1995 RENAULT MEGANE SCENIC spare wheel

SPECIFICATIONS
Vehicle identification
• near to the emergency spare wheel (B) with a
duplicate label of the oval plate on the lower
section of the passenger door (C).
01
LOCATION OF THE VEHICLE IDENTIFICATION
PLATE
Two possible locations on the vehicle:
• in the engine compartment (A),
98485-1R
98517R
98516R
01-2

GENERAL
Description of parts (exploded view)
40
PRE4005
290 Roof
* 291 Roof rear cross member
292 Absorber support
293 Rear end panel
294 Lights mounting
295 Tailgate
* 296 Wing panel
* 297 Top of body
* 298 Rear door
* 299 Rear door panel
300 Rear end pillar lower reinforcement
* 301 Rear end cross member
302 Emergency spare wheel mounting sup-
port
303 Rear floor base
* Parts for which repaired areas must be electro zinc plated304 Base support
305 Base stiffener
* 306 Sill panel
* 307 Front pillar
* 308 Body side, front section
309 Rear floor unit
310 Rear pillar reinforcement
* 311 Rear quarter panel lining assembly
312 Inner wheel arch
313 Stretcher extension
314 Roof cross member support
* 315 Wing panel drip moulding
316 Speaker support
317 Roof stiffener
40-6

NON-SIDE OPENING ELEMENTS
Luggage compartment lid
48PLuggage compartment lid
INTRODUCTION
The part is delivered by the Parts Department
assembled with:
– the casing (polyester composite),
– the inner metal frame,
– the outer panel (Xénoy).
See Workshop Repair Manual 502 for the repair
methods for plastics.
REMOVAL

with hinges (detailed method below),

without hinges, remove only bolts (A) and (B).
Disconnect the electric supply cable in the left hand
rear wing lining.Remove:
– the luggage compartment lid interior trim (see
section 73-A),
– the emergency spare wheel protector,
– the emergency spare wheel,
– the upper extension on the left hand rear wing panel
(see section 56-A),
– the left hand lower embellisher strip on the luggage
compartment lid (see section 55-H),
– the left hand rear wing extender
(see section 55-D),
– the right hand lower embellisher strip on the luggage
compartment lid (see section 55-H),
– the electric supply cable
(see section 73-A),
– the windscreen wiper arm (see section 56-B),
– the windscreen wiper stop,
– the wiper motor,
– the tailgate closure lock
(see section 52-A),
– the lower tailgate seal,
– the luggage compartment lid handle and lock (see
section 52-A and B),
– the lower balancer,
– the tailgate surround seal,
– the rear floor lining,
– the left hand rear wing interior trim,
– the five mounting bolts (A) on the lower hinge.
PRF4803
17514R
48-3
D

NON-SIDE OPENING ELEMENTS
Luggage compartment lid
48P
48-5
SETTINGS
In all cases, always begin by adjusting the hinges on
the body at mounting points (E), (F) and (G).
IMPORTANT: it is necessary to fit the peripheral
components and position the emergency spare wheel
to check that the luggage compartment lid is flush.
17517-1R
17628-1R
17514-1R
D

EXTERIOR PROTECTION
Luggage compartment lid embellishers.
55PLuggage compartment lid embellishers.
REMOVAL
After removing the emergency spare wheel,
remove the lower mounting bolts (A).Protect the luggage compartment lid using masking
tape and then release the embellisher using the
unclipping pliers (six clips).
Disconnect the registration plate light connector.
REFITTING
To refit, proceed in the reverse order to removal.
17600R
17602S
17601S
55-16
H

EXTERIOR ACCESSORIES
Rear windscreen wiper arm
56S
56-3
REMOVAL
After removing the emergency spare wheel,
remove the nut cover, unscrew the mounting nut on
the arm by one turn, insert the tool.
1 Extractor bolt (wedged on the loosened nut)
2 Short bend clip
3 Long bend clip
After unlocking the arm, remove the extractor then
complete the operation manually.
REFITTING
Tightening torque for the nut 11 ± 1 N.m
16834R
B

NON-SIDE OPENING ELEMENTS TRIM
Luggage compartment lid trim
73
173 NON-SIDE OPENING ELEMENTS TRIM
Luggage compartment lid trim
REMOVING THE CENTRAL TRIM
Remove the protective sheath and disconnect the
connector (A).Loosen the wing nut (B).
Remove:
– the emergency spare wheel protector,
– the mounting bolts (C).
Remove the trim using unclipping pliers (nine clips).
16782R
16784R
16783R
73-1
A