1995 OLDSMOBILE AURORA change time

Air Conditioning
The air conditioner cools, dehumidifies, and filters the
air for the inside of the vehicle.
The air conditioner compressor
is enabled in all modes.
However, when the outside temperature is below
42" F
(6"C), the compressor will not operate. When the air
conditioner is on, you may sometimes notice slight
changes
in your vehicle's engine speed and power. This
is normal, because the system is designed to cycle the
compressor
on and off to keep the desired cooling and
help fuel economy.
The air conditioning is always enabled
in defog or
defrost. In any other mode,
you can select or shut off the
air conditioning as desired by pressing
A/C ON. The
indicator light will glow while the air conditioning is
enabled. For maximum
continued cooling, press the blue
temperature button repeatedly until the display reads
60" F (16°C) and press the A/C ON button. Using the
upper vents will cause
you to feel cooler more quickly.
The direction of
the cool air can be controlled by
adjusting, or turning off, the outlets in the dash. Aiming
them over your shoulder will benefit both front and rear
passengers. Back seat passengers can also redirect air
flow using the vents at the rear
of the center console.
On hot days, open the windows long enough to let the
hot inside air out. This reduces the time the air
conditioner's compressor will have to run, which should
help fuel economy.
3-5
ProCarManuals.com

Audio Systems
The following pages describe the audio systems available
for your Aurora, and how to get the best performance
from them. Please read about the system in your vehicle.
AM/FM Stereo Radio with Automatic Tone
Control, Cassette Tape and Compact Disc
Players
Setting the Clock
To set the clock, press and hold the HR or MN button
until
it begins to change. Let up as it gets close to the
correct time. There will be an initial two-second delay
before the clock goes into the time-set mode. The
“A”
or “P” in the display designates AM or PM in clock
adjust mode. The
“A” or “P” replaces the channel
momentarily. The clock may be set with the ignition off.
The digital display indicates information on time or radio
station frequency, the
AM or FM radio band, whether the
station
is in stereo, and other audio system functions.
PWRNOL (PowerNolume): With the ignition on,
push this knob
to turn the system on or off. Turn it
clockwise to increase the volume. Turn it
counterclockwise to decrease the volume.
3-9
ProCarManuals.com

AMEM: Press this button to change between the AM,
FM1 and FM2 bands. The display will show which band
you are on. If you press this button while a tape or CD is
playing, the tape or CD will stop and the radio will
return to the AM or FM band that you were on.
TUNE: Press lightly on this knob to release it from its
recessed position. Turn
it to tune in radio stations. You
may push the knob back in to return it to its recessed
position when not
in use.
To Preset Radio Stations
The five pushbuttons labeled 1-5 can be used to preset up
to 15 radio stations (five AM, five FM 1 and five FM2).
1. Tune
in the station you want to store.
2. Press TONE to select the setting that you prefer.
3. Press and hold one of the five pushbuttons until the
display shows a channel number. The radio will mute
until the channel number is displayed. Whenever you
press that button again, the preset station and tone setting will return. Always check whether you’re in
AM, FMl or FM2.
SEEK A/V: When you press SEEK while playing the
radio,
the radio will search for the next higher or lower
station and stop. The radio will be muted while seeking.
SCAN: When you press SCAN while playing the radio,
the radio will
go through each station, pausing for a few
seconds at each station. Press SCAN again to stop on
a
station. The radio will be muted while scanning and
“SCAN”
will appear on the display.
When you press SCAN and hold
it for about two seconds
until the display shows “PSCAN’ (Preset Scan), the radio
will scan only stations that you’ve preset with your radio
pushbuttons. Press SCAN again to stop
on a station.
RCL (Recall): When the ignition is off, press RCL to
display the time. When the radio is on, press RCL to
switch the display between the radio station and the
time. After
five seconds the display will return to its
normal display.
The radio can be set
so that either the time or radio
station is normally displayed when the radio is playing.
To do this, press RCL to display the time or radio
stations as desired, then hold
RCL down until the
display flashes.
3-10
ProCarManuals.com

This button scrolls through three functions when a CD is
playing:
0 Press to see which track is playing.
0 Press again while the track is displayed (within about
five seconds), and “EL
TM” (Elapsed Time) will
appear in the display together with how much time
has elapsed since
the track started playing.
0 Press again to view the time.
You can select which function is normally displayed
when a
CD is playing. To do this, press RCL until the
display shows the desired function, then hold RCL down
until
the display flashes.
TONE: This button controls the Automatic Tone
Control (ATC) feature which lets
you select an
equalization for the type of music or voice being heard.
For example, JAZZ emphasizes bass and treble while
ROCK emphasizes bass. Press TONE to step through
the
six settings: JAZZ, VOCAL, POP, ROCK,
CLASSIC, and MANUAL. Each setting will appear on
the display. In MANUAL you can adjust tone with the
TREB and BASS controls. Any time TREB or BASS is
turned, TONE will automatically go to the MANUAL
setting. Separate
tone settings can be stored with each
preset station. You can also select separate tone settings
for your cassette tape and compact disc.
BASS: Press this button lightly to release it from its
recessed position. Turn it
to adjust bass response. As
you turn the knob, you will feel the center position. Push
the knob back in to return it to its recessed position.
Turning BASS will change the radio’s Automatic Tone
Control feature to MANUAL.
TREB (Treble): Press this button lightly to release it
from its recessed position, then pull
it out to its fully
extended position. Turn it to adjust treble response. As
you turn the knob you will feel the center position. Push
the knob back in to return
it to its recessed position.
Turning TREB will change the radio’s Automatic Tone
Control feature to MANUAL.
BAL (Balance): Press this button lightly to release it
from its recessed position. Turn
it to adjust the right and
left speaker balance. As you turn
the knob you will feel
the center position. Push the knob back in to return it to
its recessed position.
FADE: Press this button lightly to release it from its
recessed position, then pull
it out to its fully extended
position. Turn it to
the right to increase front speaker
volume. Turn
it to the left to increase rear speaker
volume. As you turn the knob
you will feel the center
position. Push the knob back
in to return it to its
recessed position.
3-11
ProCarManuals.com

TAPEKD: If you have a CD inserted and the radio is
playing, press TAPE/CD to play your CD.
To return to
the radio while the CD is playing, press
AM/FM. You
can also press TAPE/CD to switch between a tape and a
compact disc
if both are inserted. While the tape or CD
is not being played, it will remain safely inside the radio
for future listening.
RDM (Random): Press to play the CD tracks in random
order.
“RDM” will appear on the display. Press again to
play the tracks
in disc order.
Compression: While playing a CD, press NR to turn on
compression. “COMP” will appear on the display.
Compression makes loud and soft passages more equal
in volume. Press NR again to turn off compression.
AM/F” Stereo Radio with Cassette Tape
Player (Bose’Acoustimass)
EJECT Press to eject the CD. The radio will then play.
If both a tape and CD are inserted, the last one played
will eject.
This audio system may have an optional trunk-mounted
CD changer. If so, also see “Trunk-Mounted CD
Changer” later
in this section.
The digital display indicates information on time
or radio
station frequency, the AM or FM radio band, whether the
station
is in stereo, and other audio system functions.
3-14
-
ProCarManuals.com

PWWVOL (PowerNolume): With the ignition on,
push this knob to turn the system on or off. Turn it
clockwise to increase the volume. Turn it
counterclockwise to decrease the volume.
AMD": Press this button to change between the AM,
FMI and FM2 bands. The display
will show which band
you are on.
If you press this button while a tape is
playing, the tape
will stop and the radio will return to
the AM or FM band that you were on.
TUNE: Press lightly on this knob to release it from its
recessed position. Turn
it to tune in radio stations. You
may push the knob back
in to return it to its recessed
position when not
in use.
To Preset Radio Stations
The five pushbuttons labeled 1-5 can be used to preset LIP
to 15 radio stations (five AM, five FM 1 and five FM2).
1. Tune in the station you want to store.
2. Press and hold one of the five pushbuttons
until the
display shows
a channel number. The radio will mute
until the cl1annel number is displayed. Whenever you
press that button again, the preset station
will return.
Always check whether you're
in AM, FMl or FM2.
SEEK A/V: When you press SEEK while playing the
radio, the radio
will search for the next higher or lower
station and stop. The radio will be muted while seeking.
SCAN: When you press SCAN while playing the radio,
the radio
will go through each station, pausing for a few
seconds at each station. Press SCAN again to stop
on a
station. The radio
will be muted while scanning and
"SCAN"
will appear on the display.
When you press SCAN and hold
it for about two
seconds
until the display shows "PSCAN" (Preset Scan),
the radio
will scan only stations that you've preset with
your radio pushbuttons. Press SCAN again to stop on a
station.
RECALL: When the ignition is off, press RECALL to
display the time. When the radio
is on, press RECALL
to switch the display between the radio station and the
time. After five seconds the display
will return to its
normal display.
The radio can be set
so that either the time or radio
station is normally displayed when the radio is playing.
To
do this. press RECALL to display the time or radio
station
as desired, then hold RECALL down untii the
display flashes.
ProCarManuals.com

AR/VFM Stereo Radio with Automatic Tone
Control and Cassette Tape Player PWRNOL (PowerNolume): With the ignition on,
push this knob to turn the system on
or off. Turn it
clockwise to increase the volume. Turn
it
counterclockwise to decrease the volume.
AMEM: Press this button to change between the AM,
FMl and FM2 bands. The display will show which band
you are on.
If you press this button while a tape is
playing, the tape will stop and
the radio will return to
the
AM or FM band that you were on.
TUNE: Press lightly on this knob to release it from its
recessed position. Turn it to tune in radio stations. You
may push
the knob back in to return it to its recessed
position when
not in use.
To Preset Radio Stations
The five pushbuttons labeled 1-5 can be used to preset up
to
15 radio stations (five AM, five FM1 and five FM2).
1. Tune in the station you want to store.
2. Press TONE to select the setting that you prefer.
This audio
system may have an optional trunk-mounted
CD changer.
If so, also see “Trunk-Mounted CD
Changer” later in this section.
The digital display indicates information on time or radio
3. Press and hold one of the five pushbuttons until the
station frequency, the AM or FM radio band, whether the
display shows a channel number. The radio will mute
station is
in stereo, and other audio system functions. until the channel number is displayed. Whenever you
press that button again, the preset station and tone
setting will return. Always check whether you’re
in
AM, FMl or FM2.
3-18
ProCarManuals.com

SEEK A/V: When you press SEEK while playing the
radio, the radio will search for the
next higher or lower
station and stop. The radio will be muted while seeking.
SCAN: When you press SCAN while playing the radio,
the radio
will go through each station, pausing for a few
seconds at each station. Press SCAN again to stop on a
station. The radio will be muted while scanning and
“SCAN” will appear on the display.
When you press SCAN and hold
it for about two
seconds
until the display shows “PSCAN” (Preset Scan),
the radio will scan only stations that you’ve preset with
your radio pushbuttons. Press SCAN again to stop on a
station.
RCL (Recall): When the ignition is off, press RCL to
display the time. When the radio is on, press RCL to
switch the display between the radio station and the
time. After
five seconds the display will return to its
normal display.
The radio can be set
so that either the time or radio
station is normally displayed when the radio is playing.
To
do this, press RCL to display the time or radio station
as desired. Then hold RCL down
until the display
flashes.
TONE: This button controls the Automatic Tone
Control (ATC) feature which lets you select an
equalization for the type of music
or voice being heard.
For example, JAZZ emphasizes bass and treble while
ROCK emphasizes bass. Press TONE to step through
the six settings: JAZZ, VOCAL, POP, ROCK,
CLASSIC, and MANUAL. Each setting will appear on
the display. In MANUAL you can adjust tone with the
TREB and BASS controls. Any time TREB
or BASS is
turned, TONE will automatically go to the MANUAL
setting. Separate tone settings can be stored
with each
preset station. You can also select a separate tone setting
for
your cassette tape.
BASS: Press this button lightly to release it from its
recessed position. Turn
it to adjust bass response. As
you turn the knob you
will feel the center position. Push
the knob back
in to return it to its recessed position.
Turning BASS will change the radio’s Automatic Tone
Control feature to MANUAL.
TREB (Treble): Press this button lightly to release it
from its recessed position, then pull
it out to its fully
extended position. Turn it to adjust treble response. As
you
turn the knob you will feel the center position. Push
the knob back in to return
it to its recessed position.
Turning TREB will change the radio‘s Automatic Tone
Control feature to MANUAL.
3-19
ProCarManuals.com