1996 FORD RANGER lock

280
[SV20075(ALL)09/95]
RWARNING
Be careful not to add engine coolant to the windshield
washer fluid reservoir. If sprayed on the windshield,
engine coolant could make it difficult to see through the
windshield.
[SV20100(ALL)09/95]
When the engine is cool, add a 50/50 mixture of engine coolant
and water to the engine coolant recovery reservoir Ð DO NOT
ADD DIRECTLY TO THE RADIATOR. Add straight water only
in an emergency, but you should replace it with a 50/50
mixture of coolant and distilled water as soon as possible.
[SV20125(ALL)09/95]
Check the coolant level in the coolant recovery reservoir the
next few times you drive the vehicle. If necessary, add enough
of a 50/50 mixture of coolant and water to bring the liquid
level to the fill line on the reservoir.
[SV20150(ALL)09/95]
RWARNING
Never remove the coolant recovery cap while the engine
is running or hot.
[SV20175(ALL)09/95]
If you must remove the coolant recovery cap, follow these steps
to avoid personal injury caused by escaping steam or engine
coolant:
[SV20200(ALL)09/95]1.
Before you remove the cap, turn the engine off and let it
cool.
[SV20225(ALL)09/95]2.
When the engine is cool, wrap a thick cloth around the cap
and turn it slowly, counterclockwise to the first stop.
[SV20250(ALL)09/95]3.
Step back while the pressure releases.
[SV20275(ALL)09/95]4.
When you are sure that all the pressure has been released,
use the cloth to press the cap down, turn it counterclockwise,
and remove it.
File:15unsvr.ex
Update:Wed May 1 13:56:18 1996

282
[SV20475(ALL)09/95]
Severe winter climate
[SV20490(ALL)09/95]
If you drive in extremely cold climates (less than-34ÊF [-36ÊC]),
it may be necessary to increase the coolant concentration above
50%. Refer to the chart on the coolant container to ensure the
coolant concentration in your vehicle is such that the coolant
will not freeze at the temperature level in which you drive
during winter months. Never increase the engine coolant
concentration above 60%. Leave a 50/50 mixture of engine
coolant and water in your vehicle year-round in non-extreme
climates.
%*
[SV20500(ALL)08/95]
Checking Hoses
*
[SV20600(ALL)10/89]
Inspect all engine and heater system hoses for deterioration,
leaks and loose clamps before adding or replacing engine
coolant. Make whatever repairs or replacements that are
necessary using Motorcraft parts or their equivalents.
%*
[SV20700(ALL)08/95]
Engine Coolant Drain and Flush
*
[SV20800(ALL)10/89]
To drain your vehicle's engine coolant:
*
[SV20900(ALL)03/94]1.
Turn off the engine and let it cool. Fully depressurize the
engine cooling system by covering the radiator cap with a
thick cloth and turning it slowly counterclockwise to the first
stop. Step back while the pressure releases.
*
[SV20950(ALL)05/90]2.
Remove the cap.
*
[SV21000(ALL)05/90]3.
Attach a small hose to the drain tube at the bottom of the
radiator.
*
[SV21200(ALL)05/90]4.
Let the engine coolant drain into a suitable container.
Disconnect the lower radiator hose at the radiator connector
and drain any remaining engine coolant into a container.
*
[SV21250(ALL)05/95]
Proper procedures for flushing the cooling system can be found
in theService Manual.
File:15unsvr.ex
Update:Wed May 1 13:56:18 1996

Servicing Your Ranger
285
%*
[SV24500(ALL)03/95]
Wiper Blades
*
[SV24600(ALL)03/95]
Check the windshield wiper blades at least twice a year. Also
check them whenever they seem less effective than usual. Such
substances as tree sap and some hot wax treatments used by
commercial car washes reduce the effectiveness of wiper blades.
*
[SV24700(ALL)09/95]
If the blades do not wipe properly, clean both the windshield
and the wiper blades. Use undiluted windshield washer solution
or a mild detergent. Rinse thoroughly with clear water. Do not
use fuel, kerosene, paint thinner, or other solvents to clean your
wiper blades. These will damage your blades.
*
[SV24800(ALL)03/95]
To make reaching the wiper blades easy, simply turn the
ignition to the ACC position and turn your wipers on. Wait for
them to reach a vertical position and turn the ignition to the
OFF position. Do not move the wipers manually. Manually
moving the wipers across the windshield may damage them.
*
[SV24900(ALL)03/01]
Wiper blade replacement
[SV25000(ALL)01/95]
If the wipers still do not work properly after you clean them,
you may need to replace the wiper blade assembly or the blade.
When replacing the wiper blade assembly, blade refill, or wiper
arm always use a Motorcraft part or equivalent.
*
[SV25025(ALL)10/93]
To replace the wiper blades:
[SV25030(ALL)10/94]1.
Cycle windshield wiper arm and wiper blade to where
removal of blade can be performed without difficulty. Turn
ignition off at desired position.
[SV25075(ALL)10/94]2.
To remove wiper blade assembly from wiper mounting arm,
depress lock tab and push wiper mounting arm away from
wiper blade assembly.
[SV25100(ALL)10/94]3.
To install wiper blade assembly, pull wiper mounting arm
down on wiper blade until lock tab is engaged.
File:15unsvr.ex
Update:Wed May 1 13:56:18 1996

Servicing Your Ranger
319
*
[SV46300(ALL)03/95]
Removing the headlamp bulb
*
[SV46400(ALL)01/95]1.
Make sure that the headlamp switch is in the OFF position.
[SV46502(R )05/95]2.
Lift the hood. Remove the electrical connector behind the
headlamp by grasping the wires and pulling it rearward.
*
[SV46700(ALL)04/95]3.
Remove the bulb retaining ring by turning it 1/8 of a turn to
free it from the socket. Then slide the ring off the plastic
base. Keep the ring.You must use it again to hold the new
bulb in place.
*
[SV46800(ALL)04/95]4.
Carefully remove the bulb assembly from its socket by
gently pulling it rearward without turning.
*
[SV46900(ALL)03/95]
Installing the headlamp bulb
*
[SV47000(ALL)02/95]1.
With the flat side of the bulb's plastic base facing upward,
insert the glass end of the bulb into the socket. You may
need to turn the bulb left or right to line up the grooves in
the plastic base with the tabs in the socket. When the
grooves are aligned, push the bulb into the socket until the
plastic base contacts the rear of the socket.
*
[SV47100(ALL)08/95]2.
Slip the bulb retaining ring over the plastic base until it
contacts the rear of the socket. Lock the ring into the socket
by rotating it clockwise until you feel a ªstop.º
*
[SV47200(ALL)02/95]3.
Push the electrical connector into the rear of the plastic base
until it snaps, locking it into position.
*
[SV47300(ALL)02/95]4.
Turn the headlamps on and make sure that they work
properly. If the headlamp was correctly aligned before you
changed the bulb, you should not need to align it again.
File:15unsvr.ex
Update:Wed May 1 13:56:18 1996

Index
349
A
Accessory position on the ignition............. 41
Accessory power source, power point outlet....... 126
Additives, engine oil.................. 275
Air bag supplemental restraint system
and child safety seats................. 36
description.................... 25,30
disposal....................... 34
driver air bag................... 25,30
indicator light..................... 58
operation....................... 30
passenger air bag................... 30
proper seating.................... 27
service and information labels............. 30
tone generator.................. 31,34
wearing safety belts.................. 26
Air cleaner filter
location...................... 262
specifications.................... 330
Alarm, activating remote personal............ 104
Antenna, radio (see Electronic sound system).....127, 152
Antifreeze (see Engine coolant)............. 278
Anti-lock brake system (ABS)
description..................... 177
noise........................ 179
see also Brake.................... 177
Anti-theft system
arming the system.................. 107
description..................... 107
disarming an untriggered system........... 108
disarming a triggered system............. 108
triggering...................... 107
Appeals (see Dispute settlement board)......... 243
Assistance (see Customer assistance)........... 241
File:unixr.ex
Update:Wed May 1 13:58:05 1996

350
Audio system (see Electronic sound system)....... 127
Autolamp system (see Headlamps)............ 82
Automatic transmission
driving an automatic overdrive............ 158
fluid, adding.................... 301
fluid, checking................... 300
fluid, specification.................. 331
Axle
lubricant specifications................ 331
traction lok...................186, 289
B
Backing up...................... 157
Basic vehicle warranty.................. 3
Battery
acid, treating emergencies............219, 298
battery saver.................... 107
charging system warning light............. 62
disconnecting.................... 222
how to service................... 297
jumping a disabled battery.............. 219
maintenance-free.................. 297
proper disposal, recycling.............. 298
replacement, specifications.............. 330
servicing...................... 297
voltage gauge.................. 62,64
when storing your vehicle.............. 336
Brake fluid
brake warning light.................. 56
checking and adding................ 304
description..................... 304
specifications.................... 331
Brakes
adjustment..................... 177
anti-lock...................... 177
applying the brakes................. 182
brake warning light.................. 56
File:unixr.ex
Update:Wed May 1 13:58:05 1996

351
Index
Brakes (continued)
fluid, checking and adding.............. 304
fluid, refill capacities................ 304
fluid, specifications................. 331
front disc...................... 177
if brakes do not grip well.............. 181
master cylinder................... 304
new brake linings................... 5
noise......................177, 181
parking...................... 182
power braking................... 177
rear anti-lock.................... 178
servicing....................181, 304
stopping distances................182, 184
trailer....................... 214
when storing your vehicle.............. 336
Brake-shift interlock.................. 157
Break-in period..................... 5
Brights (high beams)................. 67,88
Bulbs, replacing.................... 317
halogen...................... 318
headlamps..................... 318
C
Canada, customer assistance.............. 248
Canada, warranty information.............. 3
Carbon monoxide in exhaust............... 50
Car seats for children (see Child safety seats)....... 36
Cassette tape player (see Electronic sound system) . . 133, 149
Catalytic converter................... 323
Chains, tires...................... 295
Changing a tire.................... 223
Charging system gauge................. 64
Charging system warning light.............. 62
Child safety restraints
child safety belts................... 39
child safety seats................... 36
File:unixr.ex
Update:Wed May 1 13:58:05 1996

352
Child safety seats
and air bags..................... 36
attaching with tether straps.............. 38
automatic locking mode (retractor)......... 13,36
in front seat..................... 36
in rear outboard seat................. 36
in rear seat...................... 36
tether anchorage hardware............... 38
Chime
headlamps on.................... 67
key in ignition.................... 42
safety belt...................... 57
Circuit breakers, see also fuses............. 308
Cleaning your vehicle
chrome and aluminum parts.............. 6
engine compartment................. 266
exterior....................... 6
exterior lamps.................... 82
fabric....................... 121
headlamps...................... 82
instrument panel.................. 7,74
interior....................... 121
interior lamps.................... 84
mirrors....................... 122
plastic parts..................... 7
polishing....................... 6
rustproofing..................... 6
safety belts...................... 25
tail lamps...................... 82
upholstery and interior trim............. 121
washing....................... 6
waxing........................ 6
wheels....................... 296
Climate control system.................. 74
Clock.......................136, 151
File:unixr.ex
Update:Wed May 1 13:58:05 1996