1996 FORD RANGER manual radio set

41
Starting Your Ranger
*
[ST01700(ALL)03/95]
Ignition
%*
[ST01800(ALL)01/95]
Understanding the Positions of the Ignition
[ST02000(ALL)04/94]
7-1/2 pica art:0021143-A
The positions of the key in the ignition lock cylinder.
%*
[ST02201(ALL)07/95]
ACCESSORY allows some of your vehicle's electrical accessories
such as the radio and the windshield wipers to operate while
the engine is not running.
*
[ST02301(ALL)01/95]
In order to turn the key from the ON or OFF position to the
ACCESSORY position, you must push the key release button if
your vehicle's manual transmission gearshift is mounted on the
floor.
*
[ST02401(ALL)08/95]
LOCK locks the steering wheel and gearshift lever.
*
[ST02501(ALL)10/95]
RWARNING
LOCK does not lock the gearshift on console or
floor-mounted manual transaxle gearshifts. If the parking
brake is not set and the gearshift is moved out of gear,
your vehicle may move unexpectedly and injure someone.
[ST02600(R )06/95]
A neutral tow feature is available on your vehicle. See your
dealer for more information.
File:04unstr.ex
Update:Wed May 1 13:44:22 1996

Electronic Sound Systems
131
*
[AS29315(ALL)01/95]
n
Setting the station MEMORY PRESET buttons
*
[AS29320(ALL)01/95]
Your radio is equipped with 6 station memory buttons.
These buttons can be used to select up to 6 preset AM
stations and 12 FM stations (6 in FM1 and 6 in FM2)
*
[AS29325(ALL)10/95]
Follow the easy steps below to set these buttons to the desired
frequencies:
*
[AS29330(ALL)10/95]1.
Select a band, then select a frequency.
*
[AS29340(ALL)10/95]2.
Press one of the memory preset buttons and hold the button
until the sound returns. That station is now held in memory
on that button.
*
[AS29345(ALL)10/95]3.
Follow the two steps above for each station memory preset
button you want to set.
*
[AS29350(ALL)01/95]
n
Using the AUTOSET feature
*
[AS29355(ALL)01/95]
With AUTOSET, you can continually set strong stations into
your memory buttons without losing your originally set
stations.
*
[AS29360(ALL)01/95]
Press the ªAUTOSETº button once. Your radio will set the
first six strong stations of the band you are in (AM, FM1, or
FM2) into the memory buttons. The display will show
ªAUTOº, then run through the frequencies setting the
memory buttons.
*
[AS29365(ALL)10/95]
NOTE: If there are fewer than five strong stations in the
frequency band, the remaining unfilled buttons will
store the last strong station detected on the band.
*
[AS29370(ALL)01/95]
When all stations are filled, the radio will begin playing the
station stored in memory button 1.
*
[AS29375(ALL)01/95]
To deactivate the Auto Memory Store mode and return to
manually-set memory button stations, press the ªAUTOSETº
button. Display will show ªAUTOº then ªOFFº.
File:09unasr.ex
Update:Wed May 1 13:49:43 1996

Electronic Sound Systems
133
%*
[AS29435(ALL)08/95]
Using the Controls of Your Cassette Tape Player
*
[AS29440(ALL)08/95]
NOTE: Radio power must be on to use the cassette tape
player.
*
[AS29445(ALL)08/95]
How to insert a tape
*
[AS29450(ALL)04/95]
Your cassette tape player is equipped with power loading. Once
you insert a tape and push slightly (with theopen edge to the
right), the loading mechanism draws the tape the rest of the
way in and play will begin after a momentary tape tightening
process. Display indicates ªTAPEº while tape is playing.
*
[AS29455(ALL)06/95]
NOTE: A cassette tape can be loaded with the ignition on
whether or not the radio power is on. However, with
radio power off, the cassette tape is loaded and stored.
*
[AS29465(ALL)08/95]
How to locate a desired track on the tape
*
[AS29470(ALL)08/95]
There are four ways to quickly locate a desired selection on the
tape. You can use the fast forward, rewind, ªSEEKº or ªSCANº
function. Following are brief descriptions of each.
*
[AS29475(ALL)09/95]
n
Fast forwarding the tape
*
[AS29480(ALL)01/95]
To fast forward the tape, press the ªFFº button. The radio
will begin playing until fast forward is manually stopped (by
pushing the ªTAPEº button) or the end of the tape is
reached.
*
[AS29485(ALL)01/95]
At the end of the tape, the direction automatically reverses
and plays the other side of the tape.
*
[AS29490(ALL)08/95]
n
Rewinding the tape
*
[AS29495(ALL)01/95]
To rewind the tape, press the ªREWº button. The radio will
begin playing until rewind is manually stopped (by pushing
the ªTAPEº button) or the beginning of the tape is reached.
File:09unasr.ex
Update:Wed May 1 13:49:43 1996

146
*
[AS29967(R )05/95]
Midline Stereo and Stereo Cassette Radio
*
[AS29970(ALL)08/95]
Using the Controls on Your New Radio
*
[AS29972(ALL)10/95]
How to turn the radio on and off
*
[AS29973(ALL)01/95]
Press the ªVOL/PUSH ONº knob to turn the radio on. Press
again to turn it off.
*
[AS29975(ALL)10/95]
How to adjust the volume
[AS29980(ALL)06/95]
Turn the ªVOL/PUSH ONº knob clockwise to increase the
volume and counterclockwise to decrease the volume. Bars
illuminate in the display to show relative volume level.
*
[AS29985(ALL)10/95]
NOTE: If the volume level is set above a certain listening
level when the ignition switch is turned off, when the
ignition switch is turned back on, the volume will
come back to a ªnominalº listening level. However, if
the radio power is turned off, the volume will remain
in the position it was set at when radio power was
switched off.
*
[AS29990(ALL)10/95]
Selecting the AM or FM frequency band
[AS29995(ALL)10/94]
Push the ªAMº/FMª button to select the desired frequency
band or to stop/store cassette tape (when in cassette mode).
These functions are used with the station memory buttons
described underHow to tune radio stations.
%*
[AS30000(ALL)10/95]
How to tune radio stations
[AS30005(ALL)04/95]
There are four ways for you to tune in a particular station. You
can manually locate the station using the ºTUNEª button,
ºSEEKª button, ºSCANª button, or select the station by using
the memory buttons, which you can set to any desired
frequency. These four methods are described below.
File:09unasr.ex
Update:Wed May 1 13:49:43 1996

Electronic Sound Systems
147
*
[AS30010(ALL)09/95]
n
Using the ºTUNEª function
*
[AS30015(ALL)03/95]
You can change the frequency up or down one increment at
a time by pressing and releasing either the left (
b) or right
(
a) side of the ºTUNEª button.
*
[AS30020(ALL)10/95]
Manual tuning adjusts your radio to any allowable broadcast
frequency, whether or not a station is present on that
frequency. (SeeAll About Radio Frequenciesin this section.)
*
[AS30025(ALL)10/95]
n
Using the ºSEEKª function
*
[AS30030(ALL)09/95]
This feature on your radio allows you to automatically select
listenable stations up or down the frequency band. Press the
right (
a) side of the ºSEEKª button to select the next
listenable station up the frequency band. Press the left (
b)
side of the button to select the next listenable station down
the frequency band. By holding the button down, listenable
stations can be passed over to reach the desired station.
*
[AS30035(ALL)01/95]
n
Using the ºSCANª function
*
[AS30040(ALL)04/95]
Pressing the ºSCANª button will begin the scan mode up
the frequency band, stopping on each listenable station for
approximately five seconds.
*
[AS30045(ALL)02/95]
To stop the scan mode on the presently sampled station,
press the ºSCANª button again.
*
[AS30050(ALL)10/95]
n
Setting the Station Memory Preset buttons
*
[AS30055(ALL)10/95]
Your radio is equipped with 6 station memory buttons.
These buttons can be used to select up to 6 preset AM
stations and 12 FM stations (6 in FM1 and 6 in FM2).
File:09unasr.ex
Update:Wed May 1 13:49:43 1996

Electronic Sound Systems
149
*
[AS30130(ALL)10/95]
NOTE: Illuminated bars in the display show relative levels of
bass and treble, and positions of speaker balance and
fader functions (left to right, front to rear).
%*
[AS30135(R )08/95]
Using the Controls of Your Cassette Tape Player
*
[AS30140(R )09/95]
NOTE: Radio power must be on to use the cassette tape
player or eject a tape.
*
[AS30145(R )08/95]
How to insert a tape
*
[AS30150(R )09/94]
Your cassette tape player is equipped with power loading. Once
you insert a tape and push slightly (with theopen edge to the
right), the loading mechanism draws the tape the rest of the
way in and play will begin after a momentary tape tightening
process.
*
[AS30155(R )09/95]
NOTE: A cassette tape can be loaded and stored with the
ignition and radio power off.
*
[AS30165(R )08/95]
How to locate a desired track on the tape
*
[AS30170(R )09/94]
There are four ways to quickly locate a desired selection on the
tape. You can use the fast forward, rewind, ºSEEKª, or ºSCANª
function. Following are brief descriptions of each.
*
[AS30175(R )09/95]
n
Fast forwarding the tape
*
[AS30180(R )01/95]
To fast forward the tape, press the ºFFª button. The radio
will begin playing until fast forward is manually stopped (by
pushing the ºTAPEª button) or the end of the tape is
reached.
*
[AS30185(R )01/95]
At the end of the tape, the direction automatically reverses
and plays the other side of the tape.
*
[AS30190(R )08/95]
n
Rewinding the tape
*
[AS30195(R )01/95]
To rewind the tape, press the ºREWª button. The radio will
begin playing until rewind is manually stopped (by pushing
the ºTAPEª button) or the beginning of the tape is reached.
File:09unasr.ex
Update:Wed May 1 13:49:43 1996