1996 FORD EXPLORER radio controls

110
[IP00400( X)03/95]
The main controls for the climate control system, lights, message
center, lamps, clocks and radio are on the instrument panel.
%*
[IP00475(ALL)09/95]
NOTE: Any cleaner or polish that increases the gloss (shine)
of the upper part of the instrument panel should be
avoided. The dull finish in this area is to help protect
the driver from undesirable windshield reflection.
%*
[IP00500(ALL)06/95]
The Climate Control Systems
*
[IP00601(ALL)12/91]
Your vehicle is equipped with a control assembly designed to
handle either a combination A/C-Heater System or a
Heater-Only System.
%*
[IP00801(ALL)10/93]
Instrument Panel Registers
*
[IP00901(ALL)02/95]
There are four registers in the instrument panel. Each of these
registers contains a louver assembly which can be manually
adjusted to direct airflow up, down, left and right. An
illustration of the register locations follows.
[IP01201(ALL)04/94]
7-1/2 pica art:0020099-D
Instrument panel registers
[IP01400(ALL)12/91]
Air Conditioning (A/C) Controls (Manual Air
Conditioning)
*
[IP01450(ALL)02/95]
The control for your air conditioning and heater system is
located at the center of the instrument panel below the radio
and will operate only when the ignition key is turned to the
ON position. Your air conditioner and heater will heat and/or
cool your vehicle interior depending on the function position
File:06unipx.ex
Update:Thu Feb 29 09:05:45 1996

Instrument Panel Controls
127
[IP15800( X)10/94]
Liftgate Wiper and Washer (If equipped)
[IP15901( X)10/94]
The wiper/washer switch is to the right of the radio. To turn on
the wiper, rotate the wiper/washer switch to the WIPE position.
To select an interval wipe rotate switch between OFF and HI.
To turn on the washer, push the switch all the way in and hold
for spray. Release the button and the spray stops, but the wiper
continues to operate. To turn off the wiper, rotate the switch to
the OFF position.
[IP15950( X)12/92]
For information about refilling the liftgate washer fluid or
replacing your liftgate wiper blade, seeWindshield washer fluid
andWindshield wipersin the Index.
[IP16000( X)05/95]
7-1/2 pica art:0090189-A
Liftgate wiper/washer button
%*
[IP16800(ALL)01/95]
The Interior and Exterior Lights
%*
[IP16900(ALL)01/95]
Turning On the Exterior Lights
*
[IP17000(ALL)09/95]
To turn on your headlamps, parking lamps, marker lamps,
license plate lamps and tail lamps, use the headlamp control
knob to the left of the steering column.
[IP17100(ALL)09/95]1.
Rotate the headlamp control knob to the first position.
Parking lamps, tail lamps, license plate lamps and marker
lamps are now on.
[IP17200(ALL)06/94]2.
Rotate the headlamp control knob to the next position.
Headlamps are now on in addition to the above.
File:06unipx.ex
Update:Thu Feb 29 09:05:45 1996

Instrument Panel Controls
131
*
[IP17660( X)12/93]
n
The further you move the slide knob toward the right, the
longer the headlamps stay on after you leave your vehicle.
Similarly, if you move the slide knob only slightly toward
the left, the headlamps stay on for only a moment after you
turn your vehicle off.
%*
[IP17715(ALL)04/95]
Fog Lamps (If equipped)
[IP17725(ALL)03/95]
The fog lamps switch is located on the instrument panel to the
right of the radio and climate control.
[IP17730(ALL)05/95]
n
To turn the fog lamps on, turn on the low-beam headlamps,
then push the fog lamp switch. An indicator light will glow
when the lamps are on.
*
[IP17735(ALL)10/94]
n
To turn off, push the switch again.
[IP17750(ALL)05/95]
7-1/2 pica art:0090191-A
Fog lamp switch
*
[IP17760(ALL)02/93]
The fog lamps act as a supplement to the low beam headlamps
under limited visibility conditions such as rain, snow, dust or
fog and operate only when the low beam headlamps are on.
*
[IP17770(ALL)02/93]
To maximize fog lamp bulb life it is recommended that the fog
lamp switch be turned off after each use prior to turning off the
headlamps.
File:06unipx.ex
Update:Thu Feb 29 09:05:45 1996

134
[IP19875( X)09/95]
10-1/2 pica
art:0020975-B
Map lamps (if equipped)
%*
[IP19900( X)10/94]
High-mount Brakelamp
[IP19910( X)10/94]
The high-mount brakelamp is located outside the vehicle,
directly over the rear window.
[IP19920( X)10/94]
10-1/2 pica art:0021015-E
High-mount brakelamp
*
[IP20300(ALL)04/95]
Clock Controls on Electronic Radios
[IP20400(ALL)10/94]
The electronic radios have a built-in clock. For complete
operating instructions, refer toElectronic Sound Systemsin this
Owner Guide.
File:06unipx.ex
Update:Thu Feb 29 09:05:45 1996

Steering Column Controls
141
*
[SC06450(ALL)09/95]
To change the position of the steering wheel, push the release
lever under the steering column away from you. Tip the
steering wheel to the desired position. Pull the lever back into
place to lock the steering wheel.
*
[SC07250(ALL)12/89]
Be sure the steering wheel locks in a notch. It is not infinitely
adjustable. Do not adjust the steering wheel while the vehicle is
in motion.
%*
[SC07300(ALL)03/91]
Speed Control (If equipped)
*
[SC07400(ALL)06/95]
If your vehicle has speed control, you can automatically
maintain a constant speed at or above 30 mph (50 km/h).
*
[SC07450(ALL)06/95]
Use of radio transmitting equipment that is not Federal
Communications Commission (FCC) or in Canada the Canadian
Radio and Telecommunications Commission (CRTC) approved
may cause the speed control to malfunction. Therefore, use only
properly installed FCC (CRTC in Canada) approved radio
transmitting equipment in your vehicle.
[SC07500(ALL)10/94]
7-1/2 pica art:0020091-F
The speed control switches
*
[SC07800(ALL)08/95]
To set the speed control:
*
[SC08000(ALL)08/95]1.
Press and release the ON switch.
[SC08100(ALL)02/95]2.
Accelerate to the desired speed above 30 mph (48 km/h)
using the accelerator pedal.
File:07unscx.ex
Update:Thu Feb 29 09:06:35 1996

Features
203
[FV65400( X)03/95]
Rear Console (If equipped)
[FV65500( X)03/95]
Your Explorer comes with a rear console that is located between
the bucket seats. The console includes:
[FV65600( X)08/94]
n
Air vents, with rear seat controls
[FV65700( X)08/94]
n
Radio controls
[FV65800( X)10/94]
n
Beverage holder
[FV65900( X)05/95]
17-1/2 pica
art:0090192-A
Rear console
File:08unfvx.ex
Update:Thu Feb 29 13:56:40 1996

Electronic Sound Systems
209
%*
[AS00600( X)06/95]
Luxury Audio System
*
[AS00700( X)08/95]
Using the Controls on Your New Radio
*
[AS00800( X)08/95]
How to turn the radio on and off
*
[AS00900( X)01/95]
Press the “VOL/PUSH ON” knob to turn the radio on. Press
again to turn it off.
*
[AS01000( X)08/95]
How to adjust the volume
[AS01100( X)06/95]
Turn the “VOL/PUSH ON” knob clockwise to increase the
volume and counterclockwise to decrease the volume.
[AS01200( X)09/95]
NOTE: If the volume level is set above a certain listening
level when the ignition switch is turned off, when the
ignition switch is turned back on, the volume will
come back to a “nominal” listening level. However, if
the radio power is turned off (with the “VOL/PUSH
ON” button) and the volume is at a low level, the
volume will remain in the position it was set at when
radio power is switched back on.
*
[AS01300( X)08/95]
Selecting the AM or FM frequency band
*
[AS01400( X)04/95]
Push the “AM/FM” button to select the desired frequency band.
Pushing the “AM/FM” button causes the frequency band to
switch from “AM” to “FM1” to “FM2” to “AM”, changing one
band to the next each time the button is pressed. These
functions are used with the station memory buttons described
underHow to tune radio stations.
File:09unasx.ex
Update:Thu Feb 29 09:08:53 1996

212
*
[AS03600( X)01/95]
Adjusting the tone balance of your radio
*
[AS03700( X)01/95]


Increasing or decreasing bass and treble response
*
[AS03800( X)01/95]
Push the“BASS/TREB”popout knob to gain access to the
bass and treble controls. Bass control allows you to adjust
the lower, bass frequencies to your preference. The outer
ring of the“BASS/TREB”knob adjusts the bass (turn
clockwise to increase bass; counterclockwise to decrease
bass).
*
[AS03900( X)01/95]
Treble control allows you to adjust the higher, treble
frequencies of your radio to your preference. The inner ring
of the“BASS/TREB”knob adjusts the treble (turn clockwise
to increase treble; counterclockwise to decrease treble).
*
[AS04000( X)01/95]


Adjusting speaker balance and speaker fader
*
[AS04100( X)01/95]
Push the“BAL/FADE”popout knob to gain access to the
speaker balance and fader controls. Balance control allows
you to adjust the sound distribution between the right and
left speakers. The outer ring of“BAL/FADE”knob adjusts
the speaker balance control. (Turn clockwise to shift the
sound to the right speakers, and turn counterclockwise to
shift the sound to the left speakers.)
*
[AS04200( X)01/95]
Fade control allows you to adjust the sound distribution
between the front and rear speakers. The inner ring of the
“BAL/FADE”knob adjusts the speaker fader. (Turn
clockwise to shift the sound to the rear speakers, and turn
counterclockwise to shift the sound to the front speakers.)
File:09unasx.ex
Update:Thu Feb 29 09:08:53 1996