Page 30 of 387
Q: What’s wrong with this?
L 1 I I I I 1 I I I I I
A: The belt is twisted across the body.
You can be seriously injured by a twisted belt. In
a crash, you wouldn’t have the full width of the
belt to spread impact forces. If a belt is twisted,
make
it straight so it can work properly, or ask
your dealer to
fix it.
1-23 ProCarManuals.com
Page 170 of 387

Driving Across an Incline
Sooner or later, an off-road trail will probably go across
the incline of a hill.
If this happens, you have to decide
whether
to try to drive across the incline. Here are some
things to consider:
0
0
0
A hill that can be driven straight up or down may be
too steep to drive across. When you go straight up or
down a hill, the length of the wheel base (the
distance from the front wheels to the rear wheels)
reduces the likelihood the vehicle will tumble end
over end. But when you drive across an incline, the
much more narrow track width (the distance between
the left and right wheels) may not prevent the vehicle
from tilting and rolling over. Also, driving across an
incline puts more weight on the downhill wheels.
This could cause a downhill slide or a rollover.
Surface conditions can be a problem when you drive
across
a hill. Loose gravel, muddy spots, or even wet
grass can cause your tires
to slip sideways, downhill.
If the vehicle slips sideways, it can hit something
that will trip
it (a rock, a rut, etc.) and roll over.
Hidden obstacles can make the steepness of the
incline even worse.
If you drive across a rock with
the uphill wheels, or if the downhill wheels drop into
a rut or depression, your vehicle can tilt even more. For reasons like these, you need to decide carefully
whether to
try to bve across an inche. Just because the
trail goes across the incline doesn’t mean you have to
drive it. The last vehicle to
try it might have rolled over.
Driving across an incline that’s too steep will
make your vehicle roll over.
You could be
seriously injured or killed.
If you have any doubt
about the steepness
of the incline, don’t drive
across it. Find another route instead.
Q: What if I’m driving across an incline that’s not
too steep,
but I hit some loose gravel and start to
slide downhill. What should
I do?
A: If you feel your vehicle starting to slide sideways,
turn downhill. This should help straighten out the
vehicle and prevent the side slipping. However, a
much better way to prevent this is to get out and
“walk the course”
so you know what the surface is
like before you drive it.
4-25
ProCarManuals.com
Page 283 of 387

Wheel Alignment and Tire Balance
The wheels on your vehicle were aligned and balanced
carefully at the factory
to give you the longest tire life
and best overall performance.
In most cases, you will not need to have your wheels
aligned again. However, if you notice unusual tire wear
or your vehicle pulling one way or the other, the
alignment may need
to be reset. If you notice your
vehicle vibrating when driving
on a smooth road, your
wheels may need
to be rebalanced.
Wheel Replacement
Replace any wheel that is bent, cracked, or badly rusted
or corroded.
If wheel nuts keep corning loose, the wheel,
wheel bolts
and wheel nuts should be replaced. If the
wheel leaks
air, replace it (except some aluminum
wheels, which
can sometimes be repaired). See your
Geo dealer if any of these conditions exist.
Your dealer will know the kind
of wheel you need.
Each new wheel
should have the same load-carrying
capacity, diameter, width, offset
and be mounted the
same way as
the one it replaces.
If you need to replace any of your wheels, wheel bolts
or wheel nuts, replace them only with new
GM original
equipment parts. This way, you will be sure to have the
right wheel, wheel bolts and wheel nuts for your
Geo model.
Using the wrong replacement wheels, wheel bolts
or wheel nuts on your vehicle can be dangerous. It
could affect the braking and handling of your
vehicle, make your tires lose air and make
you lose
control.
You could have a collision in which you or
others could be injured. Always use the correct
wheel, wheel bolts and wheel nuts for replacement.
NOTICE:
The wrong wheel can also cause problems with
bearing life, brake cooling, speedometer or
odometer calibration, headlamp aim, bumper
height, vehicle
ground clearance and tire or tire
chain clearance to the body and
chassis.
~~
See “Changing a Flat Tire” in the Index for more
information.
6-46
ProCarManuals.com
Page 301 of 387
Vehicle Dimensions
Wheelbase Two-Door Convertible
... 86.6 inches (2 200 mm)
Four-Door Hardtop
...... 97.6 inches (2 480 mm)
Tread
Front
................. 54.9 inches (1 395 mm)
Rear ................ 55.1 inches (1 400 mm)
Length
Two-Door Convertible
. . 143.7 inches (3 650 mm)
Four-Door Hardtop ..... 158.7 inches (4 030 mm)
Two-Door Convertible ... 64.2 inches (1 630 mm)
Four-Door Hardtop ...... 64.4 inches (1 635 mm)
Two-Door Convertible
Two-Wheel Drive
...... 64.3 inches (1 633 mm)
Width
Height Four-wheel Drive
..... 65.1 inches (1 654 mm)
Four-Door Hardtop
Two-Wheel Drive ...... 65.7 inches (1 669 mm)
Four-wheel Drive ..... 66.5 inches (1 689 mm)
Air Conditioning Refrigerants
Not all air conditioning refrigerants'are the same.
If the air conditioning system in your vehicle needs
refrigerant, be sure the proper refrigerant
is used.
If you're not sure, ask your Geo dealer.
6-64
ProCarManuals.com