1995 OLDSMOBILE SILHOUETTE Owners Manual

Cleaning Leather
Use a soft cloth with lukewarm water and a mild soap or
saddle soap.
0
0 For stubborn stains, use a mild solution of 10%
isopropyl alcohol (rubbing alcohol) and 90% water.
Never use oils, varnishes, solvent-based or abrasive
cleaners, furniture polish
or shoe polish on leather.
Soiled leather should be cleaned immediately.
If dirt
is allowed to work into the finish, it can harm the
leather.
Cleaning the Top of the Instrument Panel
Use only mild soap and water to clean the top surfaces
of the instrument panel. Sprays containing silicones or
waxes may cause annoying reflections in the windshield
and even make it difficult
to see through the windshield
under certain conditions.
Vacuum the carpeted area as needed, and clean as you
would any other carpet.
Cleaning the Built-In Child
Restraint Pad
The built-in child restraint pad is attached to the seat
frame with fastener strips. You can remove the pad and
hand wash it with mild soap and water.
Care of Safety Belts
Keep belts clean and dry.
ProCarManuals.com

Glass
Glass should be cleaned often. GM Glass Cleaner
(GM Part No. 1050427) or a liquid household glass
cleaner will remove normal tobacco smoke and
dust films.
Don’t use abrasive cleaners on glass, because they may
cause scratches. Avoid placing decals on the inside rear
window, since they may have to be scraped off later. If
abrasive cleaners are used on the inside of the rear
window, an electric defogger element may be damaged.
Any temporary license should not be attached across the
defogger grid.
Cleaning the Outside of the
Windshield, Backglass and Wiper
Blades
If the windshield is not clear after using the windshield
washer, or if the wiper blade chatters when running, wax
or other material may be on the blade or windshield. Clean the outside
of the windshield with
GM
Windshield Cleaner, Bon-Ami Powder@ (GM Part
No. 105001 1). The windshield is clean if beads do not
form when you rinse it with water.
Clean the blade by wiping vigorously with a cloth
soaked in full strength windshield washer solvent. Then
rinse the blade with water.
Wiper blades should be checked on a regular basis and
replaced when worn.
Weatherstrips
Silicone grease on weatherstrips will make them last
longer, seal better, and not stick or squeak. Apply
silicone grease with a clean cloth at least every six
months. During very cold, damp weather more frequent
application may be required. (See “Recommended
Fluids and Lubricants” in the Index.)
6-46
ProCarManuals.com

Cleaning the Outside of Your
Oldsmobile
The paint finish on your vehicle provides beauty, depth
of color, gloss retention and durability.
Washing Your Vehicle
The best way to preserve your vehicle’s finish is to keep
it clean by washing it often with lukewarm or cold water.
Don’t wash your vehicle
in the direct rays of the sun.
Don’t use strong soaps or chemical detergents. Use
liquid hand, dish or car washing (mild detergent) soaps.
Don’t use cleaning agents that are petroleum based, or
that contain acid or abrasives.
All cleaning agents
should be flushed promptly and not allowed to dry on
the surface, or they could stain. Dry the finish with a
soft, clean chamois or a
100% cotton towel to avoid
surface scratches and water spotting.
Before entering an automatic car wash, if your vehicle is
equipped with the optional power sliding
door, be sure
to have the enable switch
in the OFF position.
High pressure car washes may cause water to enter your
vehicle.
Finish Care
Occasional waxing or mild polishing of your
Oldsmobile by hand may be necessary to remove
residue from the paint finish.
You can get GM approved
cleaning products from your retailer. (See “Appearance
Care and Materials”
in the Index.)
Your Oldsmobile has a “basecoatklearcoat” paint finish. The
clearcoat gives more depth and gloss to the colored basecoat.
Always use waxes and polishes that are non-abrasive and
made for a basecoatklearcoat paint finish.
NOTICE:
Machine compounding or aggressive polishing on
a basecoatklearcoat paint finish may dull the
finish or leave swirl marks.
Foreign materials such as calcium chloride and other
salts, ice melting agents, road oil and tar, tree
sap, bird
droppings, chemicals from industrial chimneys, etc. can
damage your vehicle’s finish
if they remain on painted
surfaces. Wdsh the
vehicle as soon as possible. If
necessary, use non-abrasive cleaners that are marked
safe for painted surfaces to remove foreign matter.
6-47
ProCarManuals.com

Exterior painted surfaces are subject to aging, weather
and chemical fallout, that can take their toll over
a
period of years. You can help to keep the paint finish
looking new by keeping your Oldsmobile garaged or
covered whenever possible.
Aluminum Wheels
Tires
To clean your tires, use a stiff brush with a tire cleaner.
When applying
a tire dressing always take care to wipe
off any overspray or splash from painted surfaces.
Petroleum-based products may damage the paint finish.
Your aluminum wheels have
a protective coating similar Finish Damage
to the painted surface of your vehicle. Don’t use strong Any stone chips, fractures or deep scratches in the finish
soaps, chemicals, chrome polish, abrasive cleaners or should be repaired right away.
abrasive cleaning brushes on them because yo~l could
damage this coating. After rinsing thoroughly,
a wax
may be applied. Minor
chips and scratches can be repaired with touch-up
materials available from your retailer or other service
outlets. Larger areas of finish damage can be corrected
in your retailer’s body and paint shop.
NOTICE: Underbody Maintenance
Don’t use an automatic car wash that has hard
silicon carbide cleaning brushes. These brushes
can take the protective coating
off your
underbody parts such as fuel lines, frame, floor pan, and aluminum wheels.
removed, accelerated corrosion (rust) can occur on the
Chemicals used
for ice and snow removal and dust
control can collect on the underbody. If these are not
exhaust system even though they have corrosion
protection.
6-48
ProCarManuals.com

At least every spring, flush these materials from the
underbody with plain water. Clean any areas where mud
and other debris can collect. Dirt packed
in closed areas
of the frame should be loosened before being flushed.
Your retailer or an underbody car washing system can
do this for
you.
Collision Repair
Your vehicle was built with composite SMC (Sheet
Molded Compound) fiberglass body panels and molded
RIM (Reaction Injection Molded) front fenders and
bumper covers. These panels require different collision
repair procedures than metal-paneled vehicles. See your
Oldsrnobile retailer for information on collision repair.
Chemical Paint Spotting
Some weather and atmospheric conditions can create a
chemical fallout. Airborne pollutants can fall upon and
attack painted surfaces on your vehicle. This damage
can take two forms: blotchy, ringlet-shaped
discolorations, and small irregular dark spots etched into
the paint surface.
Although no defect
in the paint job causes this,
Oldsmobile will repair, at no charge to the owner, the
surfaces
of new vehicles damaged by this fallout
condition within
I2 months or 12,000 miles (20 000 km)
of purchase, whichever comes first.
ProCarManuals.com

I i
Appearance Care and Maintenance Materials
Weatherstrips, Stops squeaks
6-50
ProCarManuals.com

Vehicle Identification Number (VIN)
This is the legal identifier for your Oldsmobile. It appears
on a plate in the front corner of the instrument panel, on
the driver’s side. You can see it if you look through
the
windshield from outside your vehicle. The VIN also
appears
on the Vehicle Certification and Service Parts
labels and the certificates of title and registration.
Engine Identification
The eighth character in your VIN is the engine code.
This code will help you identify your engine,
specifications, and replacement parts.
Service Parts Identification Label
You’ll find this label inside the glove box door. It’s very
helpful if you ever need to order parts. On this label is:
your VIN,
the model designation,
0 paint information, and
0 a list of all production options and special equipment.
Be sure that this label is not removed from the vehicle.
Add-on Electrical Equipment
NOTICE:
Don’t add anything electrical to your Oldsmobile
unless you check with your retailer first. Some
electrical equipment can damage your vehicle and
the damage wouldn’t be covered
by your warranty.
Some add-on electrical equipment can keep other
components from working
as they should.
Your vehicle has an air bag system. Before attempting to
add anything electrical to your Oldsmobile, see “Servicing Your
Air Bag-Equipped Oldsmobile” in the Index.
6-51
ProCarManuals.com

Fuses and Circuit Breakers
L
The wiring circuits in your vehicle are protected from
short circuits by a combination of fuses and circuit
breakers in the wiring itself. This greatly reduces the
chance of damages caused by electrical problems.
To identify and check fuses, refer to the fuse panel,
which is behind the glove box door, and the fuse usage
chart later in this section.
A fuse puller is clipped inside the fuse panel door. Place
the wide end
of the fuse puller over the plastic end of
the fuse. Squeeze the ends over the fuse and pull it out.
Look at the silver-colored band inside the fuse. If the
band
is broken or melted, replace the fuse. Be sure you
replace a bad fuse with a new one of the correct size.
6-52
ProCarManuals.com