ALL)04/95]
13-1/2 pica
art:0040301-A
Climate control system panel
[IP01700(ALL)01/93]
Function Selector Buttons
[IP01800(ALL)01/93]
There are six function selector buttons: OFF, Mix, Defrost, Panel,
Panel/Floor, and Floor. When you press a function selector
button, the indicator light on the button will illuminate. If your
vehicle is equipped with a rear passenger compartment climate
control system, the instrument panel will also include a rear seat
function selector lever.
[IP01900(ALL)04/94]
n
The OFF button shuts off the air supply to all outlets and
stops all fan operations. Use this setting when driving
through an area where outside air is unpleasant or dusty.
File:06vxipn.ex
Update:Mon Jun 3 14:33:05 1996

Instrument Panel Controls
121
[IP16600(ALL)01/93]
You can turn the map lamps on and off by pressing the
switches next to the lamps.
*
[IP16700(ALL)05/95]
Radio
[IP16800(ALL)04/94]
For information about the radio in your vehicle, refer to the
Electronic Sound Systemschapter in this owner guide.
[IP16901(ALL)09/93]
Clock Controls on Electronic Radios
[IP17000(ALL)04/94]
The electronic radios have a built-in clock. For complete
operating instructions, refer to theElectronic Sound Systems
chapter in this owner guide.
*
[IP17300(ALL)05/92]
Radio Antenna
*
[IP17400(ALL)07/93]
The fixed radio antenna is mounted on the front fender on the
passenger's side of the vehicle.
*
[IP17500(ALL)04/95]
Power Antenna (If equipped)
[IP17600(ALL)09/93]
The power antenna is located on the front fender on the
passenger's side of the vehicle. It will automatically raise when
the radio is turned on and lower when the radio is turned off.
*
[IP17700(ALL)04/95]
NOTE: The radio must be turned off so that the antenna will
retract prior to entering a car wash. Failure to retract
the antenna could result in damage to the antenna,
antenna base, or vehicle.
[IP17750(ALL)04/95]
Cleaning the Instrument Panel Lens
*
[IP17760(ALL)04/95]
Clean the instrument panel lens with a soft cloth and a glass
cleaner, such as Ford Ultra-Clear Spray Glass Cleaner, or
equivalent. Do not use paper towel or any abrasive cleaner to
clean the lens as these may cause scratches.
File:06vxipn.ex
Update:Mon Jun 3 14:33:05 1996

152
*
[FV08600(ALL)06/95]
Liftgate
[FV08610(ALL)06/95]
Opening the Liftgate
[FV08620(ALL)06/95]
To unlock the liftgate with the key, insert the key into the lock
and turn it counterclockwise. To make the gate swing up to the
fully opened position, pull back and upward on the handle. The
liftgate will not unlock if the optional liftgate window is open.
[FV08630(ALL)06/95]
17-1/2 pica art:0040121-F
Opening the liftgate
[FV08640(ALL)06/95]
You can also unlock the liftgate using the optional power door
lock system, or the optional keyless entry system. However, it
cannot be opened until you release the latch by reaching under
the license plate light shield and lifting up on the handle.
File:08vxfvn.ex
Update:Mon Jun 3 14:49:33 1996

Features
153
[FV08670(ALL)06/95]
Opening the Liftgate Window (If equipped)
[FV08700(ALL)07/95]
To open the liftgate window only, turn the key clockwise. The
window unlatches and the rear wiper falls out of the way. Do
not force the wiper down by hand Ð it moves when the key is
turned. To close, push downward until it latches.
[FV08800(ALL)09/93]
13-1/2 pica
art:0040098-A
The liftgate window in the open position
[FV08900(ALL)01/93]
RWARNING
Never drive the vehicle with the liftgate window open.
Dangerous exhaust fumes can be drawn into the vehicle
with the window raised and the vehicle moving.
[FV09000(ALL)01/93]
Closing the Liftgate
[FV09100(ALL)01/93]
To close the liftgate, reach up and pull the handle on the inner
trim panel downward.
[FV09200(ALL)01/93]
When you have pulled down the liftgate enough so that you
can reach the license plate light shield, push the shield down
and forward to close the liftgate. At this point, the liftgate is not
locked.
File:08vxfvn.ex
Update:Mon Jun 3 14:49:33 1996

Features
155
[FV09500(ALL)01/93]
You can lock the liftgate by pushing in the lock lever before
you begin to close the liftgate. You can also lock the liftgate by
closing the liftgate, inserting your key and turning it clockwise
until you hear the lock lever engage. If you turn it too far, the
optional liftgate window will open. The liftgate can also be
locked with the optional power door locks.
[FV09600(ALL)01/93]
The liftgate area is intended only for cargo, not passengers. It
cannot be opened from inside the vehicle.
[FV09700(ALL)01/93]
After the lock lever is depressed, the liftgate must be unlocked
with the power door lock button or the key.
[FV09800(ALL)01/93]
NOTE: The lock lever will be on the right side of the lock
cylinder if your vehicle is equipped with the standard
liftgate glass. The lock lever will be on the left side
of the lock cylinder if your vehicle is equipped with
the optional flip-up liftgate window.
*
[FV09900(ALL)02/95]
Windows
*
[FV10300(ALL)02/94]
Power Windows (If equipped)
[FV10400(ALL)04/95]
Each of the front doors has a power control that opens and
closes the window on that door. The driver's door has master
controls that operate both front door windows. You must place
the ignition in the ON position to use your power window
controls. The driver's power window controls include a lockout
button which prevents the operation of the passenger side
window from either the passenger or driver side controls.
[FV10500(ALL)06/95]
To open the window, press down on the switch; to close the
window, lift up on the switch.
*
[FV10600(ALL)05/95]
RWARNING
Do not let children play with the power windows. They
may seriously hurt themselves. Make sure occupants are
clear of the window(s) before closing.
File:08vxfvn.ex
Update:Mon Jun 3 14:49:33 1996

Electronic Sound Systems
217
*
[AS13200(ALL)02/95]
n
Loose labels on cassette tapes can become lodged in the
mechanism. Remove any loose label material before inserting
a cassette.
*
[AS13300(ALL)02/95]
n
If a tape is loose inside the cassette, tighten it before playing
by putting your finger or a pencil into one of the holes and
turning the hub until the tape is tight.
[AS13400(ALL)03/93]
n
Using a Ford Cassette Cleaning Cartridge to clean the tape
player head after 10-12 hours of play will help maintain the
best playback sound and proper tape operation.
%*
[AS29753(ALL)03/95]
Clock Operation
[AS29756(ALL)07/94]
How to View the Clock Mode
[AS29759(ALL)06/95]
Press the ªCLº button to alternate the frequency/tape/CD (if
equipped) and time in the display. In the clock mode, pressing
any radio/tape/CD (if equipped) function will automatically
display the radio frequency/tape/CD (if equipped) for
approximately ten seconds before changing back to the clock
mode.
[AS29762(ALL)07/94]
How to Set the Clock
[AS29765(ALL)06/95]1.
Turn the ignition on (clock can be set when radio is on or
off).
[AS29768(ALL)06/95]2.
Press and hold in the ªCLKº button, press the ªSEEKº
button left (
b) to advance the hours and right (
a)to
advance the minutes.
[AS29771(ALL)03/93]
NOTE: The clock displays 12-hour time with no A.M./P.M.
indications.
File:10vxasn.ex
Update:Mon Jun 3 14:57:29 1996

230
[DR01600(ALL)09/93]Shift-lock Safety Feature
[DR01700(ALL)04/95]Your vehicle has a special shift-lock safety feature which
prevents you from shifting out of P (Park) without the brake
pedal depressed. To shift the transaxle out of the P (Park)
position, the ignition must be in the ON position and your foot
must be pressing on the brake pedal.
*[DR01800(ALL)04/95]If the shift lever cannot be moved from the P (Park) position
with the brake pedal depressed:
*[DR01900(ALL)01/93]1.Shut the engine off and remove the ignition key.
*[DR02000(ALL)01/93]2.Apply the parking brake.
*[DR02100(ALL)01/93]3.Reinsert the ignition key and turn it clockwise to the first
position (OFF).
*[DR02200(ALL)04/95]4.Depress the brake pedal, move the gearshift lever to N
(Neutral) and start the engine.
*[DR02290(ALL)06/95]If you need to shift out of P (Park) by using the alternate
procedure described above, it is possible that a fuse has blown
and that your brakelamps may also not be functional. Please
refer to the chapter titledServicing Your Villagerin this Owner
Guide for instructions on checking and replacing fuses.
*[DR02300(ALL)05/95]R WARNING
DO NOT DRIVE YOUR VEHICLE UNTIL YOU VERIFY
THAT THE BRAKELAMPS ARE WORKING.
%*[DR02500(ALL)06/92]Backing Up
*[DR02600(ALL)06/95]Before shifting into or out of R (Reverse), you should always
come to a complete stop.
File:11vxdrn.ex
Update:Tue Jun 4 11:42:50 1996

Driving Your Villager
233
[DR04320(ALL)06/95]
N (Neutral)
*
[DR04340(ALL)06/95]
In N (Neutral), the wheels of the transaxle are not locked. Your
vehicle will roll freely, even on the slightest incline, unless the
parking brake or brakes are on.
*
[DR04400(ALL)06/92]
Parking
*
[DR04500(ALL)06/95]
Always come to a complete stop before you shift into P (Park).
This position locks the transaxle and prevents the front wheels
from turning. To securely latch the gearshift in the P (Park)
position, pull it toward you, push it completely
counterclockwise against the stop, and then push it toward the
instrument panel.
[DR04600(ALL)01/93]
The gearshift is securely latched in Park (P) if you cannot rotate
it in a clockwise direction without lifting it toward you.
*
[DR04700(ALL)06/95]
RWARNING
Always set the parking brake fully and make sure the
gearshift is securely latched in P (Park).
*
[DR04800(ALL)06/95]
RWARNING
Never leave your vehicle unattended while it is running.
*
[DR05000(ALL)06/94]
Forced Downshifts
[DR05100(ALL)01/93]
To gain extra acceleration in Drive (D) (when passing another
vehicle) push the accelerator to the floor. The transaxle will
automatically downshift to the appropriate gear - third, second
or first.
File:11vxdrn.ex
Update:Tue Jun 4 11:42:50 1996