1996 FORD AEROSTAR warning

125 [FV08800(ALL)02/91]
Dual Rear Cargo Door (If equipped)
[FV09300(ALL)05/90]
quarter page art:0020200-A
Opening the right rear door
[FV09400(ALL)06/95]
To open the left rear door, open the right rear
door and then pull up on the tee-shaped handle
located on the inside of the left rear door.
[FV09500(ALL)05/90]
To open the right side cargo door from the
inside of your vehicle, find the slot on the door
and pull the door handle inward.
[FV09600(ALL)05/90]
one third page art:0020249-A
Opening the right side cargo door from the inside
[FV09700(ALL)03/95]
When closing the dual rear cargo doors,
remember to close the left rear door first.
*
[FV09801(ALL)05/95]
RWARNING
Do not operate your vehicle with the rear
double doors open.
File:08cpfva.ex
Update:Tue Aug 29 17:41:55 1995

127
%*
[FV19250(ALL)02/95]
Windows
[FV20500(ALL)01/89]
Sliding side windows
[FV20700(ALL)08/95]
one third page art:0020207-B
Opening the sliding side window
%*
[FV22901(ALL)03/91]
Using the Power Windows (If equipped)
[FV23001(ALL)06/95]
Each front door has a power control that opens
and closes the window on that door. The
driver's door has a master control switch that
operates both front door windows. You must
place the ignition switch in the ON or ACC
position to use your power window controls.
*
[FV23401(ALL)08/95]
RWARNING
When driving your vehicle make sure that
the liftgate door and window are closed to
prevent exhaust fumes from being drawn
into the vehicle. This will also prevent
cargo from falling out.
*
[FV23501(ALL)07/95]
RWARNING
Do not let children play with the power
windows. They may seriously hurt
themselves. Make sure occupants are clear
of the window(s) before closing.
File:08cpfva.ex
Update:Tue Aug 29 17:41:55 1995

128 [FV24001(ALL)08/95]
quarter page art:0020201-CPower window controls Ð driver-side shown
%*
[FV24101(ALL)01/95]
Seats
%*
[FV24801(ALL)05/90]
Adjusting the Front Seat Manually
[FV24825(ALL)06/95]
You can move the driver seat forward or
backward. If your vehicle is equipped with the
optional reclining bucket seat, you can also tilt
the seatback up to 30 degrees rearward.
[FV25401(ALL)04/89]
The front passenger seat cannot be adjusted.
[FV25425(ALL)06/95]
one third page art:0095010-A
Seat adjustment levers
*
[FV26001(ALL)05/95]
RWARNING
Never adjust the driver's seat or seatback
when the vehicle is moving.
File:08cpfva.ex
Update:Tue Aug 29 17:41:55 1995

129
*
[FV26100(ALL)05/95]
RWARNING
Do not pile cargo higher than the
seatbacks to avoid injuring people in a
collision or sudden stop.
*
[FV26200(ALL)06/95]
RWARNING
To reduce the risk of serious injury in a
collision, always drive and ride with your
seatback upright and the lap belt snug
and low across the hips.
*
[FV26300(ALL)08/95]
RWARNING
To reduce the risk of serious injury in a
collision, children should always ride with
the seatback upright.
*
[FV26350(ALL)05/95]
To move the seat forward or backward:
[FV26450(ALL)06/95]
one third page art:0095011-AFile:08cpfva.ex
Update:Tue Aug 29 17:41:55 1995

132
*
[FV32200(ALL)12/91]
To install the rear bucket seat:
[FV32300(ALL)12/91]
1. Lift the seat assembly into the vehicle and
drop the front and rear floor hooks into the
floor wells at a point just behind the floor
attachment pins.
[FV32500(ALL)05/89]
2. Rotate the seat latch handle forward, causing
the J hook to engage over the front of the
foremost well retainer.
[FV32801(ALL)02/92]
3. For right hand seats, continue rotating the
seat latch handle until it comes to a
complete stop on the top of the tube. This
will cause the seat assembly to slide forward,
engaging the front and rear floor hooks with
the floor well retainers.
[FV32901(ALL)02/92]
For left hand seats, push the seat latch
handle downward to a full stop. This locks
the seat in position. Before you engage the
safety belt, be sure it is not twisted. Remove
any twist, then insert the tongue end of the
detachable anchor into the detachable anchor
until you hear a ªsnapº and feel the latch
engage.
*
[FV33300(ALL)05/95]
RWARNING
Check to see that the seat is latched
securely in position. Keep floor area free
of objects that would prevent proper seat
engagement. Never attempt to adjust the
seat latch while the vehicle is in motion.
File:08cpfva.ex
Update:Tue Aug 29 17:41:55 1995

134 [FV34001(ALL)08/95]
three fourths page art:0095047-ALocation of the detachable anchor warning label on safety
belt
File:08cpfva.ex
Update:Tue Aug 29 17:41:55 1995

138
*
[FV34401(ALL)06/95]
RWARNING
When reinstalling a rear seat in your
vehicle it must be placed in its original
position. Improper installation of the seat
will prevent correct use of the safety belts
and could increase the risk of injury.
Refer to the warning label on the seat
belt.
[FV34501(ALL)08/95]
2. Fold the seatback forward and latch it in the
down position (bench seat only).
[FV34601(ALL)03/91]
3. Rotate the seat latch handles (located under
the seat near the floor) upward, causing the
latch hooks to disengage from the floor
attachment.
[FV34701(ALL)03/91]
4. Lift seat at rear and rotate about the forward
attachment. When seat latches are clear of
floor attachments, release the latch handles.
[FV34801(ALL)03/91]
5. Pull the seat rearward to disengage it from
the front floor pins.
*
[FV34901(ALL)05/89]
Be careful that the latches are not damaged
when the seats are stored.
*
[FV35001(ALL)05/89]
To install the seat assembly:
*
[FV35100(ALL)10/90]
1. Clear the area of debris around the seat floor
attachments.
[FV35200(ALL)07/92]
2. With the seatback in a folded and latched
position (bench seat only), place the seat
assembly in your vehicle and engage the
front seat hooks onto the forward attachment
pin in the floor wells.
*
[FV35300(ALL)10/90]
3. Rotate the seat downward and engage the
latch into the rear floor attachment. Lifting
of the latch handles is not required for
installation.
File:08cpfva.ex
Update:Tue Aug 29 17:41:55 1995

140 [FV36001(ALL)06/95]
half page art:0095041-AInstallation and removal of the second and third passenger
bed and bench seat
*
[FV38301(ALL)05/95]
RWARNING
Never adjust the driver's seat or seatback
when the vehicle is moving.
*
[FV38350(ALL)05/95]
RWARNING
Always latch the vehicle seat to the floor,
whether the seat is occupied or empty. If
not latched, the seat may cause injury
during a sudden stop.
*
[FV38401(ALL)05/93]
RWARNING
Before using the seat, make sure that the
latch hooks are securely locked around the
floor pins.
File:08cpfva.ex
Update:Tue Aug 29 17:41:55 1995