1995 OLDSMOBILE AURORA lock

4. Press the HR button to make the first one or two
digits agree with your code.
5. After you have confirmed that the code in the display
matches the secret code
you have written down,
press AM/FM. “SEC” will appear
in the display,
indicating that the radio is now operable and secure.
If the code entered to unlock Theftlock@ is incorrect, the
radio will remain locked. After eight unsuccessful
attempts to unlock
the radio, the display will show
“InOP” (inoperative). At this point you will need
to
keep the ignition on for one hour before you may
attempt to enter another code. After three unsuccessful
attempts to unlock the radio,
the display will show
“InOP” (inoperative) again.
If you forget your code or cannot unlock the radio,
contact your retailer for assistance.
To Disable Theftlock@
Enter your secret code as follows; pause no more than
15 seconds between steps:
1.
2.
3.
4.
5.
4.
7.
Turn the ignition to the ACCESSORY or RUN
position.
Press the PWR/VOL button to
turn the radio off.
Press the
1 and 4 buttons together. Hold them down
until “SEC” shows in the display.
Press the MN button and
“000” will appear on the
display.
Press MN again to make the last two digits agree
with your code.
Press the
HR button to make the first one or two
digits agree with your code.
After you have confirmed that the code in the display
matches the secret code you have written down,
press AMEM. The display will show
“---”
indicating that the radio is no longer secured.
If the code entered is incorrect, “SEC” will appear in the
display. The radio
will remain secured until the correct
code is entered.
3-27
ProCarManuals.com

Avoid needless heavy braking. Some people drive in
spurts -- heavy acceleration followed by heavy braking
-- rather than keeping pace with traffic. This is a
mistake. Your brakes may not have time to cool between
hard stops. Your brakes will wear
out much fdster if you
do a lot of heavy braking. If you keep pace with the
traffic and allow realistic following distances, you will
eliminate a lot
of unnecessary braking. That means
better braking and longer brake life.
If your engine ever stops while you’re driving, brake
normally but don’t pump your brakes.
If you do, the
pedal may get harder to push down. If your engine
stops, you will still have some power brake assist.
But
you will use it when you brake. Once the power assist is
used up,
it may take longer to stop and the brake pedal
will be harder to push.
Anti-Lock Brakes (ABS)
Your Aurora has an advanced electronic braking system
that
will help prevent a braking skid.
ANT’- (I)
LOCK
This light on the
instrument panel
will
come on briefly when
you start your vehicle.
When you start your vehicle and begin to drive away,
you may hear a momentary motor or clicking noise. And
you may even notice that your brake pedal moves
a little
while this is going on. This is the ABS system testing
itself.
If there’s a problem with the anti-lock brake
system, the anti-lock brake system warning light will
stay
on.
See “Anti-Lock Brake System Warning Light“ in the
Index.
4-6
ProCarManuals.com

I
I
Here’s how anti-lock works. Let’s say the road is wet.
You’re driving safely. Suddenly an animal jumps out in
front
of you.
You slam on the brakes. Here’s what happens with ABS.
A computer senses that wheels are slowing down. If one
of the wheels is about to stop rolling, the computer will
separately work the brakes at each front wheel and at the
rear wheels. The
anti-lock system can change the brake pressure
faster than any driver could. The computer
is
programmed to make the most of available tire and road
conditions.
You can steer around the obstacle while braking hard.
As you brake, your computer keeps receiving updates on
wheel speed and controls braking pressure accordingly.
4-7
ProCarManuals.com

Remember: Anti-lock doesn't change the time you need
to get your
foot up to the brake pedal. If you get too
close to the vehicle in front of you, you won't have time
to apply your brakes
if that vehicle suddenly slows 01-
stops. Always leave enough 1-0om up ahead to stop. even
though you have anti-lock brakes.
To Use Anti-Lock
Don't pump the brakes. Just hold the brake pedal down
and let anti-lock work for you. You may hear
a motor or
clicking noise during a hard stop. but this is normal.
Traction Control System
Your vehicle has a traction control system that limits
wheel spin. This is especially useful
in slippery road
conditions. The system operates only
if it senses that one
or both of the front wheels are spinning or beginning to
lose traction. When this happens, the system works the
front brakes and reduces engine power (by shutting off
fuel injectors and managing engine spark) to
limit wheel
spin.
The TRACTION ACTIVE light will come on when
your traction control system
is limiting wheel spin. See
"Traction Control System Active Light"
in the Index.
You may feel the system working, or you may notice
some noise, but this is normal.
If yo~~r vehicle is in
cruise control when the traction control system begins to
limit wheel spin, the cruise control will automatically
disengage. When road conditions allow you to safely
use
it again, you may re-engage the cruise control. (See
"Cruise Control"
in the Index.)
TRACTION
OFF
When the system is on, the TRACTION OFF warning
light
will come on to let you know if there's a problem
with your traction control system. See "Traction Control
System Warning Light"
in the Index. When this warning
light is on, the system
will not limit wheel spin. Adjust
your driving accordingly.
4-8
ProCarManuals.com

The traction control system automatically comes on
whenever
you start your vehicle. To limit wheel spin,
especially
in slippery road conditions, you should
always leave the system on. But you can turn the
traction control system off
if you ever need to. (You
should
turn the system off if your vehicle ever gets stuck
in sand, mud, ice or snow. See “Rocking Your Vehicle”
in the Index.)
I ‘ -I
To turn the system off,
press the TRACTION
CONTROL button on
the center console. The
TRACTION
OFF warning light will come on and
stay on.
If the system is limiting wheel spin when you
press the button,
the system won’t turn off right away. It
will wait until there’s no longer a current need to limit
wheel spin.
You can
turn the system back on at any time by pressing
the button again. The TRACTION
OFF warning light
should go
off.
Braking in Emergencies
Use your anti-lock braking system when you need to.
With anti-lock, you can steer and brake at the same
time.
In many emergencies, steering can help you more
than even the very best braking.
4-9
ProCarManuals.com

Steering in Emergencies
There are times when steering can be more effective
than braking. For example, you come over
a hill and
find a truck stopped in your lane, or a car suddenly pulls
out from nowhere, or a child darts out from between
parked cars and stops right
in front of you. You can
avoid these problems by braking
-- if you can stop in
time. But sometimes you can't; there isn't room. That's
the time for evasive action
-- steering around the
problem.
Your Aurora can perform very well
in emergencies like
these. First apply your brakes.
It is better to remove as
much speed
as you can from a possible collision. Then
steer around the problem,
to the left or right depending
on the space available.
An emergency like this requires close attention and a
quick decision.
If you are holding the steering wheel at
the recommended
9 and 3 o'clock positions, you can
turn it a full I80 degrees very quickly without removing
either hand.
But you have to act fast, steer quickly, and
just
as quickly straighten the wheel once you have
avoided the object.
The fact that s11ch emergency situations are always
possible
is a good reason to practice defensive driving at
all times and wear safety belts properly.
Off-Road Recovery
You may find sometime that your right wheels have
dropped off the edge
of a road onto the shoulder while
you're driving.
If the level of the shoulder is only slightly below the
pavement, recovery should be fairly easy. Ease off the
accelerator and then,
if there is nothing in the way, steer
so that your vehicle straddles the edge of the pavement.
You can
turn the steering wheel up to 1/4 turn until the
right front tire contacts the pavement edge. Then turn
your steering wheel
to go straight down the roadway.
4-11
ProCarManuals.com

If your traction control system is off, then an
acceleration skid is also best handled by easing your
foot
off the accelerator pedal.
If your vehicle starts to slide, ease your foot
off the
accelerator pedal and quickly steer the way you want the
vehicle to
go. If yo11 start steering quickly enough, your
vehicle may straighten out. Always be ready for a
second skid
if it occurs.
Of course, traction is reduced when water, snow, ice,
gravel, or other material is on the road. For safety, you’ll
want to
slow down and adjust your driving to these
conditions.
It is important to slow down on slippery
surfices because stopping distance
will be longer and
vehicle control more limited.
While driving
on a surface with reduced traction, try
your best to avoid sudden steering, acceleration, or
braking (including engine braking by shifting
to a lower
gear). Any sudden changes could cause the tires
to slide.
You may not realize the surface is slippery
until your
vehicle is skidding. Learn to recognize warning clues
--
such as enough water, ice or packed snow on the road to
make a “mirrored surface”
-- and slow down when you
have any doubt.
Remember:
Any anti-lock brake system (ABS) helps
avoid only the braking skid.
Driving at Night
m
Night driving is more dangerous than day driving. One
reason is that some drivers are likely to be impaired
--
by alcohol or drugs, with night vision problems, or by
fatigue.
4-14
ProCarManuals.com

What’s the worst time for this? “Wet ice.” Very cold
snow or ice can be slick and hard
to drive on. But wet
ice can be even more trouble because
it may offer the
least traction of all. You can get “wet ice” when it’s
about freezing
(32°F; OOC) and freezing rain begins to
fall. Try to avoid driving on wet ice
until salt and sand
crews can get there.
Whatever the condition
-- smooth ice, packed, blowing
or loose snow
-- drive with caution.
Keep your traction control system on.
It improves your
ability to accelerate when driving on
a slippery road.
Even though your vehicle has a traction control system,
you‘ll want
to slow down and adjust your driving to the
road conditions. See “Traction Control System”
in the
Index. Your
anti-lock brakes improve your ability to make
a
hard stop on a slippery road. Even though you have the
anti-lock braking system, you’ll want to begin stopping
sooner than you would
on dry pavement. See
“Anti-Lock”
in the Index.
Allow greater following distance on any slippery
road.
Watch for slippery spots. The road might be fine
until you hit a spot that’s covered with ice. On an
otherwise clear road, ice patches
may appear in
shaded areas where the sun can‘t reach: around
clumps
of trees, behind buildings, or under bridges.
Sometimes the surface
of a curve or an overpass may
remain icy when
the surrounding roads are clear. If
you see
a patch of ice ahead of you, brake before you
are on
it. Try not to brake while you’re actually on
the ice, and avoid sudden steering maneuvers.
4-25
ProCarManuals.com