1996 FORD RANGER warning

Steering Column Controls
95
*
[SC08700(ALL)08/95]
RWARNING
Do not use the speed control in heavy traffic or on roads
that are winding, slippery, or unpaved.
*
[SC08801(ALL)05/95]
In mountainous areas, at higher elevations, or when pulling a
trailer, the speed control may not be able to maintain the preset
speed with the transmission in
j(Overdrive).
*
[SC08850(ALL)06/92]
If your vehicle comes with a 5-speed manual transmission, you
may prefer to drive in 4 (Fourth) gear, in mountainous areas or
at high altitudes, to improve speed control performance.
*
[SC09275(ALL)12/91]
In order to downshift (with a manual transmission) with the
speed control operating, you must press either the brake or
clutch pedal long enough to disengage the speed control. Wait a
second before depressing the clutch again and making the shift
so that the speed control can fully return to the idle position.
*
[SC09325(ALL)05/95]
RWARNING
Do not shift the transmission into N (Neutral) with the
speed control on.
[SC09350(ALL)03/95]
To maintain a preset speed under the above conditions, with
electronically controlled transmissions Ð press the Transmission
Control Switch (TCS). The indicator light will turn on and
illuminate the words ªO/D OFF.º This will cancel ªOverdrive.º
You can press the Transmission Control Switch (TCS) on or off
at any speed. For the best fuel economy during normal driving
conditions, press the Transmission Control Switch (TCS) to turn
off the light. This allows overdrive operation.
File:07unscr.ex
Update:Wed May 1 13:46:58 1996

98
%*
[SC11500(ALL)08/95]
Resuming a Set Speed
*
[SC11600(ALL)06/95]
If you press the brake pedal, the speed control is cancelled. You
can return to the speed you set by using the RSM switch, as
long as you did not press the OFF switch.
*
[SC11700(ALL)08/95]
To resume the speed you had before, you must be driving at
least 30 mph (50 km/h).
*
[SC11800(ALL)05/93]
Press and release the RSM switch. Your vehicle gradually
returns to the previously set speed and then maintains it.
*
[SC11850(ALL)03/95]
RWARNING
If your vehicle has speed control, do not use it on
slippery roads. You could lose control of your vehicle
and could injure someone.
File:07unscr.ex
Update:Wed May 1 13:46:58 1996

102
[FV08401(R )04/94]
10-1/2 pica
art:0020196-C
Tailgate removal
*
[FV08601(R )05/95]
RWARNING
Do not drive your vehicle with the tailgate open unless
there is a load holding it in place.
%*
[FV14100(ALL)04/95]
Power Door Locks (If equipped)
[FV14550(R )05/95]
The power door lock switches are located in the front doors. To
lock all doors push the switch markeds. To unlock all doors
push the switch markeds.
*
[FV14701(ALL)03/91]
The manual door locks will override the power door lock
controls.
[FV15101(R )06/94]
7-1/2 pica art:0020204-F
Power door lock controls
File:08unfvr.ex
Update:Wed May 1 13:48:36 1996

104and the parking lamps will flash. If a door is open or ajar, the
horn will give two short chirps warning you that a door is
open.
%*
[FV16800(ALL)02/95]
Remote entry personal alarm
*
[FV16900(ALL)02/95]
If you wish to activate the remote entry system personal alarm,
press the PANIC button. This will honk the horn and flash the
lights for approximately 2 minutes 45 seconds. You can turn it
off by pressing the PANIC button again from the transmitter or
by turning the ignition to the ON or ACCESSORY position.
*
[FV17000(ALL)02/95]
When you use the remote entry UNLOCK or PANIC buttons,
the illuminated entry system turns on the vehicle's interior
lights for 25 seconds. You can turn these lights off with the
remote entry LOCK button or by turning the ignition to the ON
or ACCESSORY position.
[FV17100(ALL)03/95]
7-1/2 pica art:0021160-A%*
[FV17200(ALL)04/95]
Arming and Disarming the Alarm System with Remote
Entry
*
[FV17350(ALL)04/95]
Your Remote Entry System will automatically arm the factory
installed Anti-Theft System when the doors are locked, and
automatically disarm it when the doors are unlocked. The
remote will also reset the anti-theft alarm (when the driver's
door is unlocked or the PANIC button is pressed on a
programmed remote entry transmitter) if it was triggered.
File:08unfvr.ex
Update:Wed May 1 13:48:36 1996

Features
111
%*
[FV22901(ALL)03/91]
Using the Power Windows (If equipped)
[FV23001(ALL)08/94]
Each door has a power control that opens and closes the
window on that door. The driver's door has a master control
switch that operates all door windows. You must place the
ignition switch in the ON or ACC position to use your power
window controls.
*
[FV23501(ALL)08/95]
RWARNING
Do not let children play with the power windows. They
may seriously hurt themselves. Make sure occupants are
clear of the window(s) before closing.
[FV23601(R )06/94]
10-1/2 pica
art:0020211-H
Master control switch
File:08unfvr.ex
Update:Wed May 1 13:48:36 1996

114
*
[FV25950(ALL)08/95]3.
Move the seat to the desired position.
[FV25960(ALL)10/94]4.
Release the bar to latch the seat in its new position. Make
sure the seat latches securely in place.
[FV25970(ALL)10/94]
13-1/2 pica
art:0021273-A
Adjusting the bucket seat
*
[FV26001(ALL)08/95]
RWARNING
Never adjust the driver's seat or seatback when the
vehicle is moving.
*
[FV26100(ALL)08/95]
RWARNING
Do not pile cargo higher than the seatbacks to avoid
injuring people in a collision or sudden stop.
*
[FV26200(ALL)08/95]
RWARNING
To reduce the risk of serious injury in a collision, always
drive and ride with your seatback upright and the lap
belt snug and low across the hips.
File:08unfvr.ex
Update:Wed May 1 13:48:36 1996

Features
115
*
[FV26300(ALL)08/95]
RWARNING
To reduce the risk of serious injury in a collision,
children should always ride with the seatback upright.
[FV26400(ALL)08/94]
Reclining Bucket Seats (If equipped)
[FV26500(R )06/95]
If your vehicle is equipped with the optional reclining bucket
seat, you can tilt the seatback up to 30 degrees rearward.
*
[FV26600(R )06/95]1.
On the side of the seat, find the handle for the recliner.
*
[FV26700(R )08/95]2.
Lift the handle up and hold it in place.
*
[FV26800(R )06/95]3.
Lean against the back of the seat and adjust it to the position
you want.
*
[FV26900(R )06/95]4.
Release the handle to lock the seatback in position.
*
[FV27001(R )06/95]5.
To return the seatback to upright position, lift the handle
and lean forward. Then release the handle.
[FV27751(ALL)08/94]
Lifting the recliner handle of an unoccupied seat will allow the
seat back to fold forward for access to the rear. Pushing the seat
back with the release handle raised returns the seat back to the
upright position.
File:08unfvr.ex
Update:Wed May 1 13:48:36 1996

Features
117
*
[FV40301(R )05/95]
RWARNING
Do not install a child seat in a center facing jump seat.
[FV46005(ALL)08/94]
Tilt Slide Seat (If equipped)
[FV46010(R )05/95]
SuperCab only
[FV46020(ALL)08/94]
With the front seatback tilted forward, the tilt slide seat can be
moved to provide additional entry space to access the rear seat
compartment of the vehicle.
*
[FV46025(ALL)05/94]
To operate the tilt slide seat:
[FV46030(ALL)08/94]1.
Lift the seatback release lever on the outboard side of the
seat cushion to unlock the slide mechanism and seatback.
*
[FV46035(ALL)03/93]2.
Push the seat assembly forward to provide entry space to the
rear seat compartment of the vehicle.
*
[FV46037(ALL)08/94]
RWARNING
Do not place objects behind or under the front seat
which can prevent the seat from returning to the locked
position.
*
[FV46038(R )08/95]
RWARNING
A seatback which is folded forward even a small degree
may not lock properly in the event of a sudden stop or
collision.
[FV46040(ALL)08/94]3.
With the seatback still forward, using the seat cushion push
the seat rearward to the desired position and return the
seatback to its upright position. This will lock the seat track.
[FV46043(ALL)09/95]
NOTE: Whenever the seatback is returned to the upright
position, the seat will lock in that seat position.
File:08unfvr.ex
Update:Wed May 1 13:48:36 1996