1996 Mercury Sable belt

17
*
[SR06201(ALL)03/95]
RWARNING
Make sure that the lap belt is as low
around your hips as possible. Do not
wear the lap belt around your waist.
If you do not use the lap belts
properly, the risk of being injured in
a collision greatly increases.
*
[SR06225(ALL)03/95]
RWARNING
All front and rear seat outboard
occupants (including pregnant
women) should wear lap and
shoulder belts, for optimum
protection in a collision.
*
[SR06251(ALL)03/95]
RWARNING
Use the shoulder belt on the outside
shoulder only. Never wear the
shoulder belt under the arm. Never
swing it around your neck over the
inside shoulder. Never use a single
belt for more than one person.
Failure to follow these precautions
could increase the risk and/or
severity of injury in a collision.
*
[SR06275(ALL)03/95]
Due to folding rear seats, sometimes the buckles
and tongues toward the center of the vehicle
may be hidden by the rear edge of the seat
cushion. Pull them out so they will be accessible.
*
[SR06301(ALL)03/95]
While you are fastened in the seat belt, the
combination lap/shoulder belt with a cinch
tongue adjusts to your movement. However, if
you brake hard, turn hard, or if your vehicle
receives an impact of 5 mph (8 km/h) or more,
File:fcsrs.ex
Update:Wed Dec 20 09:34:02 1995

18the safety belt will become locked and help
reduce your forward movement.
[SR06500(ALL)03/95]
To unfasten the belt, push the red release button
on the end of the buckle. This allows the tongue
to unlatch from the buckle. While the belt
retracts, guide the tongue to its original position
to prevent it from striking you or the vehicle.
[SR06550(ALL)02/95]
one third page art:0000029-F
Unfastening the combination lap and shoulder belts for the
rear-facing third seat (wagon)
[SR06560(ALL)04/95]
Center Occupant Rear Safety Belt (Sedan)
[SR06565(ALL)04/95]
The safety belt in the center rear seating position
has a detachable shoulder belt.
[SR06570(ALL)04/95]
To attach the shoulder belt to the lap belt, pull
the shoulder belt out from the retractor in the
seatback and insert the lap belt connecting pin
into the wide end of the key-slot on the
shoulder belt as shown in Figure 1. Pull the
connecting pin into the narrow end of the
key-slot until you hear a snap and feel it latch.
See Figure 2. Make sure the shoulder belt is
securely fastened to the lap belt by pulling up
on the shoulder belt.
File:fcsrs.ex
Update:Wed Dec 20 09:34:02 1995

19 [SR06575(ALL)04/95]
half page art:0001371-B
The reverse side of the lap belt and the detachable
shoulder belt
[SR06580(ALL)04/95]
half page art:0001372-A
The reverse side of the shoulder belt attached to the lap belt
File:fcsrs.ex
Update:Wed Dec 20 09:34:02 1995

20 [SR06585(ALL)04/95]
RWARNING
The rear center lap belt must be
tightened separately from the
shoulder strap. The lap belt must fit
snugly, and as low as possible
around the hips. Do not wear around
your waist. For information about
adjusting the belt, see ªLAP BELTSº
in this chapter.
[SR06590(ALL)04/95]
Detach the shoulder belt before folding down
the passenger side rear seat. To detach the
shoulder belt, slide the connecting pin to the
wide end of the key-slot and lift the shoulder
belt off the connecting pin. As the shoulder belt
retracts, guide the belt so that it does not strike
you or the vehicle.
%
*
[SR06601(ALL)04/95]
Lap Belts
[SR06650(ALL)03/95]
The lap belts in the center front seating position
(if equipped) and center rear seat (wagon) do
not adjust automatically. You must adjust them
to fit snugly and as low as possible around your
hips. Do not wear the lap belt around your
waist.
[SR06675(ALL)04/95]
The front center seat belt buckle and tongue are
stowed in a pocket between the seat cushion and
seatback. Remove them from the stowage pocket
before fastening.
*
[SR06700(ALL)03/95]
Pull the belt across your hips andinsert the
tongue into the correct buckleon your seat
until you hear a snap and feel it lock. Make sure
the buckle is securely fastened.
%*
[SR06750(ALL)02/95]
If you need to lengthen the belt, unfasten it and
tip the belt tongue at a right angle to the belt.
Pull the belt tongue over your lap until it
reaches the buckle.
File:fcsrs.ex
Update:Wed Dec 20 09:34:02 1995

21
*
[SR06800(ALL)02/95]
If you need to shorten the belt, pull on the loose
end of the webbing until the belt fits snugly.
[SR06850(ALL)02/95]
one third page art:0000029-F
Unfastening the lap belts for the center front and center
rear seating positions
*
[SR06900(ALL)02/95]
To unfasten the belt, push the release button on
the end of the buckle. This allows the tongue to
unlatch from the buckle.
[SR06925(ALL)03/95]
RWARNING
Make sure that the lap belt is as low
around your hips as possible. Do not
wear the lap belt around your waist.
If you do not use the lap belts
properly, the risk of being injured in
a collision greatly increases.
%*
[SR07750(ALL)02/95]
Safety Belt Extension Assembly
*
[SR07800(ALL)02/95]
For some people, the safety belt may be too
short even when it is fully extended. You can
add about eight inches (20 cm) to the belt length
with a safety belt extension assembly (part
number 611C22). Safety belt extensions are
available at no cost from your dealer.
[SR07850(ALL)02/95]
This assembly is not for use in the wagon
rear-facing seat.
File:fcsrs.ex
Update:Wed Dec 20 09:34:02 1995

22 [SR07900(ALL)02/95]
RWARNING
The use of the safety belt extension
assembly, in the wagon rear-facing
seat will affect the performance of
the safety belts and increase the risk
of personal injury.
*
[SR07925(ALL)03/95]
RWARNING
Use only extensions manufactured by
the same supplier as the safety belt.
Manufacturer identification is located
at the end of the webbing on the
label. Also, use the safety belt
extension only if the safety belt is
too short for you when fully
extended. Do not use extension to
change the fit of the shoulder belt
across the torso. Failure to follow
these instructions will affect the
performance of the safety belts and
increase the risk of personal injury.
%*
[SR07950(ALL)03/95]
Safety Belt Maintenance
*
[SR07970(ALL)04/95]
Check the safety belt systems periodically to
make sure that they work properly and are not
damaged.
%*
[SR07980(ALL)04/95]
All safety belt assemblies, including retractors,
buckles, front seat belt buckle support assemblies
(slide bar) (if equipped), child safety seat tether
bracket assemblies (if equipped), and attaching
hardware, should be inspected after any
collision. Ford recommends that all safety belt
assemblies used in vehicles involved in a
collision be replaced. However, if the collision
File:fcsrs.ex
Update:Wed Dec 20 09:34:02 1995

23
was minor and a qualified technician finds that
the belts do not show damage and continue to
operate properly, they do not need to be
replaced. Safety belt assemblies not in use
during a collision should also be inspected and
replaced if either damage or improper operation
is noted.
%*
[SR08400(ALL)04/95]
Cleaning the Safety Belts
*
[SR08500(ALL)04/04]
Clean the safety belts with any mild soap
solution that is recommended for cleaning
upholstery or carpets. Do not bleach or dye the
belt webbing because this may weaken it.
%
*
[SR14300(ALL)04/95]
Air Bag Supplemental Restraint
System (SRS)
*
[SR14650(ALL)04/95]
The driver and right front passenger air bags are
Supplemental Restraint Systems (SRS), provided
at these seating positions in addition to the
lap/shoulder belt, and are designed to
supplement the protection provided to properly
belted occupants in moderate to severe frontal
collisions. The supplemental air bag system does
not provide restraint to the lower body.
%*
[SR14800(ALL)02/95]
The Importance of Wearing Safety Belts
*
[SR14900(ALL)01/95]
RWARNING
ALWAYS WEAR YOUR SAFETY
BELT!
File:fcsrs.ex
Update:Wed Dec 20 09:34:02 1995

24
*
[SR14950(ALL)01/94]
RWARNING
All occupants of the vehicle,
including the driver, should always
wear their safety belts, whether or
not an air bag Supplemental
Restraint System is also provided at
their seating position. Failure to do
so may increase the risk of severe
injury or death in the event of a
collision.
*
[SR15000(ALL)01/95]
There are four very important reasons to use
safety belts even with an air bag system. Use
your safety belts to:
*
[SR15100(ALL)01/95]
q
help keep you in the proper position (away
from the air bag) when it inflates
*
[SR15200(ALL)01/95]
q
reduce the risk of harm in rollover, side or
rear impact collisions, because an air bag is
not designed to inflate in such situations
*
[SR15300(ALL)01/95]
q
reduce the risk of harm in frontal collisions
that are not severe enough to activate the
supplemental air bag
*
[SR15400(ALL)01/95]
q
reduce the risk of being thrown from your
vehicle
%*
[SR15500(ALL)01/95]
The Importance of Being Properly Seated
*
[SR15600(ALL)02/95]
In a collision, the air bag must inflate extremely
fast to help provide additional protection for
you. In order to do this, the air bag must inflate
with considerable force. If you are not seated in
a normal riding position with your back against
the seatback, the air bag may not protect you
properly and could possibly hurt you as it
inflates.
File:fcsrs.ex
Update:Wed Dec 20 09:34:02 1995