1996 FORD E SERIES Page 3

317 [SV28400( E )05/89]
full page art:0020369-C
Tire identification chart
File:14ltsve.ex
Update:Wed Apr 17 08:40:13 1996

324
*
[SV33950( ALL)03/90]
When checking fluid at normal operating
temperature, the fluid level should be within the
crosshatched area on the dipstick. When the
vehicle has not been driven, and outside
temperature is above50ÊF (10ÊC), thefluid level
should be between the holes on the dipstick.
%*
[SV33960( ALL)05/95]
Adding Automatic Transmission Fluid
*
[SV33970( ALL)03/94]
The fluid type is stamped on the dipstick. Before
adding any fluid, be sure that the correct type
will be used.
*
[SV33980( ALL)10/89]
Add fluid in 1/2 pint (.25L) increments through
the filler tube to bring the level to the correct
area on the dipstick. If an overfill occurs, excess
fluid should be removed by a qualified
technician.
%*
[SV33990( ALL)04/95]
NOTE: Always dispose of used automotive
fluids in a responsible manner. Follow
your community's standards for
disposing of these types of fluids. Call
your local recycling center to find out
about recycling automotive fluids.
*
[SV34100( EF )03/94]
one third page art:0020946-A
Automatic transmission dipstick
File:14ltsve.ex
Update:Wed Apr 17 08:40:13 1996

325 [SV34200( E )03/93]
half page art:0020374-C
Automatic transmission dipstick location
[SV34300( E )12/91]
one third page art:0020375-B
Automatic transmission dipstick location
File:14ltsve.ex
Update:Wed Apr 17 08:40:13 1996

327
*
[SV36850( ALL)12/91]
NOTE: If brake fluid is spilled on painted
surfaces, it must be flushed and wiped
away immediately. Brake fluid may
dissolve the paint finish on your
vehicle.
*
[SV36900( ALL)01/95]
RWARNING
If you use a brake fluid that is not DOT
3, you will cause permanent damage to
your brakes.
*
[SV37000( ALL)01/95]
Do not fill the reservoir above the MAX line.
*
[SV37100( ALL)01/95]
If you find that the fluid level is excessively low
Ð below the seam or ridge on the outside of the
plastic reservoir Ð have the brake system
inspected.
*
[SV37200( ALL)01/95]
RWARNING
Do not let the reservoir for the master
cylinder run dry. This may cause the
brakes to fail.
*
[SV37400(BEF )01/89]
quarter page art:0020381-A
Brake master cylinder
File:14ltsve.ex
Update:Wed Apr 17 08:40:13 1996

329
*
[SV38250( ALL)03/94]
one third page art:0021016-B
Power steering dipstick
[SV38700( E )08/91]
quarter page art:0020387-A
Power steering reservoir
*
[SV38800( ALL)07/94]
5. If the power steering fluid is low, add fluid
in small amounts, continuously checking the
level, until you reach the FULL HOT range.
Do not overfill.
*
[SV38850( ALL)03/95]
6. When you are finished, put the dipstick back
in and make sure that it fits snugly.
*
[SV38855( ALL)02/95]
If you check the power steering fluid when it is
cold, make sure that the fluid reaches the FULL
COLD range on the dipstick. The reading will
only be accurate if the fluid temperature is
approximately50ÊF to 85ÊF (10ÊC to 30ÊC).
File:14ltsve.ex
Update:Wed Apr 17 08:40:13 1996

330 [SV38860(E )10/95]E-Super Duty vehicles:
[SV38870( E)10/95]
4. Check the fluid level in the power steering
fluid reservoir. The fluid level should be
between the MIN and MAX lines on the side
of the reservoir.
[SV38880( E)10/95]
5. If the power steering fluid is below the MIN
mark, add fluid in small amounts until the
level is between the MIN and MAX lines on
the side of the reservoir.
[SV38890(E )10/95]
half page art:0021528-A
Power steering reservoir
*
[SV38895( E)10/95]
If you check the power steering fluid when it is
cold, make sure that the fluid reaches the MIN
on the reservoir. The reading will only be
accurate if the fluid temperature is
approximately50ÊF to 85ÊF (10ÊC to 30ÊC).
File:14ltsve.ex
Update:Wed Apr 17 08:40:13 1996

332 % [SV40300( E )05/94]
full page art:0020392-IFuses/circuit breakers and their locations
File:14ltsve.ex
Update:Wed Apr 17 08:40:13 1996

337 [SV42175( E )07/94]
full page art:0020841-I
Power distribution box
File:14ltsve.ex
Update:Wed Apr 17 08:40:13 1996