
Downloaded from www.Manualslib.com manuals search engine Dual Tire  Operation Buying  New  Tires 
To 
find  out  what kind and  size of tires  you need,  look  at 
the  Certificatioflire  label. 
When 
the vehicle  is new,  or  whenever a wheel,  wheel 
bolt  or  wheel  nut  is  replaced,  check  the  wheel  nut  torque 
after 
100, 1,000 and 6,000 miles (160,  1  600 and 
10 000 km) of  driving.  For  proper  torque,  see  “Wheel 
,Nut  Torque”  in the  Index. 
The  outer  tire  on  a  dual  wheel  setup  generally  wears 
faster  than the  inner  tire.  Your tires will wear  more 
evenly  and last  longer  if  you rotate  the  tires  periodically. 
If  you’re  going  to be  doing  a  lot  of driving  on 
high-crown  roads,  you can  reduce  tire  wear by adding 
5 psi (35 kPa)  to the  tire  pressure  in the  outer  tires.  Be 
sure  to  return to the  recommended  pressures  when no 
longer  driving  under  those  conditions.  See  “Changing  a 
Flat  Tire” in  the  Index  for  more  information.  The  tires  installed  on  your 
vehicle when it was  new  had 
a Tire Performance  Criteria  Specification  (TPC Spec) 
number  on each  tire’s  sidewall.  When  you get new  tires, 
get  ones  with that  same  TPC  Spec  number. That way 
your  vehicle will  continue to have  tires  that are  designed 
to  give  proper  endurance,  handling,  speed  rating, 
traction,  ride and  other  things during  normal service on 
your  vehicle.  If your  tires  have  an  all-season  tread 
design,  the TPC  number  will be followed  by an 
“MS” 
(for  mud and  snow). 
11 you ever  replace  your  tires  with those  not having  a 
TPC  Spec  number, make  sure they are  the  same  size, 
load  range,  speed rating  and  construction  type (bias, 
bias-belted  or  radial) as your  original  tires. 
If you  operate  your  vehicle  with  a  tire  that  is 
badly  underinflated,  the  tire  can  overheat.  An 
overheated  tire  can  lose  air  suddenly  or  catch 
fire. 
You or  others  could  be  injured.  Be  sure  all 
tires  (including  the  spare)  are  properly  inflated. 
6-45   

Downloaded from www.Manualslib.com manuals search engine Wheel  Alignment  and  Tire  Balance 
The wheels  on your vehicle were aligned and balanced 
carefully at  the  factory 
to give you the longest tire life 
and best overall  performance. 
In most  cases, 
you will not need to have your wheels 
aligned again. However,  if you  notice unusual tire wear 
or your vehicle  pulling one way  or the other, the 
alignment  may need 
to be reset.  If you  notice your 
vehicle vibrating when  driving  on 
a smooth road, your 
wheels  may need to be rebalanced.  Each 
new wheel should have the  same load-carrying 
capacity, diameter, width, offset and be mounted the 
same  way as the  one  it  replaces. 
If you  need  to replace any of your  wheels, wheel bolts 
or wheel nuts, replace them  only with  new GM original 
equipment  parts. This way,  you  will be sure  to  have 
the 
right wheel,  wheel bolts and wheel nuts  for your vehicle. 
Wheel  Replacement 
Replace any wheel  that is bent,  cracked,  or  badly rusted 
or  corroded. 
If wheel nuts  keep  coming  loose, the wheel, 
wheel bolts and wheel  nuts should be replaced. If the 
wheel leaks air, replace it  (except  some  aluminum 
wheels, which  can  sometimes  be repaired). See your 
GM dealer  if any of these  conditions  exist. 
Your  dealer  will know the  kind 
of wheel you need. 
I A CAUTION: - - 
Using  the  wrong  replacement  wheels,  wheel  bolts 
or  wheel  nuts 
on your  vehicle  can  be  dangerous. 
~ It  could  affect  the  braking  and.  handling  of  your 
vehicle,  make  your  tires  lose  air and  make  you 
lose  control. 
You could  have  a  collision  in  which 
you  or others  could  be  injured.  Always  use  the 
correct  wheel,  wheel  bolts  and  wheel  nuts 
for  replacement. 
6-48   

Downloaded from www.Manualslib.com manuals search engine Underbody  Maintenance 
Chemicals used for ice  and  snow  removal  and  dust  control 
can collect  on  the  underbody. If these  are  not  removed, 
accelerated  corrosion  (rust)  can  occur 
on the  underbody 
parts  such  as  fuel  lines,  frame,  floor  pan  and  exhaust 
system  even  though  they  have  corrosion  protection. 
At  least  every  spring,  flush these  materials from the 
underbody  with plain water. Clean any  areas where  mud 
and  other  debris  can collect.  Dirt packed  in closed  areas 
of  the  frame  should  be loosened before being  flushed. 
Your  dealer  or 
an underbody  vehicle washing system 
can  do this for 
you. 
Chemical  Paint  Spotting 
Some  weather and atmospheric  conditions  can  create a 
chemical fallout.  Airborne pollutants can  fall upon  and 
attack painted  surfaces 
on your vehicle. This  damage 
can take  two forms: blotchy, ringlet-shaped 
discolorations, and small irregular  dark spots etched 
into 
the paint surface. 
Although  no defect  in 
the paint job causes  this, GM  will 
repair,  at 
no charge  to the owner, the surfaces of new 
vehicles damaged  by this  fallout  condition within 
12 months  or 12,000 miles (20 000 km) of purchase, 
whichever  occurs first. 
This  applies only 
to materials manufactured and sold  by 
General Motors. Bodies, body conversions 
or equipment 
not  made  or sold by General  Motors  are not covered. 
6-58   

Downloaded from www.Manualslib.com manuals search engine Fuel Tank  Capacity 
TYPE 
Standard  Tank 
Cutaway  Standard  Tank 
Cutaway  Optional  Tank 
All quantities  are  approximate. 
QUANTITY 
3 1 gallons (1 17.3 L) 
35 gallons  (132 L) 
55 gallons (208.2 L) 
Normal  Replacement  Parts 
Engine  “VORTEC”  4300 
VIN w 
Oil Filter  PF52 
Air Cleaner  Filter*  A9 17C 
PCV  Valve  CV789C 
Spark 
Plugs 4  1-932 
Fuel  Filter  GF48 
1 
Radiator  Cap  RC36  VORTEC” 
5000 
M 
PF1218 
A9 17C 
cv774c 
4  1-932 
GF48 
1 
RC36 
*For  severe  dusty conditions,  use 
AC Air Filter,  Part No. 1236C.  “VORTEC” 
5700 
R 
PF1218 
A9  17C 
cv774c 
4 1-932 
GF48 
1 
RC36  “VORTEC”  7400 
J 
PF1218 
A917C 
cv774c 
4  1-932 
GF48 
1 
RC36 
6-67   

Downloaded from www.Manualslib.com manuals search engine Air  Conditioning  Refrigerants 
Not  all  air  conditioning  refrigerants  are  the  same. If the  air  conditioning sys&m in your vehicle needs refrigerant, be 
sure  the  proper  refrigerant  is  used.  If  you’re not sure,  ask  your GM dealer. 
TYPE 
Refrigerant 
R- 134a 
QTY Front 
Only 
3.00 lbs. 
(1.36  kg) 
u 
QTY Front and 
Rear 
4.875 lbs. 
(2.21 kg)   

Downloaded from www.Manualslib.com manuals search engine Section 7 Maintenance Schedule 
IMPORTANT: 
KEEP  ENGINE OIL 
AT THE PROPER 
,EVEL  AND CHANGE A: 
RECOMMENDED 
This  section  covers  the maintenance  required for your 
vehicle.  Your vehicle  needs  these  services  to  retain its 
safety, dependability  and emission  control  performance. 
GP” m 
Protection 
Plan 
Have you purchased  the GM Protection  Plan?  The Plan 
supplements 
your new  vehicle  warranties.  See your 
Wurranty and  Owner  Assistance  booklet, or your 
GM dealer for details. 
Introduction 
Your Vehicle and the Environment 
Proper  vehicle  maintenance not only  helps to keep your 
vehicle 
in good  working  condition,  but also  helps the 
environment.  All recommended  maintenance procedures 
are  important.  Improper vehicle maintenance  can  even 
affect  the quality 
of the  air we breathe.  Improper  fluid 
levels  or  the wrong  tire inflation  can  increase 
the level 
of emissions  from  your  vehicle. To help protect  our 
environment,  and 
to keep  your  vehicle in good 
condition,  please  maintain 
your vehicle properly. 
7-1   

Downloaded from www.Manualslib.com manuals search engine How This Section  is  Organized 
The  remainder of this section is divided  into  five  parts: 
“Part A: Scheduled Maintenance Services” shows 
what  to have  done  and how  often.  Some  of these 
services  can be complex, 
so unless  you are technically 
qualified  and have 
the necessary  equipment,  you should 
let your dealer’s  service department  or another qualified 
service  center 
do these jobs. 
kerformmg  maintenance work on a  vehicle can 
be  dangerous. 
In trying  to do some  jobs, YOU can 
be  seriously  injured. 
Do your own maintenance 
work only  if  you have the required  know-how 
and  the  proper  tools and equipment  for  the  job. 
If  you  have any doubt, have 
a qualified 
technician  do the  work. 
If you are  skilled enough  to  do  some work on your 
vehicle,  you will probably want  to  get the service 
information 
GM publishes. See “Service  and Owner 
Publications’’  in the Index. 
“Part B: Owner Checks  and Services” tells  you what 
should  be checked whenever 
you stop  for fuel. It also 
explains what 
you can  easily do to help keep your 
vehicle 
in good condition. 
“Part C: Periodic Maintenance Inspections” explains 
important inspections that your 
GM dealer’s service 
department  or another qualified service center 
should perform. 
“Part D: Recommended Fluids  and Lubricants” lists 
some  products 
GM recommends to help  keep your 
vehicle properly  maintained.  These products,  or their 
equivalents,  should be  used  whether  you do the  work 
yourself  or have  it done. 
“Part E: Maintenance Record” provides a place  for 
you 
to record the maintenance performed on your 
vehicle. Whenever any maintenance  is performed, be 
sure  to write it down 
in this part.  This will help you 
determine  when  your  next  maintenance should  be done. 
In addition, it is a good idea to keep your maintenance 
receipts.  They may be needed 
to qualify your  vehicle  for 
warranty repairs. 
7-2   

Downloaded from www.Manualslib.com manuals search engine Part A: Scheduled  Maintenance 
Services 
Using  Your Maintenance  Schedule 
The proper  fluids and lubricants  to use  are 1iste.d in 
Part D. Make  sure  whoever services your vehicle uses 
these. 
All parts  should  be replaced  and all necessary 
repairs  done before  you or anyone  else  drives  the 
vehicle. 
We  at General  Motors want  to  help you keep  your 
vehicle 
in good working  condition. But we don’t know 
exactly  how you’ll  drive it. You  may  drive  very short 
distances  only a 
few times  a  week. Or you may drive 
long  distances 
all the time in very  hot, dusty weather. 
You may use your vehicle in making  deliveries.  Or 
you  may  drive 
it to work, to  do errands or in many 
other  ways. 
Because  of all  the  different  ways people.  use their GM 
vehicles,  maintenance needs  vary. 
You may even  need 
more  frequent  checks  and replacements  than you‘ll find 
in the schedules in this  section. So please  read this 
section  and note  how 
you drive. If you have any 
questions  on how to keep your  vehicle 
in good 
condition,  see 
your GM dealer. 
This  part  tells you 
the maintenance  services  you should 
have  done  and when 
you should  schedule  them.  If  you 
go  to your  dealer  for  your service  needs,  you’ll know 
that GM-trained  and  supported  service people will 
perform the work using  genuine GM parts. 
I nese  schedules  are  for  vehicles that: 
0 carry passengers and cargo within recommended 
limits.  You 
will find these  limits on your vehicle’s 
CertificatiodTire  label. See  “Loading  Your Vehicle” 
in the Index. 
0 are driven on reasonable  road surfaces  within  legal 
driving limits. 
0 use  the  recommended  fuel.  See  “Fuel“  in the Index. 
Selecting  the  Right  Schedule 
First you’ll need  to decide which of the two schedules  is 
right for your vehicle.  Here’s how to decide which 
schedule 
to follow: 
Gasoline  engine  vehicles and diesel  engine  vehicles 
have different maintenance requirements. 
If you  have  a 
diesel  engine,  follow 
a schedule  designated  for diesel 
engine  vehicles only. 
See  the Diesel Engine  Supplement for diesel engine 
maintenance  schedules. 
7-3